空爆毁伤地面机动目标扫描准则研究

文中主要针对多爆炸成型弹丸空爆战斗部,在分析区域识别和占空比识别两种不同扫描准则的基础上,应用蒙特卡洛方法计算了战斗部对目标的毁伤概率.通过仿真计算结果对比分析,获得了不同扫描准则对毁伤概率的影响,结果可为多爆炸成型弹丸空爆战斗部设计和选择使用扫描准则提供参考依据.     

Analytic computation of the photocurrent density in a n-6H-SiC/p-Si/n-Si/p-Si0.8Ge0.2 multilayer solar cell

In this work we conceived a model of a multilayer solar cell composed by four layers of opposite conductivities: an n-type 6H-SiC used as a frontal layer to absorb high energy photons (energy gap equals 2.9 eV), a p-type Si layer, an n-type Si layer and a p-type SiGe back layer to absorb low energy photons (Si_0.8Ge_0.2 with an energy gap equal to 0.8 eV). The impurity concentration in every layer of the model is taken equal to 10¹⁷ cm⁻³ to ensure abrupt junctions inside the cell. The optical properties of the separate layers have been fitted and tabulated to be used for thin films devices numerical simulation. We developed the equations giving the minority carrier concentration and the photocurrent density in each abscissa of the model. We used Matlab software to simulate and optimize the layers thicknesses to achieve the maximum photocurrent generated under AM0 solar spectrum. The results of simulation showed that the optimized structure could deliver, assuming 10⁵ cm/s surface recombination velocity, a photocurrent density of more than 53 mA/cm², which represents 88.3% of the ideal photocurrent (59.99 mA/cm²) that can be generated under AM0 solar spectrum.     

在役油气管道安全评定软件

PSAforWindows是运行在Windows系统下的油气管道安全评定软件。该软件既可以用于在开挖中发现的管道局部缺陷的剩余强度的精确评定 ,又可以用于腐蚀检测之后对管道全线的安全评定与剩余寿命预测。软件中采用了非线性有限元分析、失效评定图和概率性的评定方法等最新成果。介绍该软件的结构、模块、软件特点、主要功能和操作界面     

UO2-Gd2O3芯块密度的影响因素研究

对UO2-Cd2O3可燃毒物芯块密度的影响因素进行了详细研究。试验表明：烧结时间、烧结温度、生坯密度、Gadox（含Gd的U3O8）、A．O（草酸铵）等条件与UO2-Gd2O3芯块密度存在一定关系。     

Morphology development in polyethylene/polystyrene blends: the influence of processing conditions and interfacial modification

The influence of processing conditions and interfacial modification on the morphology evolution and the composition range within which fully co‐continuous high density polyethylene/polystyrene blend structures can exist during blending in a single screw extruder was studied. Blends ranging from pure A to pure B component, with and without compatibilizer, were prepared under two different shear rates. It was found that high shear rates displaced the breakdown–coalescence balance of the dispersed nodules to the side of coalescence, narrowing the percolation domain and the critical composition for full co‐continuity decreased with increasing shear rates. The addition of a tri‐block compatibilizer induced the percolation threshold of the polystyrene phase to begin at lower percentages of polyethylene but the phase inversion point did not change. The experimental results are discussed in the light of various theoretical models. Copyright © 2005 Society of Chemical Industry     

一种控制盐层段井眼闭合率的钻井液密度新公式

针对钻井过程中钻遇的盐层段井眼蠕变缩径问题,利用弹塑性力学理论,蠕变本构方程采用Heard蠕变方程,在平面应变和均匀地应力假设下,推导出控制井眼收缩的钻井液密度新公式,该公式与前人推导的公式不同。通过理论分析,指出产生差异的根本原因在于蠕变应力差(极坐标下表示的径向应力与切向应力之差)公式的推导上,用有限元法计算结果对理论公式进行检验,证明是可行的。对文中的力学模型采用有限元法建模、求解,利用求解结果对各应力差公式进行验证,得出:根据文中公式计算结果与有限元法计算结果完全一致,而据前人公式计算结果偏离有限元计算值较大,从而间接证明了该钻井液密度新公式的推导更严密,更准确。     

高频MnZn功率铁氧体烧结工艺研究

按照氧化物陶瓷工艺对高频MnZn功率铁氧体烧结工艺条件进行了研究。烧结温度越高，晶粒越大，晶界越薄，电阻率越低，磁芯损耗越大，起始磁导率和烧结密度分别在1240℃和1230℃达到最大值。延长保温时间，可以使晶粒充分生长，晶界变薄，电阻率减小，损耗增大。保温3h后，起始磁导率和烧结密度均可达到最大值。氧分压越低，材料起始磁导率越高，电阻率越小，损耗越大，但氧分压低于5％后烧结密度不再继续增加。     

Estimation of Load Capacity of Pipe Piles in Sand Based on Cone Penetration Test Results

Pipe piles can be classified as either closed- or open-ended piles. In the present paper, the load capacity of both closed- and open-ended piles is related to cone penetration resistance qc through an experimental program using calibration chamber model pile load tests and field pile load tests. A total of 36 calibration chamber pile load tests and two full-scale field pile load tests were analyzed. All the test piles were instrumented for separate measurement of each component of pile load capacity. Based on the test results, the normalized base resistance qb/qc was obtained as a function of the relative density DR for closed-ended piles, and of both the relative density DR and the incremental filling ratio (IFR) for open-ended piles. A relationship between the IFR and the relative density DR is proposed as a function of the pile diameter and driving depth. The relationship between IFR and DR allows the estimation of IFR and thus of the pile load capacity of open-ended piles at the design stage, before pile driving operations.     

浅谈开关电源中的平面变压器

与传统变压器相比较,使用平面变压器可以提高开关电源的功率密度,减小开关电源中磁性元件的体积。因此,近年来平面变压器被广泛地研究。文章介绍了平面变压器的结构,将平面变压器与传统变压器进行比较,分析综述了平面变压器在当今开关电源发展应用的优势和前景,并进一步说明了平面变压器中绕组间距选择,绕组交叉技术及PCB绕组设计等要点。     

Preparation,structural elucidation,molecular weight determination,and molecular recognition of first‐ and second‐tier dendrimer molecules

1,3,5‐Triglyceratetriazine [first tier (G₁)] and tri(1,3,5‐triglycerate) triazine [second tier (G₂)] dendrimers were prepared with 1,3,5‐trichlorotriazine and sodium glycerate in a 1 : 3 mass ratio in an ethanolic medium.G₁ and G₂ were amorphous, white, solid substances. Their structures were elucidated with IR, ¹H‐NMR, and ¹³C‐NMR, and their thermal stability was studied with thermogravimetric analysis. The activation energy was calculated with the Freeman–Carroll model. Densities, viscosities, and surface tensions for 0.01–0.08 mol/kg aqueous solutions increased at 0.01 mol/kg for sodium glycerate, 1,3,5‐trichlorotriazine, 1,3,5‐triazine triglycerate chloride, G₁, and G₂. These values were measured at 298.15 K. The apparent molal volume, reduced viscosity, and inherent viscosity were calculated from the densities and viscosities, respectively. The data were regressed for the limiting densities, limiting apparent molal volumes, intrinsic viscosities, limiting inherent viscosities, and limiting surface tensions for solute–solvent interactions. The positive limiting apparent molal volume values were noted in the order of G₂ > 1,3,5‐triazine triglycerate chloride > G₁ > 1,3,5‐trichlorotriazine > sodium glycerate, with weaker hydrophilic intermolecular interactions of G₂. The higher intrinsic viscosity and limiting inherent viscosity values for G₂ implied stronger G₂–H₂O hydrophilic interactions, and the higher limiting apparent molal volume of G₂ indicated slightly higher dynamic conformational changes in comparison with G₁, with stronger structural activities. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008