稠油微生物开采技术现状及进展

综述了用微生物方法开采稠油的技术现状与进展，论题如下。①概述。②基本方法：异源微生物采油，包括微生物吞吐和微生物驱；本源微生物采油压大港孔店油田的实例。③主要机理，包括产表面活性剂，降解稠油中重质组分及其他。④技术研究，包括机理性、可行性及经济效益研究，列举了国内外6个实例。⑤现场应用，包括国外1个、国内6个实例。⑥该技术的优势及问题。参22。     

低价的市场竞争心理必须改变

概述了中国PCB产品必须走出低价的市场竞争的困境,坚决走自主创新来发展中国PCB工业的道路。     

Oligo(ethylene oxide) side‐chain steric screening effects on conductimetric properties of grafted poly(4‐vinylpyridinium) salts in aqueous solutions

A set of poly[N‐oligo(ethylene oxide)yl 4‐vinylpyridinium tosylate] (P4VOEOOTs) has been prepared by spontaneous polymerization of 4‐vinylpyridine. This method gives a grafted polyelectrolyte having a positive charge on every backbone pyridinic moiety. The P4VP15Ts, P4VP164Ts, P4VP350Ts and P4VP750Ts aqueous solution conductivities were determined in the concentration range from 6 × 10^?4 to 10^?2 M at 25 °C. The variation of the conductivity versus concentration of the investigated system exhibits typical polyelectrolyte behaviour. The polyelectrolyte mobility was found to be dependent on the oligo(ethylene oxide) (OEO) side‐chain length. Manning's rod‐like model fails to describe these results. A simple steric effect is proposed to explain the influence of the OEO length. Copyright © 2003 Society of Chemical Industry     

质量控制图系统的实现及在SMT中的应用

本文将控制图理论与计算机技术相结合,开发了质量控制图系统.介绍了该系统的设计方案和关键技术问题,并以电子产品制造中监控SMT机的焊膏厚度为例说明了系统的应用.     

电子产品研制阶段可靠性增长试验研究

结合工程实际经验,深入讨论了可靠性增长过程及实现途径,在保持试验条件和改进过程不变的条件下,实施了对具体型号电子产品的可靠性增长试验,达到了预期的可靠性增长目标,并且利用可靠性增长试验的数学模型(AMSAA模型)来评估产品的可靠性增长,对开展可靠性增长与可靠性增长试验工作具有重要的实际意义.     

油品质量检验工作中应注意的十个问题

介绍了油品质检员做好油品检验工作在具体操作试验中应注意的十个问题，以确保试验数据真实有效，结论准确。     

Synthesis and photosensitivity of acryloylmorpholine copolymers with a pendant (meth)acryloyl group

We have developed new photopolymers that have superior waterproof properties and that can easily interact with polyfunctional acrylate compounds, thus serving as hydrophobic photocrosslinking reagents. Acryloylmorpholine monomers whose homopolymers were less moisture absorbing than the usual water‐soluble polymers but were still water soluble to a good degree, were copolymerized with other acryloyl monomers. We then introduced the photosensitive (meth)acryloyl group to side chains of the resulting polymers. Among six copolymers examined, the copolymers composed of acryloyl morpholine, hydroxyethyl acrylate, ethyl, or methyl methacrylate, and methacryloyl isocyanate were found to have nicely balanced hydrophilicity and waterproof properties, in addition to good compatibility with hydrophobic photocrosslinking reagents. The composite polymers thus obtained were confirmed to be promising photopolymers usable even in a highly humid environment. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 684–692, 2003     

砂岩酸化中水化硅沉淀的影响因素分析

讨论了砂岩酸化中产生水化硅沉淀的反应机理。使高岭土与1.0%HF和多种配比的HCl HF在不同温度(20-90℃)反应不同时间(10-300分钟),用等离子吸收光谱法(ICP)测定酸液中可溶性硅的浓度(mg/L),取某时段测定值的减小量为该时段水化硅沉淀生成量,讨论了多种因素的影响,得到了如下结果和结论。反应温度越高,则高岭土与HF之间的反应越快,形成水化硅沉淀的时间越短,最终生成的沉淀量越大;在HF中加入HCl(使用土酸体系)、减小土酸中HF质量分数、加大土酸中HCl、HF质量分数比,均可使生成沉淀时间延后,使最终生成沉淀量减少。60℃时300分钟沉淀量,在1.0%HF、5.0%HCl 1.0%HF、9.0%HCl 1.0%HF中分别为482、321、201mg/L。提出了在酸化设计与施工中可以采取的6条简便易行的减少水化硅沉淀量的措施。图4表1参6。     

莲心中可溶性成分的有效提取

采用不同的原料处理,改变提取的流程和提取时间，测定不同条件下所得提取液的可见吸收光谱，以此反映各提取液的组分和浓度是否发生变化，并比较在最大吸收波长下各提取液的吸光度大小，从而确定将莲心捣碎后，加热回流时间为60min的提取方法效果最佳。     

水溶性油墨用富马酸改性松香树脂的研制

介绍了一种水溶性富马酸改性松香树脂的制备方法 ,选取了较佳的工艺条件 ,本产品经国内几家油墨厂使用 ,结果表明适合水溶性油墨的应用要求