新型有机磷系阻燃剂的热稳定性

利用STA490C热分析仪对8种新型有机磷系阻燃剂的热失重过程进行测定和对比,结果表明磷杂螺环阻燃剂3,9-二羟基-2,4,8,10-四氧杂-3,9-二磷杂螺环[5,5]十一烷-3,9-二氧化物和苯基次膦酸类阻燃剂4-甲氧基羟甲基苯基次膦酸热稳定性较好。     

短程硝化-强化生物除磷序批式反应器处理畜禽养殖废水

畜禽养殖废水有机物水质水量变化大,有机物、氨氮与磷的浓度较高,直接排放会严重危害环境。通过构建厌氧-好氧序批式反应器（SBR）处理预酸化畜禽养殖废水,分析了不同进水负荷条件下反应器对污染物的去除性能和微生物群落结构的变化规律。结果表明：SBR反应器对高负荷进水中TN、PO^3-₄—P和COD的平均去除率可分别达到64.5%、97.5%和94.5%。反应器出现NH⁺₄—N和NO₂—N亚硝酸同时积累的短程硝化现象,这可能与高进水负荷对氨氧化菌和亚硝酸盐氧化菌的活性和种群的影响有关。与乙酸盐相比,以丙酸盐作碳源时污泥的强化生物除磷活性更高。随着进水负荷的增大,聚糖菌（GAOs）的相对丰度明显升高。四联球状菌（Tetrasphaera）为反应器中始终占优势的聚磷菌（PAOs）,对反应器除磷性能有重要贡献。在高有机负荷条件下,SBR内PAOs与GAOs之间不存在明显的底物竞争关系,系统脱氮除磷性能未受影响。     

Managing nutrient losses from rural point sources and urban environments

Nutrient loss from rural point sources and urban environments need to be minimised as part of strategies to overcome declining water quality on the Swan Coastal Plain and in the Peel-Harvey estuary in Western Australia. This paper discusses the management of nutrient losses from domestic effluent, urban stormwater runoff, domestic gardens and public open space, intensive animal industries and intensive irrigated agriculture. Measures to minimise nutrient losses from these sources are outlined, using cooperative, technological and regulatory approaches.     

关于我国精细磷化工发展的几点建议

介绍了国内外精细磷化工的生产现状，分析了我国发展磷酸盐的产品领域和市场前景，对基础产品、市场营销、技术创新、大型企业进入磷酸盐行业提出了建议。     

化学镀镍-铜-磷三元合金工艺的研究

为提高化学镀镍－磷合金镀层的性能及获得多种性能的合金镀层以拓宽其应用范围。在化学镀镍－磷合金液中加入硫酸铜制得镍－铜－磷三元合金。研究了镀液中硫酸镍、次磷酸钠、柠檬酸钠、硫酸铜、稳定剂、光亮剂的含量以及pH值和温度等因素对合金镀层的外观、沉积速度及铜含量的影响。通过5％氯化钠溶液和10％硫酸溶液浸泡试验比较了所得镍－铜－磷合金镀层与镍－磷合金镀层以及前人制得的镍－磷合金镀层的耐蚀性，同时比较了上述镀层的其它性能。结果表明，所得镍－铜－磷合金镀层的耐蚀性、外观、结合力、孔隙率、沉积速度、硬度和耐磨性等性能优于镍－磷合金及前人制得的镍－铜－磷合金镀层。     

水体总磷测定方法的改进

采用过氧化氢消解水样，测定水中总磷的含量，春精密度为1.0%，回收率为96.8%-99.1%之间，此方法操作简单，稳定，准确，快速。     

Preparation of epoxy–clay nanocomposite and investigation on its anti-corrosive behavior in epoxy coating

An epoxy–clay nanocomposite was synthesized using a quaternary ammonium-modified montmorillonite clay and diglycidyl ether of bisphenol A (DGEBA) type epoxy resin, in order to produce anti-corrosive epoxy coating. Anti-corrosive properties of the nanocomposite were investigated using salt spray and electrochemical impedance spectroscopy (EIS) methods. The results showed an improvement in the barrier and anti-corrosive characteristics of epoxy-based nanocomposite coating and a decrease in water uptake in comparison with pure epoxy coating. Wide-angle X-ray diffraction (WAXD) patterns and transmission electron microscopy (TEM) analysis showed that the interlayer spacing of clays increased after addition of epoxy resin along with applying shear force and ultrasound sonicator. The best performance of this coating was achieved at 3 and 5 wt.% clay concentration.     

A2O工艺缺氧生物磷去除

A lab-scale anaerobic-anoxic-oxic （A^2O） process used to treat a synthetic brewage wastewater was investigated. The objectives of the study were to identify the existence of denitrifying phosphorus removing bacteria （DPB）, evaluate the contribution of DPB to biological nutrient removal and enhance the denitrifying phosphorus removal in A^2O bioreactors. Sludge analysis confirmed that the average anoxic P uptake accounted for approximately 70% the total amount of P uptake, and the ratio of anoxic P uptake rate to aerobic P uptake rate was 69%. In addition, nitrate concentration in the anoxic phase and different organic substrate introduced into the anaerobic phase had significant effect on the anoxic P uptake. Compared with conventional A^2O processes, good removal efficiencies of COD, phosphorus, ammonia and total nitrogen （92.3%, 95.5%, 96% and 79.5%, respectively） could be achieved in the anoxic P uptake system, and aeration energy consumption was saved 25%. By controlling the nitrate recirculation flow in the anoxic zone, anoxic P uptake could be enhanced, which solved the competition for organic substrates among poly-P organisms and denitrifiers successfully under the COD limiting conditions. Therefore, in wastewater treatment plants the control system should be applied according to the practical situation to optimize the operation.     

PET共聚阻燃改性研究进展

该文综述了近年来聚对苯二甲酸乙二醇酯(PET)以共聚改性方式制备高性能阻燃PET的最新研究进展,主要从磷系共聚阻燃、高温交联、高温重排、高温离子聚集和高温端基捕获链扩展5个方面对阻燃改性PET的阻燃机理和阻燃性能进行阐述,并总结了不同阻燃共聚改性方法的特点,对未来PET共聚阻燃的研究方向提出展望.     

Synthesis and metal uptake studies on poly(8‐hydroxy‐5‐azoquinolinephenylacrylate‐formaldehyde) resin and its metal complexes

8‐hydroxy‐5‐azoquinolinephenylacrylate‐formaldehyde (8H5AQPA‐F) macromonomer was prepared from acryloylchloride, with condensation products of 8‐hydroxy‐5‐azoquinolinephenol‐formaldehyde, and polymerized in DMF at 70°C using benzoyl peroxide as free radical initiator. Poly(8H5AQPA‐F) was characterized by infrared and nuclear magnetic resonance spectroscopic techniques. Polychelates were obtained in alkaline solution of polymeric ligand, with the aqueous solution of Cu(II) and Ni(II). Elemental analysis of polychelates suggests that the metal to ligand ratio is about 1:2. The polymer metal complexes were also characterized by IR, XRD, magnetic moments, and thermal analysis. The effects of pH and electrolyte on the metal uptake behavior of the resin were also studied. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 797–802, 2007