无线电引信被干扰率及抗干扰率

本文从无线电引信相对杀伤比率出发，引伸出引信被干扰率及抗干扰率的定义及计算公式。     

C／O测井响应随源距变化的理论研究

针对井内介质分别为水、油，地层分别为３５％孔隙度饱和水砂和油砂的４种情况，采用蒙特卡罗方法模拟外径φ８９碳氧比测井仪不同源距处的非弹性散射伽马能谱。通过分析地层或井内介质不同时的Ｃ／Ｏ差值随源距变化的关系，为设计仪器推荐源距参数。     

GH2027铁基高温合金的第二相研究

运用电子显微分析和波谱分析等方法对ＧＨ２０２７合金的第二相进行了研究，结果表明，合金晶界相主要是片状Ｍ６Ｃ和薄膜状Ｍ２３Ｃ６，经波纹图样测得其错配度约为３％，晶内Ｍ６Ｃ和Ｍ２３     

混凝土受拉断裂的破坏机理

本文从试验现象出发,建立了以数理统计为基础的混凝土受拉全过程曲线方程。研究表明,混凝土受拉应力应变全曲线是混凝土试件内部的粘结界面与水泥胶合物在外拉力作用下逐步断裂造成的。文章所建立的方法不仅可以解释许多试验现象,模拟混凝土受拉全曲线,而且还可以得出试验中难以测出的结果。     

f—x域内提高地震资料的信噪比

在 f-x 域,地震记录可以表示成有限个调频调幅正弦波的叠合,叠合的结果是一个连续且光滑的函数。我们可以用一个简单的 n 次多项式去逼近这个函数。本文提出了一种在 f-x 域用最小平方拟合原理消除随机噪声的新方法,并证明了在噪声为自噪以及空间采样足够密的条件下,拟合结果与噪声无关,即 f-x 域最小平方拟合处理可以有效地消除记录上的随机白噪,而对有效信号的破坏甚微。由于理论上允许振幅值及同相轴形态在空间上发生变化,因而该方法不具有混波作用,是高分辨率处理的理想工具。     

光孤子相互作用对压缩态的影响

在线性近似条件下，量子化了非线性薛定谔方程，用后向传播法数值求解了光孤子相互作用对压缩比的影响。数值结果表明，在碰撞距离附近，压缩比显著增加。     

高效防气防砂一体化管柱的研制与应用

为解决文南油田高气液比井出砂易造成卡泵的问题,研制了高效防气防砂一体化管柱。该管柱主要由闭式气锚、重力式防气装置和激光割缝筛管3部分组成。闭式气锚的分离作用消除了气体对抽油泵的影响,提高了泵效;重力防气装置利用液气分离原理和高烟囱原理进行液气分离,液流回流时间可达10min,排气最高压差可达0.2MPa;经激光割缝筛管过滤后的液体含砂粒外径小于0.05mm。该管柱在文南油田现场应用16井次,累计增液6000t,增油2717t,平均单井泵效提高7%。     

用试井方法确定注水后地层渗透率的变化

大港油田已进入开发中后期，高含水油田占73％，开发初期的一些参数已不适合现在开发的需要。研究出一套用试井方法确定注水以后地层渗透率变化的方法，对大港油田的增储上产具有重要意义。     

On the hollowness ratio effect on the dynamics of a spinning Rayleigh beam

The analytical solutions of a spinning Rayleigh beam with rotatory moment inertia and gyroscopic effect are presented in this paper. The critical speeds can be written analytically in a function of the length-to-radius ratio (l) defined by the beam's length over its outer radius and the hollowness ratio (α) defined by the hollow area over the total area of the cross section. The sensitivity analyses show that the critical speed is decreasing with l, but increasing with α. Moreover, α is more sensitive to the critical speeds. The design of a spinning beam should therefore be emphasized more on the hollowness factor. Contrary to common belief, only finite critical speeds exist and the number is independent of the boundary conditions. It increases monotonically with l, but decreases with α. The steady state unbalanced response can therefore be expressed analytically by the finite precessional modes and the corresponding generalized coordinates.     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry