静态电子轨道衡组成部分解析及其合理选择

阐述静态电子轨道衡诸多优点;工作原理、允许误差及误差分配;轨道衡的结构组成部分、解析各部分的工作特性及技术指标要求;合理选配及推荐实例.     

Scanning electron microscope electron detector with a radial type discrete dynode electron multiplier

A discrete dynode electron multiplier with radial flux of electrons was built and tested in the range of low‐voltage scanning electron microscopy as a backscattered electron detector of topographic contrast. The multiplier collects backscattered electron emitted in a specific range of take‐off angles and over the whole azimuth angular range enabling large solid collection angle. Multipliers with different dynode shapes were studied theoretically with the use of the software for particle optics and three assemblies were built and tested experimentally. The gain estimation, assessment of the type of detected electrons (secondary electron or backscattered electron), imaging the spatial collection efficiency and signal‐to‐noise measurements were performed.     

A generalization of Vidyasagar's theorem on stabilizability using state detection

In this paper we generalize the Vidyasagar's well known theorem on the local stabilizability problem of nonlinear systems using state detection [11]. Our purpose is to prove that if a system is weakly detectable and stabilizable by means of a continuous state feedback u = γ(x), for which no differentiability assumption is imposed, then the system is also stabilized by the law u = γ(z), where z is the output of a weak detector for the state x. The result above is applicable to several cases not covered by other works.     

Municipal solid waste conversion to energy

In recent years it has been recognised by an increasing number of nations that there is considerable energy potential within MSW. As a result many countries have established R,D& D programmes to examine methods of exploiting this potential. The IEA's MSW Conversion Activity was set up in 1986 to provide an infrastructure for sharing information and co-ordinating work in this area internationally. This Activity was extended in 1989 and currently a total of 9 nations participate in it.

To cope with the wide scope of the area (encompassing both biological and thermal processing of MSW) the Activity was divided into three subgroups or Expert Working Groups (EWGs). Each of these dealt with a distinct area of expertise:

1. •Downstream effects of source separation and screening of MSW

2. •Sampling and analytical protocols

3. •Landfill gas

In addition to these groups a central secretariat based at Harwell (UK) has provided guidance, established and administered databases of contacts and produced a series of national reports.

This paper describes the achievements of the Activity and discusses work proposed for the future.     

Properties and Performance of Cation-Doped Ceria Electrolyte Materials in Solid Oxide Fuel Cell Applications

Cation-doped CeO₂ electrolyte has been evaluated in single-cell and short-stack tests in solid oxide fuel cell environments and applications. These results, along with conductivity measurements, indicate that an ionic transference number of ∼0.75 can be expected at 800°C. Single cells have shown a power density >350 mW/cm². Multicell stacks have demonstrated a peak performance of >100 mW/cm² at 700°C using metallic separators.     

各种状态的液体通过核孔膜的规律

介绍了液体通过核孔膜规律方面取得的新认识，包括：（１）纯净液体通过核孔膜的规律；（２）核孔膜测定液体粘滞系数的各种方法；（３）各种物质溶液浓度的核孔膜测定；（４）液相混合物快速分离和化学分离；（５）流体中固体微粒对核孔膜的堵塞及其公式；（６）用核孔膜滤除液中各各斩规律。     

用于重离子核反应实验测量的纵向电场气体电离室

本文报道了一种新型的大动态范围，多叠层探测器系统组件之一的纵向电场气体电离室的构造，性能和在中能得离子核反应实验中的应用。     

Nuclear Magnetic Resonance Studies of Silicon Carbide Polytypes

The ²⁹Si MAS NMR spectra of the 2H, 4H, 6H, and 3C polytypes of silicon carbide are presented. An attempt is made to correlate differences in the chemical shifts with local atomic environment. The results of the analysis of the spectra of pure polytypes are used as a basic for the interpretation of the spectra of mixed polytypes and a discussion of the crystallinity and impurity levels of different samples. Carbon-13 chemical shifts obtained from spectra of the same polytypes are also tabulated.     

Time‐dependent heat transfer coefficient of a wall

A time‐dependent coefficient of heat transfer is proposed for the computation of thermal power required, so that a room temperature reaches a desired value within a given time. A mathematical formulation of the room heating transient phenomenon is constructed in a dimensionless form. Using an integral approximate solution an analytical expression for this coefficient is provided and it is verified by diagrams adopted by DIN 4701. Copyright © 2003 John Wiley & Sons, Ltd.     

Synthesis of p‐aminophenol from the hydrogenation of nitrobenzene over metal–solid acid bifunctional catalyst

BACKGROUND: A single‐step conversion of nitrobenzene (NB) to p‐aminophenol (PAP) through catalytic hydrogenation is a widely used synthesis route for PAP. The main shortcoming of this route is the use of sulfuric acid for rearrangement of the phenylhydroxylamine (PHA) intermediate. In this paper, S₂O₈^2?/ZrO₂ (PSZ) solid acid and Pt‐S₂O₈^2?/ZrO₂ (Pt‐PSZ) bifunctional catalysts were prepared for the synthesis of PAP in non‐acid medium. RESULTS: Calcination temperature has a substantial effect on the acidity, structure and activity for PHA rearrangement of PSZ. The highest PAP yield was 33.8% over PSZ calcined at 823 K when the reaction was carried out in water at 423 K. A high PAP yield of 23.9% was achieved by a single‐step reaction of nitrobenzene over Pt‐PSZ bifunctional catalysts. CONCLUSION: PSZ solid acid exhibits high activity for PHA rearrangement. Perfect tetragonal ZrO₂ and much stronger acid sites play important roles in catalytic activity. Inhibiting the hydrogenation activity by reducing the amount of Pt loading on Pt‐PSZ can improve the competition of PHA rearrangement on acid sites with hydrogenation of PHA on metal active sites, resulting in better selectivity to PAP. Copyright © 2008 Society of Chemical Industry