采用荷载平衡的概念表达预应力度及在初步设计中的应用

利用荷载平衡法的概念，将预应力度用等效荷载与外荷载的比值表达，设计可利用其比值确定预应力度，便其更简捷，明确，同时，提出了预应力度的真实值问题。     

钢结构稳定设计——理论与实践

本文提出了实际工程结构的非线性理论设计和分析方法(NIDA),并以澳门回归纪念馆的设计为例,展示了本方法的优越性.在设计过程中,设计者无需假设K系数和有效长度,在结构分析完成后便可迅速完成设计,因此本文提出的方法既经济又便利.尽管对于钢框架在往复荷载及动力荷载作用下的弹塑性大位移分析已经非常成熟,但本文的方法开创了结构的非线性分析及设计的新纪元,能够对现行的设计方法理论起到巨大的推动作用.     

平衡纵剖面数值试验及其对防洪的影响研究

本文采用一维非恒定流非均匀沙的水沙数学模型，以长江中游螺山汉口河段为背景，进行了根化数值模拟试验，分析了该概化河段平衡纵剖面的变化规律及其与上游来水来沙条件的关系，并和相应的理论公式进行了比较。在此基础上，对水沙条件发生较在变化时的平衡纵比降以及带来的对长江中下游防洪的影响进行了分析。     

Impurity Distribution Behavior in Caprolactam Extraction with Environmentally Benign Mixed Solvents

In a previous study a solvent mixture of heptane containing 40 mass % heptanol was selected as an alternative in the industrial extraction of caprolactam to replace benzene, toluene, or chlorinated hydrocarbons. This work reports the equilibrium distribution ratio of caprolactam and four model impurities of organic nature, namely, cyclohexanone, aniline, n‐methylcaprolactam, and cyclohexane‐carboxamide, comparing the mixed solvents with toluene as a reference. The resulting phase equilibria were interpreted using the equilibrium stage model. Based on these calculations it was found that, compared to toluene, the co‐extracted fraction of cyclohexanone and aniline was higher, that of n‐methylcaprolactam was comparable, and that of cyclohexane‐carboxamide was lower using the mixed solvent. Overall, the mixed solvent reduced the fraction of co‐extracted impurities by almost 10 %.     

间苯二酚溶剂萃取液液相平衡研究

测定了“醋酸正丁酯-间苯二酚(溶质)-盐水(含0.2质量分率NaCl)”三元系在24℃、101.33kPa下的液液相平衡数据并给出了三角相图,用Hand公式对相平衡数据进行了关联,获得了可供工业连续萃取过程设计使用的关联式。本研究将醋酸正丁酯和正丁醇作为溶剂萃取间苯二酚进行了对比,并指出:醋酸正丁酯优于正丁醇。     

准最佳二进阵列偶

本文在最佳二进阵列、准最佳二进阵列和最佳二进阵列偶的基础上,定义了一种新的最佳信号,即准最佳二进阵列偶.讨论了准最佳二进阵列偶的体积、变换性质,并对其进行了Fourier频谱分析,得到了部分有益的结果.还用计算机穷举搜索出了体积从2~24的准最佳二进阵列偶.     

Modelling of the extraction equilibrium of zinc from chloride solutions with tri-n-octylphosphine oxide

The extraction of zinc from chloride solutions with tri-n-octylphosphine oxide (TOPO) dissolved in benzene has been thermodynamically studied based on the law of mass action. A model employing the simplified Pitzer equations for stoichiometric activity coefficient estimations is found to be effective for the explanation and prediction of the distribution data, and the thermodynamic extraction constant is determined as log K_et = 5.16 ± 0.11 at 20°C.     

Phase equilibrium in solutions of star-shaped macromolecules: an improved Okada-Numasawa model

The two-region Okada-Numasawa model for solutions of star-shaped polymers has been improved by means of a change in the integration order and introduction of a concentration-dependent and molar-mass-dependent Flory-Huggins interaction parameter (the second and third approximations of the Flory-Huggins theory). To overcome calculation difficulties, a special algorithm for computing coexistence curves of polymeric systems with an UCST has been used. The agreement between the experimental and calculated coexistence curves for the star-shaped polystyrene (PS)-cyclohexane system has been improved: the difference between T_cs is ∼0.33 K against ∼12 K as given by the original model.     

Calcium addition in straw gasification

The present work focuses on the influence of calcium addition in gasification. The inorganic-organic element interaction as well as the detailed inorganic-inorganic elements interaction has been studied. The effect of calcium addition as calcium sugar/molasses solutions to straw significantly affected the ash chemistry and the ash sintering tendency but much less the char reactivity. Thermo balance test are made and high-temperature X-ray diffraction measurements are performed, the experimental results indicate that with calcium addition major inorganic-inorganic reactions take place very late in the char conversion process. Comprehensive global equilibrium calculations predicted important characteristics of the inorganic ash residue. Equilibrium calculations predict the formation of liquid salt if sufficient amounts of Ca are added and according to experiments as well as calculations calcium binds silicon primarily as calcium silicates and less as potassium calcium silicates.