助模板剂对MCM—41分子筛孔结构和性能的影响

在硅酸钠－硫酸铝－十六烷基三甲基氯化铵－水体系中，加入不同类型，如正庚烷、三甲基苯和十二胺的有机助模板剂（简称助剂）进行ＭＣＭ－４１分子筛的合成试验，并用ＸＲＤ、ＩＲ及Ｎ２吸附等方法考察了助剂对ＭＣＭ－４１分子筛孔径、热稳定性及酸性的影响。结果表明，十二胺助剂对ＭＣＭ－４１分子筛的孔径影响最大，但热稳定性较差，相比之下，三甲基苯助剂合成的ＭＣＭ－４１分子筛具有孔径大、热稳定性好和酸性特征较好的特点。     

SAPO-34/SiO_2催化甲醇制烯烃

采用水热法合成了SAPO-34分子筛,并用X射线粉末衍射仪和扫描电子显微镜对SAPO-34分子筛的结构进行了表征,同时探讨了黏合剂种类、甲醇分压、催化剂粒径和硅源等对SAPO-34分子筛催化甲醇制烯烃(MTO)反应性能的影响。实验结果表明,在MTO反应中,三烯(乙烯、丙烯和丁烯)选择性在反应初期存在明显的诱导期;以S iO2为黏合剂合成的SAPO-34/S iO2催化剂不但可缩短MTO反应的诱导期,三烯选择性也较未添加黏合剂或以A l2O3为黏合剂时高1~2个百分点;且当催化剂活性明显下降时,三烯选择性下降的幅度较小。催化剂粒径、甲醇分压及硅源对催化剂的诱导期也有明显的作用。在甲醇分压低于19kPa、催化剂粒径0.25~0.38mm、S iO2为黏合剂、硅酸四乙酯为硅源时,SAPO-34/S iO2催化剂的MTO性能明显提高。     

DX centers in AlxGa1-xAs bulk alloy,AlAs/GaAs ordered,and disordered superlattices

Properties of theDX centers in Al_0.5Ga_0.5As bulk alloy (b-AL), (AlAs)₂ (GaSa)₂ ordered superlattice (o-SL) and (AlAs) _m (GaAs) _n disordered superlattice (d-SL) (m = 1, 2, 3,n = 1, 2, 3) with the same macroscopic composition were measured and compared. By deconvolution of deep level transient spectroscopy (DLTS) spectrum due to theDX center, we have found a decrease in the number of separate peaks in DLTS spectrum in an intentionally atomic ordered arrangement. Visiting Scholar of the Japan Society for the Promotion of Science. On leave from Department of Electrical Engineering, San Jose State University, San Jose, California 95192-0084, USA.     

海南省水资源配置决策的层次分析模型研究

海南省特殊的地理位置决定了其水资源配置问题的独特性,在水资源配置方案中,呈现出多阶段、多层次、多目标、多决策主体的特点,使得水资源配置模型难以确定并给决策带来了很大的风险性。本文研究了适合于海南省水资源优化配置所需的评比指标,对层次分析法加以改进,结合海南省水资源配置问题的决策要求,用改进后的层次分析法进行评价指标优化计算,最终得出了较为满意的结果。     

Influence of washing and of heat-treatment conditions on the thermal stability of VPI-5

Thorough washing of a VPI-5 synthesized with n-dipropylamine as template improves greatly its thermal stability while no major change is observed in the template content. A detailed study of the influence of the pretreatment conditions shows that in order to obtain a high thermal stability (up to at least 960 °C) two parameters are of importance. The removal of both the template and the adsorbed water requires either a low heating rate at atmospheric pressure or a low pressure (less than 3 Torr) when the heating rate is 300 ° per hour.     

VAc／MMA半连续乳液共聚合的研究：Ⅱ分子量及其分布

以过硫酸铵为引发剂，十二烷基硫酸钠为乳化剂，于７０℃下进行了ＶＡｃ／ＭＭＡ乳液共聚合试验。试验确定了不同组成ＶＡｃ／ＭＭＡ共聚物的Ｍａｒｋ－Ｈｏｕｗｉｎｋ方程参数Ｋ和α值。对ＧＰＣ测试数据处理给出了加料速率，乳化剂量，单体比例及种子与非种子法对分子是及其分布的影响。     

人参皂苷Rg分子轨道微扰理论的研究

人参皂苷Rg是具有生理活性的物质，它包括三个异构体：Rg1；Rg2；Rg3其中R83具有很强的抗癌作用。本文通过休克尔分子图形理论对Rg异构体的各分子轨道进行约化，并且根据分子轨道微扰理论求出它们不同本征多项式和本征值。     

Molecular Diffusion Coefficients of Organic Compounds in Water at Different Temperatures

Molecular (or tracer) diffusion coefficient data were obtained for 2-naphthol, benzoic acid, salicylic acid, camphor, and cinnamic acid in water at temperatures that differ significantly from ambient value. Experimental values were determined for the dissolution of 2-naphthol in water at 283 to 368 K, of benzoic acid in water at 283 to 338 K, of salicylic acid in water at 283 to 343 K, of camphor in water at 283 to 318 K, and of cinnamic acid in water at 283 to 318 K. Empirical correlations are presented for the prediction of molecular diffusion coefficient over the entire range of temperatures studied, and they are shown to predict the obtained data with very good accuracy.     

连续化,高速化,自动化是提高线材制品在国内外市场竞争力的根本出路

对线材制品从连续化、自动化、高速化等方面与国外企业生产状况进行了分析比较,提出了实现生产过程的连续化、高速化、自动化是发展我国线材制品的必由之路的观点。     

活性碳和5A分子筛的吸附特性及其在真空获得中的作用

评述了活性碳和５Ａ分子筛的吸附等温线及其在真空佩温绝热夹层真空获得中的作用。分析了真空夹层抽真空除气时用Ｎ＿２气置换以及用“多次吸附－脱附Ｎ＿２气”方法活化吸附剂等先进工艺的机理。论述了根据吸附剂吸水的吸附等温线，合理确定活化工艺条件的方法。