The Difference in Turbulent Diffusion between the Active and Passive Scalars in a Thermally Stably Stratified Medium

The difference in the turbulent diffusion between the active (heat) and passive (mass) scalars in a thermally stably stratified medium is investigated. The axisymmetric problem is treated on the formation of a turbulent circulation flow above a heated disk and on the turbulent diffusion of a passive scalar (impurity) from a continuous surface source in a stably stratified medium. The results indicate that the thermal stratification causes appreciable differences in the coefficients of turbulent transfer between the active (heat) and passive (mass) scalars. This means that the assumption of the identity of the coefficient of turbulent diffusion of heat and mass, employed in conventional models of turbulence, produces significant errors in estimating the heat and mass transfer in a thermally stably stratified medium.     

A direct numerical simulation of transition phenomena in a mixed convection channel flow

This study intends to provide an increased understanding of the laminar-turbulent transition phenomena for the buoyancy-assisted heated vertical channel flow during the early transient stage. The spectral method with weak formulation is applied in the direct numerical simulation. Initial disturbances consist of the finite-amplitude two-dimensional TS wave and a pair of three-dimensional oblique waves for the K-type disturbances. The results from the harmonic energy competitions of different wave modes show that for the buoyancy-assisted heated flow, the (k_x=1, k_z=1) or (1,1) and (1,0) modes would gain energy immediately and start to rise at almost the same rate. This phenomenon is different from that of the buoyancy-opposed flow, where the (1,1) mode decays slowly in the beginning until other modes gain enough energy and then it begins to grow quickly and overtakes the (1,0) mode after a short time period. These different transition patterns match with the experimental results that the flow transition is supercritical and subcritical for the buoyancy-assisted and -opposed flows, respectively. Buoyancy-assisted heated flow transition follows the general trend of an isothermal flow in the beginning, but the thermal-buoyant force is crucial in accelerating the instability and also causing notable differences during the subsequent transition process. All of the results for the vortex structures development, kinetic energy budget of the disturbances, flow visualization by tagged fluid particles, and the local temperature fluctuations are consistent in pointing to a clear pattern for the buoyancy-assisted heated flow transition.     

改进异步电机直接转矩控制系统的仿真研究

本文介绍了直接转矩控制系统的控制原理,并针对基于直接转矩控制的异步电动机运行时存在较大的电流及转矩脉动问题,提出一种新的控制方案,并基于Matlab 6.5对这种新方法进行仿真,仿真结果表明该方案能有效的解决电流及转矩脉动的问题.     

Gleeble 3800热模拟试验机在宝钢的典型应用与功能开发

热模拟试验可研究成分与各工艺参数对组织和性能的影响，用于指导产品设计和实际生产工艺的制定，还有助于建立数学模型。文章介绍了Gleeble 3800热／力模拟试验机在宝钢实际应用中的几个典型试验，包括高温热塑性试验、多道次变形试验、冷轧薄板相转变点试验和HAZ焊接热影响区热模拟试验等。这些试验可用来解决连铸、轧钢和冷轧产品热处理生产中存在的一些问题。     

催化重整装置的扩能改造

介绍湛江东兴炼油厂的重整装置由200kt／a扩能至300kt／a中有关催化重整反应动力学模拟计算软件的应用、反应工艺技术的改造、装置标定的情况。结合装置实际情况，采用两段装填、两段混氢技术提升了装置的技术水平。标定结果表明，改造后的装置达到了预期目的。     

基于Matlab/Simulink的机械工程控制系统仿真

通过列举一些实例 ,分析了Matlab/Simulink软件在机械工程控制系统仿真中的应用 ,能够简化编程 ,取得了很好的效果。     

Numerical solution for shape optimization of an impactor penetrating into a semi-infinite target

The shape of the impactor with the maximum depth of penetration (DOP) for a given impact velocity is found using a numerical procedure for solving a corresponding non-classical variational problem. It is shown that the optimum shape in a general case is close to a blunt cone. The variation of the optimal shape of the impactor and the dependence of the DOP vs. the initial (impact) velocity and friction coefficient is studied. The analysis is performed also for optimal conical impactors.