连续双向联想记忆模型的稳定性分析

对于连续型Ｈｏｐｆｉｅｌｄ模型的平衡态特征，目前人们已经得到了很多富有意义的成果，本文说明，连续Ｈｏｐｆｉｅｌｄ模型的大部分结论都可以推广到连续双向联想记忆模型，我们重点讨论了平衡态条件、渐近稳定性以及围绕一稳定平衡点的吸引域等问题，所得到的结论对于ＢＡＭ的设计和应用都是很有意义的。     

恢复地层剥蚀厚度方法综述

恢复地层剥蚀厚度是对盆地进行定量研究的重要基础工作。本文综述、评价了目前常用的恢复剥蚀厚度的方法,并对作者曾提出的天然气平衡浓度法作了进一步的阐述。     

潦河灌区农业水费计收现状分析及对策

阐述了潦河灌区农业水费计收现状，对水费计收现状进行分析并提出解决办法。     

采用荷载平衡的概念表达预应力度及在初步设计中的应用

利用荷载平衡法的概念，将预应力度用等效荷载与外荷载的比值表达，设计可利用其比值确定预应力度，便其更简捷，明确，同时，提出了预应力度的真实值问题。     

户式中央空调发展方向的探讨

本文描述了我国户式中央空调的发展现状，分析了三种户式中央空调各自的特点，提出了把风管式机组作为我国户式中央空调的发展方向。     

丹江口工程大坝加高后的几个水力学问题

依托1∶100水工模型试验成果,重点介绍了丹江口大坝加高后的几个水力学问题如泄流能力、坝面压力特性、河床局部冲刷、下游河道流速流态、泄洪对电厂及航运的影响等.研究显示:大坝加高后泄流能力可满足设计要求,坝下河床冲刷加重,挑距加远,设计洪水22 300 m3/s时坝下冲坑最低点高程为43.0 m,各级泄量冲坑上游坡均缓于临界坡,也略缓于初期工程同级流量冲坑的上游坡;坝下600 m以内为护岸工程重点防护段,岸边流速为5.8～9.8 m/s;泄洪对丹江口电厂影响较小,对自备电站不利影响较为显著;最大通航流量6 200 m3/s时下游引航道口门区流态复杂,水流较混乱.     

Construction of a control system for disturbance rejection using a dual observer

A well‐known control system which can reduce the adverse effects of disturbances is a disturbance observer. However, in many cases of mechanical systems, system disturbances which do not satisfy the matching condition may be imposed. Therefore, it may be difficult to reduce the adverse effects of the disturbances by the traditional disturbance observer. In this paper, a method of control system synthesis for disturbance rejection using a dual observer is proposed. This method is based on the zeroing induced by the disturbance localization problem. This problem may be solved by dividing the state space into observable subspace and unobservable subspace. As compared with an H_∞ controller based on perfect observation, the usefulness of the proposed control system for disturbance rejection is demonstrated by numerical simulations for a two‐mass spring system. © 2002 Scripta Technica, Electr Eng Jpn, 138(4): 50–60, 2002; DOI 10.1002/eej.1138     

钢结构稳定设计——理论与实践

本文提出了实际工程结构的非线性理论设计和分析方法(NIDA),并以澳门回归纪念馆的设计为例,展示了本方法的优越性.在设计过程中,设计者无需假设K系数和有效长度,在结构分析完成后便可迅速完成设计,因此本文提出的方法既经济又便利.尽管对于钢框架在往复荷载及动力荷载作用下的弹塑性大位移分析已经非常成熟,但本文的方法开创了结构的非线性分析及设计的新纪元,能够对现行的设计方法理论起到巨大的推动作用.     

注聚井注入状况诊断方法研究

在室内试验和动态分析的基础上，对引起注聚井注入困难的原因进行了分析，提出了利用单井动态预测结果和实际注入动态曲线对比判断聚合物注入状况的方法，建立了预测注聚井注入动态的预测模型，并对数值模拟计算结果进行了分析。同时还评价了现场应用效果。通过数值模拟和实际注入动态曲线对比，可以初步判断待措施井有无近井地带堵塞，为提高注聚井压解堵措施的有效性奠定了基础。     

Transient Green’s Tensor for a Layered Solid Half-Space With Different Interface Conditions

Pulsed ultrasonic techniques can be and have been used to examine the interface conditions of a bonded structure. To provide a theoretical basis for such testing techniques we model the structure as a layer on top of a half-space, both of different elastic properties, with various interface bonding conditions. The exact dynamic Green’s tensor for such a structure is explicitly derived from the three-dimensional equations of motion. The final solution is a series. Each term of the series corresponds to a successive arrival of a “generalized ray” and each is a definite line integral along a fixed path which can be easily computed numerically. Willis’ method is used in the derivation. A new scheme of automatic generation of the arrivals and ray paths using combinatorial analysis, along with the summation of the corresponding products of reflection coefficients is presented. A FORTRAN code is developed for computation of the Green’s tensor when both the source and the detector are located on the top surface. The Green’s tensor is then used to simulate displacements due to pulsed ultrasonic point sources of known time waveform. Results show that the interface bonding conditions have a great influence on the transient displacements. For example, when the interface bonding conditions vary, some of the first few head waves and regular reflected rays change polarities and amplitudes. This phenomenon can be used to infer the quality of the interface bond of materials in ultrasonic nondestructive evaluation. In addition the results are useful in the study of acoustic microscopy probes, coatings, and geo-exploration.