高温下 CaS氧化反应特性的实验研究

采用热重等温实验研究了970～1150℃内CaS的氧化反应特性,利用红外光谱仪定量分析反应析出SO2气体,通过亚甲基蓝分光光度法测定固体残留物中CaS的含量.实验研究发现,在970～1150℃内,反应呈先失重后增重趋势,固体残留物中都检测出少量CaS的存在.随温度升高,残留固体样品中CaSO4的质量百分比下降,而CaO的质量百分比上升,SO2析出速率急剧增大,1150℃下SO2的析出速率比970℃下的析出速率高了一个数量级.随O2浓度增大,残留固体样品中CaSO4的质量百分比和SO2析出速率轻微上升.降低反应温度和增大O2浓度,有利于提高CaS氧化生成CaSO4的比例.     

Synthesis of well-defined poly(styrene)-b-poly(p-tert-butoxystyrene) multiblock copolymer from poly(alkoxyamine) macroinitiator

The stepwise insertion reaction of styrene (St) and p-tert-butoxystyrene (BOSt) into poly(alkoxyamine) macroinitiator was carried out to provide well-defined poly(St)-b-poly(BOSt) multiblock copolymers. Structural confirmation of the multiblock copolymers was accomplished by NMR and IR measurements. The model reaction also supported that the monomer insertion into the macroinitiator proceeded in accordance with a living fashion.     

The partition coefficients of ethylene between hydrate and vapor for methane + ethylene + water and methane + ethylene + SDS + water systems

The hydrate formation of CH₄+C₂H₄ mixture was studied experimentally in two different cases, with and without the presence of sodium dodecyl sulfate (SDS) in water. The results manifested that the presence of SDS could not only accelerate the hydrate formation process, but also increase the partition coefficient of ethylene between hydrate and vapor drastically. The partition coefficients of ethylene between hydrate and vapor for methane + ethylene + water with the presence of 500 ppm SDS in water were then systematically measured. The experimental temperature ranged from 273.15 to 278.15 K, the pressure ranged from 2.5 to 5.5 MPa, the initial gas-liquid volume ratio ranged from 95 to 240 standard volumes of gas per volume of liquid, and the mole percentage of ethylene in feed gas mixture ranged from 5.28% to 79.36%. The results demonstrated that ethylene could be enriched in hydrate phase and partition coefficients were increased with the presence of SDS in water. This conclusion is of industrial significance; it implies that it is feasible to recover ethylene from gas mixture, e.g., various kinds of refinery gases or cracking gases in ethylene plant, by forming hydrate.     

Kinetic study of radical polymerization. II. Solid‐state bulk polymerization of sodium methacrylate by differential scanning calorimetry

The solid‐state radical polymerization of sodium methacrylate was investigated. It was initiated by azobisisobutyronitrile, which was used as a radical initiator. Differential scanning calorimetry (DSC) was used to observe the endothermic and exothermic transitions during the polymerization reaction. Structural studies were performed with the DSC thermograms and Fourier transform infrared and ultraviolet–visible spectra, and all of the results confirmed the progress of the reaction. The obtained data revealed that the polymerization reaction proceeded completely with a 100% conversion. ΔH of this reaction was calculated with various amounts of the initiator, and the peak temperatures were determined at different heating rates. The activation energy (19.7 kcal mol^?1) was also obtained by the Kissinger method for this type of solid polymerization reaction. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1648–1654, 2003     

Synthesis of copolymers of tert‐butyl vinyl ether with maleic and citraconic anhydrides

In the present study, the effects of charge‐transfer complex formation and intramolecular fragmentation (side‐chain lactonization) in radical copolymerization of tert‐butyl vinyl ether (t‐BVE) with anhydrides of maleic (MA) and citraconic (CA) acids and the structure–thermal behavior relationships of the resulting copolymers were examined using the ¹H‐NMR, FTIR, DSC, and TGA analysis methods. It was shown that copolymerization under the chosen conditions proceeded through intramolecular fragmentation with the formation of γ‐lactone units. Side‐chain fragmentation of t‐BVE–MA and t‐BVE–CA copolymers also was confirmed by TGA and DSC analysis. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 2455–2463, 2006 2006     

银杏叶中有效成分的提取及其应用

研究了银杏叶中黄酮类抗氧化成分的提取工艺，并对黄酮类物质清除自由基和抗氧化性能进行了探讨。结果表明：用质量分数70％乙醇回流提取银杏叶，65℃时黄酮的质量浓度高达0．0625μg/mL。黄酮类物质有很强的清除自由基能力和抗氧化能力，随着黄酮浓度的增加，溶液的吸光度逐渐减小，即对．OH的清除率逐渐增大，抗氧化能力逐渐增大。且对人体无毒害作用，可考虑代替合成的抗氧化剂。     

硫酸钾生产工艺改造

介绍了曼海姆炉的结构特点、生产硫酸钾的反应原理，以及新砌筑曼海姆炉的烘炉程序、生产运行所需条件和生产中曼海姆炉常出现的问题及解决问题的办法，推荐了几种曼海姆炉的工艺改造方案。经过改进后反应炉运行良好，可以延长反应炉的修炉周期，从而延长了反应炉的使用寿命，提高了硫酸钾的产量，节约了大量的修炉费用。     

Effects of cobalt, temperature and certain impurities upon cobalt electrowinning from sulfate solutions

The effects of cobalt concentration, temperature and the presence of zinc, copper and iron ions in the electrolyte on current efficiency and cathodic quality were investigated by cyclic voltammetry and galvanostatic methods during cobalt electrowinning. The results showed that high cathodic efficiency of cobalt deposition was obtained from solutions containing cobalt concentration in the range 30–60 g l^–1. Current efficiency increased from 94% to 97% with increase in cobalt concentration to 60 g l^–1 at 20 °C. It was also found that increase in temperature to 50 °C enhanced the cobalt deposition reaction, along with the rate of hydrogen evolution, resulting in little change in current efficiency. The presence of foreign cations in the electrolyte not only adversely affects current efficiency but also promotes cracking and peeling.     

Biobased thermosets from the free‐radical copolymerization of conjugated linseed oil

New polymeric thermosets were prepared through the bulk free‐radical copolymerization of 100% conjugated linseed oil, acrylonitrile, and divinylbenzene. Under the appropriate reaction conditions and with the appropriate curing sequence, 61–96 wt % of the oil was incorporated into the crosslinked thermosets. The resulting yellow, transparent thermosets varied from being soft and flexible to being hard and brittle. Dynamic mechanical analysis and thermogravimetric analysis showed that these thermosets had good mechanical properties and thermal stability. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 979–985, 2007     

Preparations and properties of thermosensitive terpolymers of N‐isopropylacrylamide,sodium 2‐acrylamido‐2‐methyl‐propanesuphonate,and N‐tert‐butylacrylamide

Terpolymers based on N‐isopropylacrylamide, sodium 2‐acrylamido‐2‐methyl‐propanesulfonate, and N‐tert‐butylacrylamide were synthesized by free‐radical copolymerization with 2,2′‐azobisisobutyronitrile as an initiator. The lower critical solution temperatures (LCSTs) of the linear polymer aqueous solutions were determined by the measurement of the transmittance on UV at different temperatures. The influence of the polymer concentration, polymer composition, and ionic strength on the LCSTs of the linear polymers was investigated. The LCST decreased with increases in the hydrophobic monomer N‐tert‐butylacrylamide, polymer concentration, and ionic strength. The phase transition became sharp when the polymer concentration and ionic strength increased. Meanwhile, the crosslinked hydrogels were prepared with the same recipe used for the linear terpolymers, but a crosslinker was added to the reaction system. The swelling ratios of the hydrogels at various temperatures and salt solutions were determined. The hydrogels possessed both high swelling ratios and thermosensitivity. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2007