三种骨灰瓷原料的制备与晶相结构

本实验采用牛、猪、羊三种骨头通过高温煅烧制备骨灰瓷原料。采用XRD和SEM方法表征三种骨灰料的晶相结构和显微结构。实验结果表明 :三种骨灰料经 14 0 0℃煅烧后均存在Ca1 0 (PO4 ) 6(OH) 2 、α -Ca3(PO4 ) 2 种晶相。在 132 0℃煅烧的三种骨灰料中 ,按牛、猪、羊顺序 ,Ca1 0 (PO4 ) 6 (OH) 2 含量分别为 87 2 %、89 1%、71 9% ;β-Ca3(PO4 ) 2 含量最高 ,其可塑性和成瓷性能好 ,从晶相上考虑选择羊骨为较佳的骨灰瓷原料。从白度和透光度上考虑选择牛骨为较佳原料。随着煅烧温度升高 ,三种骨头料的β-Ca3(PO4 ) 2 含量增加 ,羊骨和牛骨中的Ca1 0 (PO4 ) 6 (OH) 2 含量减少 ,而猪骨的Ca1 0(PO4 ) 6 (OH) 2 含量反而增加。因此煅烧温度升高对羊骨和牛骨有利 ,而对猪骨不利     

新型多喷嘴对置式水煤浆气化技术工业化应用

煤气化技术是实现煤炭洁净利用的关键。介绍了新型多喷嘴对置式水煤浆气化炉流场、煤气化机理及其工业化应用概况。通过工业化运行结果表明:该装置气化效率高,交叉流式洗涤冷却水分布器的水均布,气化炉运转平稳,负荷可调节范围大,洗涤、冷却性能好,该技术打破了国外对水煤浆气化技术的垄断。     

Potassium sorbate solutions as copper chemical mechanical planarization (CMP) based slurries

Copper depassivation and repassivation characteristics in potassium sorbate solutions, subsequent to mechanical abrading are reported. The identification of copper repassivation kinetics obtained subsequent to mechanical damage of copper protective films formed in sorbate based solutions is discussed. The repassivation rate of copper in sorbate based solutions was measured by means of a slurryjet system capable of measuring single particle impingments on microelectrodes. Copper repassivation rates measured by this slurryjet system in sulfate solutions containing 10 g L⁻¹ potassium sorbate were found to be in the range of 0.5-1.5 ms. An increase in the potassium sorbate concentration leads to a decrease in copper repassivation time at potentials ranging from 200 to 600 mV_Ag/AgCl. The impingement angle between the copper surface and a single abrasive particle has no impact on copper repassivation time nor peak current (I_max) values. XPS studies revealed that copper passivation in potassium based solution was due to the formation of a thin film which is constituted of: Cu₂O, Cu(OH)₂ and Cu(II)-sorbate, while copper(II)-sorbate is mainly present at the top levels of the passive film. It is therefore recommended that the use of potassium sorbate as a passivating component in conjunction with the addition of strong oxidizing agents in chemical mechanical planarization (CMP) slurry design should be considered.     

洁净煤（水煤浆）用高效分散悬浮剂的制备

通过选用特定的小分子单体,采取分段聚合方式,合成具有特定官能团的化合物,用作水煤浆分散悬浮剂。     

湿法聚氨酯树脂浆料配方的改进

通过对湿法PU合成革用聚氨酯(PU)树脂浆料配方的改进，降低了浆料的生产成本，浆料的后期加工性能提高，并且PU膜的性能也有所改善。     

德士古水煤浆气化的运行及改造

对德士古煤浆的制备和贮运、气化、闪蒸系统的长周期运行方面进行了改造,改造后系统的运行质量得到了改善和提高。     

石灰乳输送泵的失效分析与优化设计

结合某水泵厂提供的石灰乳输送泵的设计资料,根据试制的离心渣浆泵出现的失效现象,分析失效原因,研究改进方法,为低比转数离心渣浆泵的设计提出优化设计意见。     

气相法聚乙烯BCG-Ⅱ型催化剂的开发和应用

对气相法聚乙烯BCG-Ⅱ型催化剂的组成、粒径分布及催化剂的淤浆聚合性能进行了研究。研究结果表明，BCG—Ⅱ型催化剂的活性较高，聚合物堆密度适中，应用在Unipol乙烯气相聚合工艺装置上操作良好，所生产的树脂颗粒均匀。干爽且流动性好，产品质量合格、稳定。     

美国能源部的浆态床F－T合成技术

浆态床Ｆ－Ｔ合成技术是美国能源部Ｆ－Ｔ合成技术的主要开发项目。本文就浆态相Ｆ－Ｔ合成催化剂的开发、中试示范实验和浆态反应器的化工基础研究作一扼要的介绍。     

New analysis of non-newtonian turbulent flowndashyield-power-law fluids

The writers' new analysis of non-Newtonian turbulent flow is extended to the yield-power-law model. As the value of the exponent of the yield-power law decreases from unity, the calculated friction factor begins by converging toward the Newtonian line at high velocity, then parallels it, and finally diverges downward. This prediction agrees with previously unexplained experimental results.