Pitting corrosion of Cr–Mn–N steel in sulphuric acid media

The resistance to pitting corrosion of austenitic stainless steel Cr18Mn12N has been studied in model solutions of sulphuric acid (0.5 m) containing chloride ions (0.5 m). The cyclic potentiodynamic method has been employed to investigate the effects of chloride ions and agitation rate on the pitting and repassivation potentials. Electron and optical microscopy, electron diffraction spectroscopy and atomic absorption spectrometry have been used to detect the surface sites for pit formation and the growth of pit nuclei. The results obtained with chromium–manganese–nitrogen steel have been compared with those of austenitic Cr18Ni9 stainless steel. A similarity in pit initiation is established, while steel composition exhibits no significant effect. Cr18Mn12N steel is less prone to repassivation as compared with Cr18Ni9 steel.     

一种识别薄板对接接头的视觉方法

对薄板紧密对接接头的识别问题进行了深入的分析，提出了由照明、自适应局部特征提取、全局特征识别和验证融合在一起的视觉识别方法。它克服了电弧光的干扰，识别结果可靠，可以有效地解决薄板紧密对接接头识别这一难题。     

High concentration erbium doping of silicon-rich SiO2 thin films on silicon

In this work, high concentration erbium doping in silicon-rich SiO₂ thin films is demonstrated. Si plus Er dual-implanted thermal SiO₂ thin films on Si substrates have been fabricated by using a new method, the metal vapor vacuum arc ion source implantation with relatively low ion energy, strong flux and very high dose. X-Ray photoelectron spectroscopy measurement shows that very high Er concentrations on the surfaces of the samples, corresponding to 10 at.% or the doping level of 10²¹ atoms cm⁻³, are achieved. This value is much higher than that obtained by using other fabrication methods such as the high-energy ion implantation and molecular beam epitaxy. Reflective high-energy electron diffraction, atomic force microscopy and cross-section high-resolution transmission electron microscopy observations show that the excess Si atoms in SiO₂ matrix accumulate to form Si clusters and then crystallize gradually into Si nanoparticles embedded in SiO₂ films during dual-ion implantation followed by rapid thermal annealing. Er segregation and precipitates are not formed. Photoluminescence at the wavelength of 1.54 μm exhibits very weak temperature dependence due to the introduction of Si nanocrystals into the SiO₂ matrix. The 1.54-μm light emission signals from annealed samples decrease by less than a factor of 2 when the measuring temperature increases from 77 K to room temperature.     

品种和加工方式对双低菜粕有效能和氨基酸有效性的影响_注

用精确饲喂技术评价了 3个品种的中国双低油菜和 1个加拿大卡诺拉的脱脂种籽和商品饼粕的能量和氨基酸的有效性。结果表明 ,4个脱脂种籽的氮校正真代谢能和氨基酸真消化率没有差异 (P >0 .0 5 ) ;而 4个商品饼粕的脱脂样品的氮校正真代谢能和氨基酸真消化率有极显著或显著差异。研究结果证实 ,不适当的加工方式不仅降低了氨基酸的有效性 ,而且影响家禽对能量的利用效率。     

一种小电流下的引弧及稳弧方法

介绍一种小电流直流TIG焊中的引弧及稳弧方法，并对实现此功能的控制电路进行了详细的分析。简单介绍了此种小型焊机的特点及用途。     

The distribution of nutrient elements in cell wall and other fractions of the herbage of some grasses and legumes

The distribution of 10 nutrient elements was assessed in three fractions of herbage samples of perennial ryegrass, tall fescue, white clover and lucerne. The cell wall fraction, prepared by mechanical disintegration of undried material, contained the following proportions of the total herbage content of the major elements: N, 2.9–16.4%; P, 3.0–6.9%; S, 3.6–17.2%; Ca, 11.3–51.8%; Mg. 6.4–27.6% and K, 0.1–1.7%. Substantial though more variable proportions of the trace element cations, Fe, Mn, Zn and Cu were also present in the cell wall fraction. The extent to which the elements were soluble in water was assessed by analysis of the water-insoluble fraction prepared from freeze-dried samples of each herbage. The proportions of the total herbage content of the major elements soluble in water were: N, 30–57%; P, 80–92%; S, 35–71%; Ca, 48–69%; Mg. 65–83% and K, 90–96%. With the trace element cations the proportions soluble in water were more variable, though they were generally less than 70% of the total. The extent to which the various elements were soluble in 80% aqueous ethanol was assessed by analysis of the insoluble fraction prepared from freeze-dried materials. With each of the major elements, smaller proportions of the total herbage content were soluble in 80% ethanol than in water, which may reflect in part the lower solubility of proteins and pectin. With the trace element cations, the differences in solubility between 80% ethanol and water were generally small and inconsistent.     

埋弧焊方法的使用

通过对埋弧焊工作原理、特点和焊接工艺的介绍,提出了鸿源卷管的焊接参数,埋弧焊焊接缺陷及其防止措施。     

马钢A/OO生物脱氮装置的试运行

介绍了马钢A/OO生物脱氮装置的工艺流程、工艺条件及影响因素,探讨了A/OO生物脱氮工艺试运行中存在的问题和解决措施。     

直流电弧炉长弧泡沫渣技术

本文指出了直流电弧炉采用长弧泡沫渣技术的必要性及该技术的发展现状，总结了炉渣物理性质，化学成分，温度和气源等对炉渣泡沫化的影响，并介绍了电炉泡沫渣的操作工艺及实际应用效果，对宝钢三期１５０ｔＤＣ－ＵＨＰ电弧炉的泡沫渣工艺提出了看法。     

Characteristics and classification of high-current fault arcs on distribution systems

When a fault occurs on transmission or distribution systems due to lightning or overvoltage, often an arc discharge occurs at the fault point. The arc discharge, which is caused by a fault current, has a high current, high temperature, strong light emission, etc., thus it sometimes causes heavy damages to electric power equipment. The arc discharge is influenced by the conditions around the arcs, i.e., gas, insulation materials, gap length, weather, etc. Also, the arc voltage along the arc column indicates the characteristics of the arc. If the voltage waveforms of the arcs caused by the fault on transmission or distribution systems are classified, it is possible to find the location and the equipment where the fault occurred. In this paper, the arc voltage data in 6-kV class XLPE cables and 6-kV class overhead lines are analyzed and an artificial neural network method is applied to classify the arc voltage waveforms. The results obtained from the six artificial neural networks developed show that the artificial neural network method is effective for classification of arc voltage waveforms if adequate input parameters are selected.