基于15N质量平衡法研究养殖消化废水中氨氮的去除机理

为避免养猪场消化废水对环境造成的污染,利用微藻去除消化废水中营养物质的二次处理方法受到了广泛关注。采用¹⁵N质量平衡法研究了鞘藻去除氨氮的主要机理,重点研究了鞘藻生长与氨氮去除的关系以及氨氮去除的主要途径。经高压灭菌后的消化废水在鞘藻培养期的氨氮去除率为96.2%,鞘藻特定生长率为0.04~0.15;稀释后的原消化废水氨氮的去除率为94.1%,鞘藻特定生长率为-0.14~0.13。通过曝气的汽提效应对氨的去除有显著的促进作用,尤其在高pH值试验条件下更有利于脱氨。¹⁵N同位素质量平衡分析表明,原始消化废水中存在的细菌对氨氮的去除影响小,在鞘藻培养期去除原消化废水中氨氮的主要途径是鞘藻的吸收和气体的损失,分别占总氮量的40.97%和32.59%。氨氮的去除与主要影响因素间的回归和通径分析表明,要提高氨氮去除率,需要提高鞘藻Chl-a含量和DO浓度,同时限制或保持pH值在弱碱性状态。     

X-ray Fluorescence Uptake Measurement of Functionalized Gold Nanoparticles in Tumor Cell Microsamples

Quantitative cellular in vitro nanoparticle uptake measurements are possible with a large number of different techniques, however, all have their respective restrictions. Here, we demonstrate the application of synchrotron-based X-ray fluorescence imaging (XFI) on prostate tumor cells, which have internalized differently functionalized gold nanoparticles. Total nanoparticle uptake on the order of a few hundred picograms could be conveniently observed with microsamples consisting of only a few hundreds of cells. A comparison with mass spectroscopy quantification is provided, experimental results are both supported and sensitivity limits of this XFI approach extrapolated by Monte-Carlo simulations, yielding a minimum detectable nanoparticle mass of just 5 pg. This study demonstrates the high sensitivity level of XFI, allowing non-destructive uptake measurements with very small microsamples within just seconds of irradiation time.     

高温熔融-电感耦合等离子体原子发射光谱法测定含铁尘泥中5种有害元素

准确、快速地测定含铁尘泥中有害元素,对含铁尘泥节能降废项目研究及综合利用有着重要的指导意义。实验针对含铁尘泥试样因含碳量高,导致常规酸溶解方法如果不增加除碳步骤则很难完全分解试样的问题,采用高温熔融法将试样制成熔融液后倾倒于稀酸中溶解的方法,解决了碳含量高难溶解的问题。采用四硼酸锂-碳酸锂混合熔剂在高温下将试样熔融,熔融液高温倾倒于稀酸中制成澄清溶液,由于骤冷,试样炸裂成微小玻璃珠,无迸溅,操作简单,使得后续溶解过程快速完成,从而建立了电感耦合等离子体原子发射光谱(ICP-AES)测定P、Pb、K、Na、Zn共5种有害元素的方法。按照实验方法测定含铁尘泥中P、Pb、K、Na、Zn,测定值的相对标准偏差(RSD,n=9)在1.4%～5.7%之间,加标回收率在96%～110%之间。研究结果表明方法能够满足含铁尘泥样品中5种元素的定量分析要求。     

磷对Ni3Al凝固组织的影响

磷(P)在Ni3Al中的溶解度很低，凝固过程中向剩余液体中偏聚，最终在晶界上析出富P相，凝固后期。P在剩余液体中的偏聚程度升高，降低形核率，抑制试样心部等轴晶的形成，促使试样外缘晶粒向心部延伸生长，增加柱状晶长度。P降低合金终凝温度，增如糊状区长度，阻碍液相补缩，增加形成疏松的倾向。P产生上述作用的根本原因是其降低固、液两相体积自由能差和原子跃迁穿过液／固界面的激活能。     

低碳钢中磷的偏聚与再结晶织构

本文用正、倒极图和ODF法研究了低碳钢板在不同冷轧和再结晶退火条件下,磷对再结晶织构的影响。用金相术、扫描电镜和电子探针研究了磷在钢中的分布和显微组织。结果发现,磷促进了与轧向平行的一组〈001〉和与轧面法向平行的一组〈111〉纤维织构的生成;这种作用与预退火温度密切相关,在390和590℃进行预退火就呈现,在490℃就抑制。在促进织构生成的预退火温度时产生晶内磷偏聚的异常显微组织。并认为这种纤维织构的形成与晶内磷偏聚有关。     

Effects of phosphorus addition on the magnetic properties of sintered Fe-50 wt.% Ni alloys

Phosphorus was added to Fe-50 wt.% Ni in the form of a coated composite powder via an electroless plating process. Addition of phosphorus to Fe-50 wt.% Ni facilitated increases in density and grain size, both of which were beneficial to magnetic performance. Because of the homogeneous distribution of phosphorus in the powder, the optimal phosphorus addition was much lower than for those using Fe₃P as the phosphorus precursor. The optimal phosphorus addition was close to its maximum solubility in Fe-50 wt.% Ni (about 0.5 wt.%), above which precipitation of excessive phosphorus in the form of iron nickel phosphide, (Fe,Ni)₃P, effectively degraded the magnetic properties of Fe-50 wt.% Ni. Without the addition of phosphorus, good magnetic properties could be achieved only when the sintering temperature was high enough (>1200 °C) to result in a high sintered density and large grains in the sintered structure.     

Fertilizers and eutrophication in southwestern Australia: Setting the scene

An excess of plant nutrients has caused serious eutrophication in aquatic ecosystems of southwestern Australia manifested by excessive growth and accumulation of green and bluegreen algae. Phosphorus is generally the limiting nutrient for algal growth and phosphatic fertilizers applied to nutrient-deficient, leaching, sandy soils are the main source of P, supplemented by rural industry point sources. Nitrogen is the limiting nutrient in marine embayments with little drainage from the land. Measures to reduce the load of P delivered to drainage include basing fertilizer application rates on soil testing for P and the use of less soluble P fertilizers. Catchment management plans are being implemented with community involvement to reduce P loads and maintain agricultural production. This introductory paper reviews the history of eutrophication in southwestern Australia and of studies into its causes, principally in the large Peel-Harvey estuary. It briefly summarises other papers in this special issue concerned with different aspects of the problem: how to fertilize the land without causing eutrophication.     

Response of rainfed bread and durum wheat to source,level and timing of nitrogen fertilizer on two Ethiopian Vertisols: II. N uptake,recovery and efficiency

In trials conducted at 2 highland Vertisol sites in Ethiopia in 1990 and 1991, 2 locally popular wheat cultivars, 1 spring bread wheat (Triticum aestivum L.) and 1 durum wheat (T. durum Desf.), were supplied with nitrogen (N) fertilizer at 0, 60 and 120 kg N ha^–1 in the form of large granular urea (LGU), standard urea prills or ammonium sulfate. N was applied all at sowing, all at mid-tillering or split-applied between these two stages (1/3:2/3). While durum wheat exhibited the highest N concentration in grain and straw, bread wheat, because of its higher productivity, resulted in a greater grain and total N uptake. In general, split application of N and use of LGU as N source enhanced grain and total N uptake, apparent N recovery and agronomic efficiency of N, particularly under severe water-logging stress. Where significant, the interactions among the experimental factors substantiated the superior responsiveness of the bread wheat cultivar to fertilizer N, and the beneficial effects of split N application and LGU as an N source. Split application of N tended to nullify the positive effects of LGU, presumably by approximating the delayed release of N achieved with LGU. Considering the potential benefits to Ethiopian peasant farmers and consumers, split application of N should be advocated, particularly on water-logged Vertisols; LGU could be an advantageous N source assuming a cost comparable to the conventional N source urea.     

脲醛树脂微胶囊包覆红磷阻燃剂制备工艺的研究 Ⅰ.预聚物合成工艺研究

研究了脲醛树脂的预聚物通过原位聚合对红磷进行包覆的一些影响因素。实验表明影响预聚物质量的主要因素是第一阶段尿醛比(F/U)1,第二阶段尿醛比(F/U)2,反应温度和pH值。制备预聚物的最佳条件为:第一阶段尿醛比为2.3∶1(摩尔比),第二阶段尿醛比为1.3∶1(摩尔比),pH值为5.1,反应温度为75℃。制备的预聚物来包覆红磷,颜色为白色;用微胶囊红磷阻燃聚乙烯,当含量为9%时,在500℃下残余物为4.85%。     

Consequences of different cutting regimes on regrowth and nutrient stoichiometry of Sparganium erectum L. and Potamogeton natans L.

Aquatic vegetation forms an essential component in freshwater ecosystems but due to changed environmental and anthropogenic conditions often needs management to reduce nuisance for human land‐use. In this paper, the authors looked at the regrowth of two macrophyte species (Potamogeton natans and Sparganium erectum) in two lowland rivers under different cutting treatments. After an initial cross‐sectional transect was manually removed from bank to bank at the beginning of the growth season, a monthly repetitive removal of biomass in plots on that transect was done during the rest of the growth season (testing frequency of mowing). Additional new transects were also cut in subsequent months (testing timing of mowing). Finally, biomass was repetitively removed in plots in those additional transects too (testing frequency of mowing × timing of mowing). The biomass at the end of the growth season was analysed for C, N, P, and Si. It was demonstrated that timing and frequency of vegetation cutting has an important effect on the capacity and rate of species' recovery and therefore on the efficiency of the applied management. Nutrient stoichiometry of the regrown biomass was directly affected by cutting. Caused by differences in the applied timing and frequency of the cutting, C/N and N/P ratios and BSi concentrations were highly variable. Yet, overall, there was a clear tendency towards a higher C/N ratio and BSi concentration and lower N/P ratio in biomass that recovered after cutting. This human impact on the quantity and quality of autochthonous organic matter may have knock‐on effects on the decomposers food web and mineralization process.