九江三期1号主变出厂冲击试验失败原因及处理

九江三期发电工程采用两台 4 4 5MVA主变压器 ,分别将两台 35 0MW发电机的 2 3kV出口电压升高到 2 2 0kV接入升压站。其中 1号主变压器在制造厂进行冲击试验时 ,两相高压绕组发生绝缘击穿 ,未通过冲击试验。针对该变压器的此次冲击试验造成的损坏部位及形成原因进行分析 ,找出变压器的绝缘设计和制造工艺上的缺陷 ,提出处理措施 ;另一方面通过比较此次雷电冲击电压与操作冲击电压对变压器绝缘损坏的部位的不同 ,判断这两种冲击试验对变压器不同部位绝缘检测的有效性     

二维小波变换理论在地震信号去噪中的应用

针对地震信号随机干扰和规则干扰的特点，运用二维小波变换的理论，设计了相应的变换域去噪滤波器。理论记录和实际野外记录试算表明，二维小波变换具有较强的信噪分离作用。只要运用得当就能取得满意的效果。     

一类线性M IMO 离散系统的切换控制方法

提出一种针对线性MIMO离散系统的切换控制方法．该切换控制方法不仅利用了系统输出误差，而且利用了控制器的状态变量信息，使系统具有理想的动态响应特性．算法需要较少的被控对象信息，实时计算量小．仿真结果表明了该算法的有效性。     

信息安全系统中一种高速随机序列发生器的设计与实现

对原来的真随机序列发生器进行研究和分析，指出存在的主要问题是：序列的输出速度较慢，把小波分析理论用于真随机序列发生器，改变原来的输出方式，设计一种新的高速随机序列发生器，以满足快速发展的信息安全系统的要求．     

3D Monte Carlo Analysis of Discrete Dopant Effects on Electron noise in Si Devices

A preliminary study of velocity fluctuations in simple devices using an atomistic model for the ionized impurity scattering is presented. The velocity fluctuations are responsible for thermal noise in semiconductor devices. In this paper the influence on the spectral density of velocity fluctuations of the boundary conditions, the doping level, the length of the resistors and the excess/default of impurities has been addressed.     

Analysis,simulation and verification of a bipolar current source power resonant inverter

A high‐frequency bipolar current source resonant inverter introduced in this paper has dramatic zero‐voltage‐switching (ZVS) characteristic. The analytic expressions of the resonant voltage and current are given. It indicates that the resonant waveform is composed of two parts, i.e. the oscillatory component and the stationary component. In special cases, the resonant waveform degenerates into the mono‐frequency component, as presents the graceful sinusoidal wave with very low total harmonic distortion (THD) value. Based on the closed‐form voltage and current, the component stresses on reactive elements are obtained. The impact of different component values and operating frequencies on ZVS feature is also discussed. It should be noted that the ZVS merit may be lost if the components are carelessly selected. The validity of the theoretical analysis has been proven with Pspice simulations and experimental results. Copyright © 2004 John Wiley Sons, Ltd.     

TES microcalorimeter readout via transformer

Readout configuration for Transition Edge Sensor (TES) electrically coupled to a low noise warm front-end via transformer is studied. The study was aimed at the implementation of the readout involved in imaging with microcalorimeter detector arrays using frequency multiplexing technique (Appl. Phys. Lett. 81(1) (2002) 159). A model describing both TES electrothermal reaction and the readout response is investigated. Contribution of electronic noise to TES energy resolution is calculated. Prospective readout architecture with TES electrical biasing from the warm readout side is introduced. The architecture allows building of large imaging detector arrays with TES. It is shown that an unprecedented combination of imaging and spectrometry features can be achieved with TES readout via transformer.     

阀门流场的数值模拟及流噪声的实验研究

采用非结构、非交错网格的有限体积法求解用二方程模型封闭的雷诺平均N S方程组 ,对水管路系统中 3种常见阀门的三维分离流动进行数值模拟。模拟结果表明 ,随着蝶阀、闸阀和球阀开度的减小 ,流体在蝶阀背面、球阀阀门内外分别形成两个方向相反的漩涡 ,闸阀的漩涡出现在挡板与管道的壁角处 ,并且漩涡在阀门下游逐渐消失。同时实验表明 ,阀门下游的流噪声大于阀门上游的流噪声 ,涡声是阀门噪声的主要来源     

Atmospheric effects of friction,friction noise and wear with silicon and diamond. Part II. SEM tribometry of silicon in vacuum and hydrogen

Scanning electron microscope (SEM) tribometric data on polycrystalline silicon (poly-Si) vs. poly-Si, Si(100) vs. Si(100) and Si(111) vs. Si(111) interfaces, obtained in Torr and in 0.2 Torr partial pressure of hydrogen gas ( ) from room temperature to 850^°C, were performed under standard and much slower thermal ramping rates. The friction data were analyzed per the methodology described in part I of this paper series. The results indicate a highly beneficial friction- and wear-reducing regime within a relatively narrow thermal region. This desirable region coincides with some chemisorption of excited species of molecular hydrogen just before the mass thermal desorption of surface hydrides. These data represent the tribochemical equivalent of a method routinely used in electronics, whereby deep electron traps (dangling Si bonds) are passivated by baking in molecular hydrogen. The also exerts a moderating influence on the size of the friction noise at all test temperatures. However, the general level of friction beyond the beneficial thermal region is high. In parallel, the general wear rate of Si representative of the entire range of standard thermal ramping in both atmospheric environments is in the extremely high 10^-12m³/(N m) range. Operating strictly in the beneficial, low-friction thermal regime resulted in a several orders-of-magnitude reduction in the wear rate over those measured under standard thermal ramping conditions. Although the results confirm previous findings that Si is not a good material of construction for miniaturized moving mechanical assemblies (e.g., microbearings and gears), there seems to be some limited possibility of gas-phase lubrication of Si micromechanisms with rarefied hydrogen at surface temperatures between 100 and 300^°C. This revised version was published online in July 2006 with corrections to the Cover Date.     

具有未知系统偏差的自适应Kalman平滑器

提出一种有效的具有未知系统伯差的自适应Ｋａｌｍａｎ平滑器．应用状态空间方法和ＡＲＭＡ新息模型，基于白噪声估值器和输出预报器，给出线性离散定常系统自适应最优状态和偏差联合Ｋａｌｍａｕ平滑器，最后给出仿真实例．