烃类在三甘醇和四甘醇中无限稀释活度系数的测定与关联

用气相色谱法分别测定了苯、甲苯、乙苯、正庚烷、正辛烷、正壬烷和正癸烷在三甘醇和四甘醇中的无限稀释活度系数 ,测定温度范围为 5 0～ 13 0℃。用修正的UNIFAC模型 (Dortmund)对上述不同温度下的无限稀释活度系数实验数据进行关联 ,得到了三甘醇和四甘醇与其它基团的相互作用参数 ,并将计算结果与实测值进行了比较。     

含多孔物质硝胺发射药的温感特性

研究了多孔物质对于硝胺发射药在不同初温下的燃面调节作用，由于多孔物质的孔结构及其与基体界面状况的改变，使发射药低温燃面增大，而高温燃面减小，这有利于降低燃速温度系数．     

CZF90测井中子发生器使用寿命浅谈

Ｃ／Ｏ测井中采用同步测量技术来分析非弹性γ与俘获γ，但在一些ＭＳＩ Ｃ／Ｏ测井中发现非弹性γ的一小部分或一大部分超前于非弹性门而进入俘获门，我们把这一问题叫做“错位”。“错位”使得Ｃ／Ｏ的ＣＩ值不正常，测井曲线不合格。这样的仪器不能用来测井。吉林油田测井公司碳氧比维修班成功地解决了Ｃ／Ｏ仪器“错位”等技术难题，在该油田所使用的ＣＺＦ９０－９４－０９发生器已测井８８口，累计打靶时间２３０ｈ，并且至今     

Ce,Eu双掺BSO晶体光折变效应研究

在ＢＳＯ晶体中同时掺入Ｃｅ和Ｅｕ离子，生长了Ｃｅ：Ｅｕ：ＢＳＯ晶体，对晶体的二波耦合和四波混频性能了测试。结果表明，Ｃｅ和Ｅｕ离子对晶体的光折变效应起到了增强的作用。     

Critical review of available correlations for two-phase flow heat transfer of ammonia

Although ammonia has been used for decades as a refrigerant of choice for selected large- and small-scale applications, no formal database is available on heat transfer of ammonia. A critical review of the published literature on heat transfer of ammonia is provided in this paper. The available correlations for in-tube and external boiling/evaporation and condensation heat transfer of ammonia are discussed and evaluated where possible. Supported by the findings of this effort, research areas of relevance that can contribute to expanded use of ammonia as an environmentally friendly refrigerant are suggested.     

涂层材料的断裂分析(英文)

和基体厚度相比,涂层很薄,因此细观力学模型可把基体作为半无限弹性体。由于涂层和基体材料的膨胀系数及弹性系数不匹配,涂层材料中残余热应力的解析解为 E_c/(1-γ_c)·(α_s-α_c)△T。用有限元法校核,该应力和解析解吻合得好。通过对涂层产生裂纹驱动力和断裂韧性的讨论,提出了抗裂涂层厚度公式。     

Prediction of evaporation heat transfer coefficient and pressure drop of refrigerant mixtures

A study on the prediction of heat transfer coefficient (HTC) and pressure drop of refrigerant mixtures is reported. HTCs and pressure drops of prospective mixtures to replace R12 and R22 are predicted on the same cooling capacity basis. Results indicate that nucleate boiling is suppressed at qualities greater than 20.0% for all mixtures and evaporation becomes the main heat transfer mechanism. For the same capacity, some mixtures containing R32 and R152a show 8.0–10.0% increase in HTCs. Some mixtures with large volatility difference exhibit as much as 55.0% reduction compared with R12 and R22, caused by mass transfer resistance and property degradation due to mixing (32.0%) and reduced mass flow rates (23.0%). Other mixtures with moderate volatility difference exhibit 20.0–30.0% degradation due mainly to reduced mass flow rates. The overall impact of heat transfer degradation, however, is insignificant if major heat transfer resistance exists in the heat transfer fluid side (air system). If the resistance in the heat transfer fluid side is of the same order of magnitude as that on the refrigerant side (water system), considerable reduction in overall HTC of up to 20% is expected. A study of the effect of uncertainties in transport properties on heat transfer shows that transport properties of liquid affect heat transfer more than other properties. Uncertainty of 10.0% in transport properties causes a change of less than 6% in heat transfer prediction.     

Performance of absorption refrigeration cycle at maximum cooling rate

The influence of irreversibility of finite-rate heat transfer on the performance of an absorption refrigerator is investigated using an endoreversible cycle model with continuous flow. The cooling rate is adopted as an objective function for refrigerator optimization. The maximum cooling rate and the corresponding coefficient of performance are derived. The optimal performance with respect to heat transfer areas of the refrigerator is analysed. In addition, certain significant conclusions are reached.     

新型双旋流平焰烧嘴的研制与应用

介绍了一种新型双族流平焰烧嘴的设计思路、结构参数及工业试验结果。其结构特点是每个部件都易装易卸，其煤气旋流器的位置可根据煤气压力变化进行调节，无需稳焰器就可保证煤气压力在较大范围波动时，都可形成稳定的平展火焰。     

液压胀形轧辊油槽深度的确定

对液压胀形轧辊（即国外的ＶＣ轧辊）辊套热装后的弹性变形进行了有限元分析，给出了确定油槽最小深度的计算公式。本文的有限元计算结果与实验结果吻合，某些结论可为液压胀形轧辊的结构设计提供理论依据。