高质量的一级光栅1．55μmDFB激光器

本文详细叙述了ＤＦＢ激光器的设计要点和新的工艺。采用一级全息光栅和二步液相外延法批量研制出高稳定单纵模工作的１．５５μｍ分布反馈激光器（ＤＦＢ—ＬＤ）。外延片成品率＞４０％。器件特性：２５℃时阈值电流２０ｍＡ，单面光功率＞１０ｍｗ，主边模抑制比ＳＭＳＲ达４３ｄＢ（λ／４相移光栅），谱线宽度△ν－２０ｄＢ＝０．３ｎｍ，调制速率＞１．８ＧＨｚ。可靠性测试显示：高温监测光谱稳定，２５°Ｃ时阈值退化率△Ｉｔｈ／ｔ＜０．３ｍＡ／ｋｈ，对应器件预估寿命将超过１０万ｈ。     

Trade-offs in scan path and BIST implementations for RAMs

In this article we propose efficient scan path and BIST schemes for RAMs. Tools for automatic generation of these schemes have been implemented. They reduce the design effort and thus allow the designer to select the more appropriate scheme with respect to various constraints.     

平面Z-型软磁铁氧体频率特性的研究

研究分析了Co2Z材料显微结构与磁性能的关系,在普通铁氧体工艺中引入预磁化处理方法,并适当控制二次再结晶现象,成功地研制出高性能的Co2Z型宽频材料,Z-型铁氧体材料的共振频率可达1.8GHz以上,截止频率在1GHz附近,起始磁导率在8-13之间,介电常数相对较低(ε'<30)。     

Comments on “Fully magnetic attitude control for spacecraft subject to gravity gradient”

The Lyapunov argument used in Wi niewski and Blanke, (Automatica 35 (1999) 1201) to establish asymptotic stability of a magnetic control law for an earth-orbiting spacecraft is incorrect. It is shown here that a small change to the assumed form of the control law can remedy the situation.     

强耦合表面磁极化子的基态能量和有效质量

采用Landau-Pekar变分理论研究强耦合表面磁极化子的性质。分别计算了强耦合表面磁极化子的基态能量和有效质量，并讨化了表面磁极化子的基态能量，振动频率和有效质量随磁场的变化关系。对KCL晶体进行了数值计算，结果表明，强耦合表面磁极化子的振动频率和有效质量随磁场的增加而增加，基态能量随磁场的增加而减少。     

Evaluation of influence of external magnetic disturbance on superconducting magnet taking conservation of linkage flux into account

External magnetic disturbance influences the quality of the image obtained with a magnetic resonance imaging (MRI) system because it causes magnetic resonance frequency drift. When a superconducting magnet in persistent current mode operation is exposed to external magnetic disturbance coil current varies to keep linkage flux constant. Conventional analysis is usually formulated with constant current and does not provide correct evaluation of drift of magnetic field in the magnet. This paper proposes a method of numerical analysis of magnetic field considering conservation of linkage flux in a superconducting magnet under a persistent current mode operation. This method is applied to evaluate drift of the magnetic field in a superconducting magnet for magnetic resonance imaging due to external magnetic disturbance. Analysis results show good agreement with the experimental results.     

MR imaging of focal liver lesions: comparison between turbo spin-echo and conventional spin-echo pulse sequences

The aim of this study was to compare conventional spin-echo (CSE)T ₂-weighted (T2W) images with turbo spin-echo (TSE) T2W pulse sequences in their ability to detect focal liver lesions. Seventy-eight consecutive patients with focal liver lesions were entered into this study. All patients were imaged using the gradient-echo (GE) sequence with the breath-hold technique forT ₁-weighted (T1W) images, and CSE and TSE sequences for T2W images. Qualitative evaluation included lesion detection (number of lesions detected) and conspicuity (extent of visualization of lesional borders); quantitative evaluation included the signal-to-noise (S/N) ratio and the contrast-to-noise (C/N) ratio. TSE showed the best performance in terms of lesion detection; however, the difference between TSE and CSE was significant only in the case of benign cysts (p<0.01). Conspicuity was higher with TSE and CSE, and lower with GE. The S/N and C/N ratios of the two T2W sequences were also comparable, and better than those of GE. However, the combined use of GE and TSE resulted in improved lesion detection. The results show that, because the acquisition time is greatly reduced with TSE sequences, these should be considered as first-line approach to magnetic resonance imaging of the liver for the study of focal lesions.     

氨基磺酸系高性能减水剂的研制开发

本文主要讨论了氨基磺酸系高性能减水剂的合成过程及后期混凝土试验情况。通过对反应温度、反应时间、溶液浓度和酸碱度、投料顺序及速度、第四单体的选择等反应条件的控制,合成具有最佳分子结构的最终产物,并通过红外光谱图和核磁共振谱图对合成主产物的分子结构进行了验证。同时,大量的混凝土试验说明氨基磺酸高性能减水剂具有优良的保坍性能。     

A numerical model for induction heating processes coupling electromagnetism and thermomechanics

This paper presents a mathematical and numerical model developed for coupling the various physical phenomena (electromagnetic, thermal and mechanical) taking place in axisymmetrical induction heating processes. All three electromagnetic, thermal and mechanical models are time dependent and take full account of the electromagnetic and thermal non‐linear effect especially with magnetic materials. The electromagnetic problem is discretized and solved in the workpiece, air and inductors. The heat transfer equation and the mechanical equilibrium equations are solved in the workpiece only, both using a finite element method. The mechanical model can take into account thermoelastic–plastic behaviour for the part. The model has been successfully applied to several cases of induction heating. Comparisons between numerical and experimental results show an excellent agreement. Copyright © 2003 John Wiley & Sons, Ltd.     

压阻式硅微加速度传感器的结构设计与仿真

一般的压阻式硅微加速度传感器结构多采用单梁加质量块的形式,这种形式的传感器灵敏度比较高,但它的横向效应较难克服,文中提出一种四梁结构的加速度传感器,通过仿真计算,说明该结构的加速度传感器具有良好的综合特性.