β晶型成核剂改性聚丙烯纤维研究

研究了含 0 .2 5 %β晶型成核剂 (酰胺化合物 )的聚丙烯 Z3 0 S及其纤维的力学性能、晶型结构和微观形态。通过纺丝 -拉伸实验和力学性能测试、广角 X射线衍射分析、SEM观察 ,发现成核改性后生成了β晶型聚丙烯 (K值约为 75 .3 % ) ,抗冲性能大幅度提高。β晶型聚丙烯在纺丝卷绕过程中发生了β晶型→α晶型转变 ,纤维中产生约 10 %微孔隙 ,改性纤维的力学性能有所降低。     

针状纳米级碳酸钙工业制备新工艺

在复合结晶导向剂存在条件下，在碳化温度30～75℃、氢氧化钙初始质量分数8％～12％的高温高浓的工艺条件下，制备出了直径为20nm、长径比为10～15、粒径分布均匀的针状纳米碳酸钙。同时研究了结晶导向剂加入量、碳化温度、氢氧化钙初始浓度等对针状纳米碳酸钙的粒径和形貌的影响，并进行了工业化试验，取得良好结果。     

可见光响应的"Cu核- Cu2O壳"型光催化剂性能的研究

以碱性染料结晶紫为目标污染物,金属卤化物灯为可见光光源,研究了自制的"Cu核-Cu20壳"微粒的光催化性能.实验结果表明,该催化剂对可见光有良好的响应,当固液比为1500,光照120min,质量浓度为60mg/L的结晶紫溶液色度和COD去除率分别达98%和92%.检测结果表明,光催化过程中有氢氧自由基产生,染料发生了彻底的降解.     

0.91Pb(Zn1/3Nb2/3)O3-0.09PbTiO3的析晶行为及助溶剂法生长

研究了0.91Pb(znl/3Nb2/3)O3-0.09PbTiO3(PZNT91/9,摩尔分数)在不同组分和配比熔盐中的析晶行为及其对晶体生长的影响。发现B2O3,PbF2等助溶剂不利于钙钛矿相的析出;而BaTiO3-PbO复合体系虽然能够促进钙钛矿相析出,但晶体析出量很少;只有适当比例的。PbO助溶剂比较适合于生长具有铁电性的钙钛矿相PZNT91/9单晶。助溶剂法生长的工艺参数为:溶质与PbO助溶剂的摩尔比为l:l,泡料温度1 150-1 200℃,泡料时间10 h,晶体生长时降温速度0.8-2℃/h,当温度降到900℃时停止生长,以50℃/h快速冷却至室温。所得晶体为琥珀色,最大尺寸达φ30 mm×15 mm,其压电系数和机电偶合系数分别为2000 pc/N和0.92。     

（Nb_yTi_（1－y））C_x单晶体制备及其结构研究

用熔剂法制备了（Ｎｂ＿ｙ．Ｔｉ＿（１－ｙ））Ｃ＿ｒ单晶体，用Ｄｅｂｙｅ照相法及四圆衍射仪对其晶体结构进行了研究。实验结果表明，（Ｎｂ＿ｙＴｉ￣（１－ｙ）Ｃ＿ｘ中存在类似于作化学计量化合物ＴｉＣ＿ｘ及ＮｂＣ＿ｘ的有序一无序转变现象，转变温度随其化学成份改变在１１７５～１２８０Ｋ范围内变化。高温型（Ｎｂ＿ｙＴｉ￣（１－ｙ））Ｃ＿ｘ的晶体结构属ＮａＣｌ型结构，碳空位呈随机分布；低温型（Ｎｂ＿ｙＴｉ￣（１－ｙ））Ｃ＿ｘ的晶体中碳空位呈短程有序分布，可用Ｖ＿６Ｃ＿５晶体结构模型进行描述。     

Transformation of Crystal Phase of Micron-sized Rutile TiO2 and Investigation on its Sonocatalytic Activity

The partial transformation of crystal phase of micron-sized TiO₂ powder from rutile to anatase was realized utilizing microwave irradiation in hydrogen peroxide solution. Afterwards, the ultrasound of low power was used as an irradiation source to induce the transition crystal TiO₂ powder to perform the sonocatalytic activity through the degradation of azo fuchsine in aqueous solution. The results show that the sonocatalytic activity of the transition crystal TiO₂ powder is obviously higher than that of pure micron-sized rutile and anatase TiO₂ powders. The degradation ratio of azo fuchsine in the presence of the transition crystal TiO₂ powder attains nearly 80% within 80 min ultrasonic irradiation.     

Stochastic defect diffusion model for relaxation effects in crystalline polyethylene

It is suggested that some relaxation processes observed in crystalline polyethylene are consequences of the diffusive motion of a particular defect called a point dislocation or twist dispiration loop along the polyethylene stems in lamellar crystals. The motion of the defect, characterized by a diffusion coefficient and a mobility, is described by solutions of the Smoluchowski diffusion equation with boundary conditions that constrain the defect to move along routes that produce experimentally observable results. The fact that passage of the defect causes both a 180° rotation of the chain and moves an extra CH₂ group in the direction of the chain axis is important to the interpretation of the data according to this model. The diffusion coefficient for a defect is estimated to be around 2 × 10^?9 cm² s^?1 at 70°C. This value is shown to be reasonable both from the viewpoint of detailed computer modelling of defect motion and contemporary ideas about scaling.     

云母钛珠光颜料的形成机理研究

阐述了云母钛的形成机理，即云母依靠静电引力吸附[Ti(H2O)6]^4 形成双电层，双电层上的[Ti(H2O)6]^4 发生水解引起多核络合物生长为水合二氧化钛，水解的水合二氧化钛与云母产生异质颗粒间的互凝而形成云母钛。     

Electrochemical reduction of nitrate on Pt(S)[n(1 1 1) × (1 1 1)] electrodes in perchloric acid solution

The electrochemical reduction of nitrate ion was studied by cyclic voltammetry on Pt(1 1 1) and [n(1 1 1) × (1 1 1)] stepped Pt surfaces, where n (=14, 10, 7, 6, 5, 4, 3, 2) is the number of terrace atoms, in 0.1 M HClO₄ + 10 mM KNO₃. The electrocatalytic nitrate reduction was found to hardly proceed on Pt(1 1 1) in the hydrogen adsorption region, while the electrocatalytic activity was improved with the increase in the step density. Inactivation was observed in the presence of adsorbed hydrogen or nitrate-derived reduced adsorbate, i.e. adsorbed NO, on (1 1 1) step sites. It was, therefore, concluded that the electrocatalytically active NO₃⁻ species does not adsorb on the (1 1 1) terraces but on the (1 1 1) monoatomic steps. The nitrate reduction current increased with the step density in a non-linear relationship. The overall current density at 0.21 V (RHE) corresponding to the peak potential of the main electrocatalytic nitrate reduction wave which was maximum at n = 2, abruptly increased with short terraces, i.e. n < 5, where the current wave of adsorbed hydrogen on the Pt stepped surface with comparatively narrow (1 1 1) terraces, denoted as H_nt, also appeared unmodified for n < 5 on voltammograms recorded in 0.1 M HClO₄ in the absence of nitrate.     

结晶紫-硼酸体系的热变色性能研究

选用羧酸类溶剂,采用固相法合成了结晶紫-硼酸系列可逆热致变色材料。考察了结晶紫和硼酸的配比、羧酸类溶剂的种类与用量以及环境温度对其热变色性能的影响。结果表明:以草酸为溶剂时,m(结晶紫)∶m(硼酸)∶m(草酸)=1∶350∶100时,颜料变色敏锐,变色温度降低到58℃,复色时间为16s,可逆性好;以丙二酸为溶剂时,m(结晶紫)∶m(硼酸)∶m(丙二酸)=1∶350∶1000时,颜料加热到68℃时,开始由浅绿色逐渐变为浅黄色,颜料色彩鲜艳,变色敏锐,复色时间仅为8s,可逆性好。DSC检测颜料的热变色过程发现2个样品在55～75℃之间都有很大的吸热峰。