UniMAT PLC在塑料挤出机控制系统中的应用

针对塑料挤出机控制系统成本高、速度低、精度低的问题,提出采用UniMATPLC控制方式,实践证明效果良好。     

S7-200在KYS-1500/50型打捆机中的应用

采用西门子S7-200系列PLC设计电气控制系统,成功实现打捆机系统的自动控制,满足了生产的工艺要求。     

西门子PLC在合金钢棒材连轧机上的应用

介绍基于西门子S7-400PLC的控制系统,通过Ethernet、Profibus-DP、MPI网完成系统数据的采集、交换与监控,满足合金钢棒材轧制线高动态品质、高调速精度的要求。     

基于Profibus-DP的西门子S7—300 PLC与ABB 800XA数据通信的实现

本文介绍基于Profibus—DP通信协议的西门子S7—300PLC与ABB 800XA系统之间的数据通信。详细描述了分别通过S7—300 PLC CPU的DP接口和CP342—5通信模块与ABB 800XA系统通信两种不同条件下的有关通信配置及实现数据通信的过程。     

μC／OS—Ⅲ在Cortex—M3处理器上的移植

为了将μC／OS-Ⅲ移植到Cortex—M3处理器上,选用RealView MDK作为软件开发平台,针对Cortex—M3处理器特性编写了移植所需的C语言和汇编语言源代码,并验证了移植的正确性。移植后的μC／OS-Ⅲ能够稳定运行于Cortex～M3处理器上。该移植对大部分Cortex—M3处理器具有通用性,对其他架构处理器的μC／OS-Ⅲ移植具有参考作用。     

基于IEC61131-3标准的PLC编辑模块设计与实现

基于IEC61131-3标准设计一个可编程逻辑控制器（PLC）编辑模块,并给出了主要数据结构和算法的设计。通过测试表明用户界面友好,操作简单,对后续开发具指导意义。     

FTIR investigation of ethylene coordination and polymerization on reduced Cr/SiO2 catalyst

FTIR spectroscopy was applied to study the initial steps of ethylene polymerization on reduced chromia-silica (0.5 wt% Cr/SiO₂). To decrease the speed of the reaction small doses of gas were introduced to the catalyst in each run and C₂D₄ was used to confirm band assignments. At the initial steps of the reaction only ethylene molecules coordinated to probably Cr _A ²⁺ cations were observed. The concentration of such complexes was estimated to be about 50% of the total amount of Cr atoms in the sample. The FTIR spectrum of the polymer formed at the initial doses of C₂H₄ (when [C₂H₄] [Cr]) was found to be slightly different from that formed after excess ethylene was introduced onto the catalyst ([C₂H₄] > [Cr]).     

Intraspecific variation and interspecific differences in sex pheromones of sibling species inCtenopseustis obliquana complex

The specific status ofCtenopseustis obliquana pheromone-types I, II, and III has been more fully examined. Females of types I and III produce a mixture of (Z)-8- and (Z)-5-tetradecenyl acetates (Z8-14:Ac, Z5-14: Ac). The previously reported different ratios of these two components in females of the two types (type I=8020, III=9010) have been reinvestigated. The median ratios of each type differed significantly, although there was some overlap in the ranges of these ratios. A field cage trial showed that males of type III are attracted to females of type I, so the observed differences may be ascribed to intraspecific variation. In contrast to females of types I or III, females of type II produce Z5-14Ac but no Z8-14Ac. The electroantennogram (EAG) profile of antennae of type II males shows a maximum response to Z5-14Ac, while the EAG profiles of types I and III show a strong response to Z8-14Ac. In wind tunnel tests using mixtures of these two compounds, type II males prefer blends consisting of all or mostly Z5-14: Ac, while type I males showed a preference to a mix of 70% Z8-14Ac plus 30% Z5-14Ac. We found that type I males are attracted to type I females when offered a choice between type I and type II females in a field cage test and that type II males similarly prefer type II females. Males of types I and II have specialist cells for Z8-14Ac and Z5-14Ac but differ with respect to relative densities of these cells and to further cell types responsive to other alkenyl acetates. Type IIC. obliquana is considered therefore a sibling species of types I and III. In addition, the amount of Z5-14Ac produced by type II females varied geographically. Females from the North Island produced significantly less (median=1.2 ng) Z5-14Ac than females from the South Island (median=2.2 ng). Type II populations in the North Island morphologically resembled sympatric type I, rather than type II from the South Island and are designated as type II (North Island). Type II (North Island) populations have so far been found only at Rukuhia (near Hamilton) and from Kerikeri. In contrast, type II populations are sympatric with type III populations over much of the South Island. In a field cage trial, males of types II and II (North Island) were attracted to females of both II and II (North Island). We tentatively ascribe the differences between type II and type II (North Island) to intraspecific variation.     

改性丙烯酸-环氧树脂纳米乳液的制备及应用

介绍了水性丙烯酸-环氧树脂纳米乳液的制备及其在油罐防腐工程中的应用。讨论了亲水侧链聚乙二醇相对分子质量大小对涂膜性能的影响以及乳化剂各组分的用量对乳液粒径的影响。     

Diluent effects on carbonate mobility in bisphenol-A polycarbonate in the solid state

The effect of miscible low molecular weight additives on the mobility of the carbonate group in bisphenol-A polycarbonate (BPAPC) has been studied using n.m.r. and dielectric relaxation experiments in the solid state. Proton-enhanced dipolar-decoupled carbon-13 n.m.r. spectra of BPAPC, isotopically enriched at the carbonate position, are obtained without magic-angle sample spinning. The resolved chemical shift anisotropy allows study of nuclear spin relaxation for the carbonate groups in the polymer that have different orientations relative to the static magnetic field in the laboratory frame. The spin-lattice relaxation time in the rotating frame (T_1?) is measured at a motional-probe frequency of 50 kHz for the undiluted polymer and for BPAPC-diluent blends containing either dibutylphthalate or dinitrobiphenyl. The T_1? exhibits some dependence on orientation in all systems studied. In the blend containing dibutylphthalate (DBP), T_1? is decreased by a factor of two for all orientations of the carbonate group. This implies that DBP substantially increases the spectral density of 50 kHz motions in the carbonate region of the polymer at ambient temperature. In contrast, dinitrobiphenyl does not significantly alter the Fourier component of thermal fluctuations at 50 kHz. Dielectric relaxation measurements at 10 kHz reveal that the primary (T_g) and secondary (β) motional processes in BPAPC are affected by low molecular weight additives. An intermediate relaxation process appears in the temperature interval between the glass transition temperature (T_g) and the sub-T_g β-relaxation (T_β) in the polymer-diluent blends. The n.m.r. spin-lattice relaxation rate in the rotating frame, T^?1_1?, correlates well with the relative magnitude of the dielectric dissipation factor (tan δ_ε) between T_g and T_β.