全文获取类型
收费全文 | 1053篇 |
免费 | 57篇 |
国内免费 | 31篇 |
专业分类
电工技术 | 18篇 |
综合类 | 90篇 |
化学工业 | 464篇 |
金属工艺 | 41篇 |
机械仪表 | 6篇 |
建筑科学 | 106篇 |
矿业工程 | 69篇 |
能源动力 | 14篇 |
轻工业 | 111篇 |
水利工程 | 15篇 |
石油天然气 | 38篇 |
无线电 | 1篇 |
一般工业技术 | 57篇 |
冶金工业 | 96篇 |
原子能技术 | 10篇 |
自动化技术 | 5篇 |
出版年
2024年 | 2篇 |
2023年 | 3篇 |
2022年 | 8篇 |
2021年 | 11篇 |
2020年 | 9篇 |
2019年 | 10篇 |
2018年 | 11篇 |
2017年 | 16篇 |
2016年 | 25篇 |
2015年 | 18篇 |
2014年 | 46篇 |
2013年 | 55篇 |
2012年 | 61篇 |
2011年 | 72篇 |
2010年 | 62篇 |
2009年 | 60篇 |
2008年 | 52篇 |
2007年 | 56篇 |
2006年 | 68篇 |
2005年 | 59篇 |
2004年 | 47篇 |
2003年 | 47篇 |
2002年 | 38篇 |
2001年 | 31篇 |
2000年 | 40篇 |
1999年 | 32篇 |
1998年 | 36篇 |
1997年 | 27篇 |
1996年 | 18篇 |
1995年 | 15篇 |
1994年 | 17篇 |
1993年 | 14篇 |
1992年 | 12篇 |
1991年 | 9篇 |
1990年 | 7篇 |
1989年 | 5篇 |
1988年 | 9篇 |
1987年 | 9篇 |
1986年 | 4篇 |
1985年 | 8篇 |
1984年 | 2篇 |
1983年 | 1篇 |
1982年 | 2篇 |
1981年 | 1篇 |
1979年 | 2篇 |
1977年 | 1篇 |
1976年 | 1篇 |
1975年 | 1篇 |
1964年 | 1篇 |
排序方式: 共有1141条查询结果,搜索用时 31 毫秒
41.
为研究单次降温条件下不同压实度、含水率、含盐量对宁夏地区硫酸盐渍土盐冻胀的影响,进行了室内配置试样试验。结果表明:在单次降温条件下,该地区硫酸盐渍土的起胀温度随含盐量增加而增大。随着温度变化,盐冻胀过程表现为4个阶段:35 ℃~ 5 ℃之间属于纯盐胀阶段,5 ℃~-5 ℃之间属于调整阶段,-5 ℃~-10 ℃之间属于盐冻胀阶段,-10 ℃~-25 ℃之间属于稳定阶段。当压实度较低、且含盐量在2%以内时,盐冻胀率随含盐量增加有所增大;当含盐量超过2%后,盐冻胀率随含盐量增加呈先增大后减小发展趋势,并在含盐量5%时达到峰值。当压实度为100%时,盐冻胀率随含盐量增加而增大。当含盐量较小时,达到最优含水率时盐冻胀率较大;而随含盐量逐渐增大,盐冻胀率随含水率增加呈先减小后增大变化趋势。总体来看,压实度越高、含盐量越大、越接近土体最优含水量时,盐冻胀率也越大。该研究可为硫酸盐渍土地区的工程建设提供参考。 相似文献
42.
采用1.0%,1.5%和2.0%预加拉伸应变,使养护7,28d龄期的高延性纤维增强水泥基复合材料(ECC)试件产生裂缝,研究其在经历10,20和30次硫酸盐-干湿循环后的裂缝特性、自愈合后的拉伸性能及自愈合产物.结果表明:带裂缝试件在经历不同循环次数后均表现出了良好的自愈合效果,残余裂缝的最大宽度和数量明显减少;养护7d试件经历10次循环后的残余裂缝最大宽度由愈合前的80μm降至25μm,养护28d试件经历30次循环后的残余裂缝最大宽度由愈合前的100μm降至50μm;67%以上带裂缝试件自愈合后的单轴拉伸应变能力接近甚至超过同样经历的对比用无裂缝空白试件;养护7d试件自愈合后的最终应力可分别恢复至75%以上,养护28d试件可恢复至131%以上;层状结构的CaCO_3晶体是ECC试件的主要自愈合产物. 相似文献
43.
Treatment of Acid Leachate from Coal Discard using Calcium Carbonate and Biological Sulphate Removal
J.?P.?MareeEmail author G.?Strobos H.?Greben E.?Netshidaulu E.?Steyn A.?Christie P.?Günther F.?B.?Waanders 《Mine Water and the Environment》2004,23(3):144-151
Abstract.
An integrated approach is proposed for treating acidic coal discard leachate, consisting of CaCO3 handling and dosing, CaCO3-neutralization, and biological sulphate removal. It was found that: powdered CaCO3 can be slurried to a constant density and used to neutralize the acid water, remove Fe (II), Fe (III), and Al, and partially remove the sulphate (to saturation level); biological sulphate removal can be used to lower the sulphate to less than 200 mg/L using ethanol as the carbon and energy source; CO2 produced during calcium carbonate treatment can be used for H2S-stripping and; H2S gas recovered in the sulphate removal stage can be used for iron removal. 相似文献
44.
氨-异丙醇溶液中磷石膏制备硫酸钾新工艺 总被引:2,自引:1,他引:2
针对氨溶液中磷石膏制备硫酸钾工艺存在的问题 ,考察了甲醇、氨 甲醇等溶剂对反应过程氧化钾收率的影响 ,筛选出氨 异丙醇作为适宜的添加溶剂 ,并对氨 异丙醇溶液中磷石膏直接制备硫酸钾的工艺进行了研究 相似文献
45.
本文主要介绍了硫酸盐形态硫的选矿脱除方法,通过反浮选可以把铁精矿的硫含量降到0.13%,硫的脱除率为93.43%。 相似文献
46.
The influence of different types of iron salts (i.e., ferrous or ferric cations with sulphate, nitrate or chloride anions) on the reaction between coarse thermomechanical pulp and acid hydrogen peroxide (Fenton chemistry) was studied when the initial pH was 3.2 and 5.3. Also, ferric ions chelated with EDTA or EDG at different molar ratios were compared with ferrous sulphate when the initial pH was extended from about 3 to 8. Different anions of ferric ion salt gave a similar catalytic effect. At an initial pH of 7–8, the ferric-EDTA catalyzed reaction resulted in similar or higher hydrogen peroxide consumption and more detectable hydroxyl radicals than the ferrous sulphate catalyzed reaction, but less reaction with the pulp was indicated. Between pH 5–8, using Fe-EDG as a catalyst gave higher hydrogen peroxide consumption and more detectable hydroxyl radicals than if using ferrous sulphate; however, the measured effect on the pulp was similar or less. 相似文献
47.
48.
49.
本文针对高铁低镍硫酸亚铁溶液中镍铁分离困难的生产实际,采用离子交换技术对硫酸亚铁溶液中的镍铁分离进行了研究。通过条件实验考察了树脂装填量、吸附前液pH值、吸附时间、镍离子浓度等对镍铁分离效果的影响。结果表明,CH-90树脂对含镍硫酸亚铁溶液中镍有明显的优先选择性,树脂对镍的工作交换容量为15 mg/g。经过离子交换树脂处理,溶液中的铁镍摩尔比由处理前的17:1最高可以提高到93:1,镍去除率达到87%,处理后溶液含镍小于0.3 g/L,具有良好的分离效果。改变初始浓度和吸附反应时间,探究了树脂的吸附等温线和吸附动力学过程,发现树脂符合Langmuir吸附和准二级动力学方程,说明吸附属于单分子层吸附和定点吸附,吸附过程主要是离子交换控制的。 相似文献
50.