全文获取类型
收费全文 | 103073篇 |
免费 | 12202篇 |
国内免费 | 6524篇 |
专业分类
电工技术 | 11737篇 |
技术理论 | 1篇 |
综合类 | 9600篇 |
化学工业 | 15772篇 |
金属工艺 | 7359篇 |
机械仪表 | 8773篇 |
建筑科学 | 8321篇 |
矿业工程 | 3449篇 |
能源动力 | 3504篇 |
轻工业 | 9285篇 |
水利工程 | 3234篇 |
石油天然气 | 4329篇 |
武器工业 | 1055篇 |
无线电 | 8403篇 |
一般工业技术 | 12457篇 |
冶金工业 | 3766篇 |
原子能技术 | 1444篇 |
自动化技术 | 9310篇 |
出版年
2024年 | 635篇 |
2023年 | 1843篇 |
2022年 | 2986篇 |
2021年 | 3657篇 |
2020年 | 4127篇 |
2019年 | 3627篇 |
2018年 | 3585篇 |
2017年 | 4258篇 |
2016年 | 4364篇 |
2015年 | 4482篇 |
2014年 | 6171篇 |
2013年 | 7259篇 |
2012年 | 7484篇 |
2011年 | 7799篇 |
2010年 | 5513篇 |
2009年 | 5708篇 |
2008年 | 5390篇 |
2007年 | 6410篇 |
2006年 | 5832篇 |
2005年 | 4745篇 |
2004年 | 4042篇 |
2003年 | 3441篇 |
2002年 | 2971篇 |
2001年 | 2444篇 |
2000年 | 2173篇 |
1999年 | 1825篇 |
1998年 | 1510篇 |
1997年 | 1303篇 |
1996年 | 1147篇 |
1995年 | 917篇 |
1994年 | 862篇 |
1993年 | 656篇 |
1992年 | 535篇 |
1991年 | 398篇 |
1990年 | 381篇 |
1989年 | 282篇 |
1988年 | 249篇 |
1987年 | 142篇 |
1986年 | 135篇 |
1985年 | 119篇 |
1984年 | 93篇 |
1983年 | 71篇 |
1982年 | 73篇 |
1981年 | 21篇 |
1980年 | 40篇 |
1979年 | 25篇 |
1976年 | 5篇 |
1975年 | 6篇 |
1959年 | 15篇 |
1951年 | 15篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
81.
82.
采用X射线衍射分析技术,研究了脉冲化学镀非晶态Ni-P合金的原子分布和函数,得出其短程有序原子集团的尺度为0.754nm,约为熔体激冷法获得的非晶态Ni-P合金短程有序畴的1/2。并利用脉冲化学沉积非晶态合金的微机制择这一结果进行了解释。 相似文献
83.
84.
聚碳硅烷的分子量分布与可纺性研究 总被引:6,自引:1,他引:5
阐述了聚碳烷的合成及其分子量分布,讨论了高低分子含量对聚碳硅烷熔点及可纺性的影响,而且提出了分子量分布的控制标准与方法。 相似文献
85.
In order to cumpare the peformance of different supply diffuers of ventilation air, the airflow passern, temperature stratifiation and contaminant dispersion in a furnitured office ventilated by three kinds of air diffuer were numerically investigated. The air diffuers studied in this paper are a quarter-cylinder displacement diffuer on the floor and mixing diffuers (linear and vortex diffuers) on the ceiling. The heat sources in the of-fice are considered to be 50% convective and 50% radiative. The k-? two-equatwn model of turbulence is employed to predict the turbulent diffusion. The results show that the displacement diffuser provides a rather uniform flow field with low velocify in most areas, and the vertical temperature difference from floor to ceiling is as high as 6 K. With the linear diffuser, the air velociry is high, and the temperature is uniform both horizontally and vertically. The air velocity generated by the vortex diffuser is moderate. The distributions of the temperature and the contaminant are rather uniform. 相似文献
86.
Shihong XU Pengshou XU Mingrong JI Xianming LIU Maosheng MA Jingsheng ZHU Yuheng ZHANG Structure Research Laboratory University of Science Technology of China Hefei ChinaZhenjia XU Institute of Semiconductor Academia Sinica Beijing China 《材料科学技术学报》1993,9(6):437-440
The alkali-metal Na adsorption on Si(100)2×1 surface and its promoted oxidation and Si oxidegrowth have been investigated by means of thermal desorption,work function,Auger electronspectroscopy and photoemission electron spectroscopy.The experimental data showed that therewas a new state,interface electron state,near the Fermi level after the deposition of Na atoms.It wasfound that the presence of Na always caused an increase of the oxygen initial uptake whereas thepromotion of Si oxide growth was observed only at the coverage of Na greater than 0.5 ML.A newmechanism of Na-promoted Si oxide growth is suggested in this paper. 相似文献
87.
离子注入对Cr12MoV钢表面组织结构和力学性能的影响 总被引:1,自引:0,他引:1
研究了Cr12MoV钢离子注入层的显微组织特征及其对表面性能的影响。结果表明,离子注入使Cr12MoV钢的表面硬度和耐磨性能得到显著改善,且存在着一个最佳的注入剂量,约为3×10^1^7N^+/cm^2左右。离了注入在Cr12MoV钢表面层中形成了大量细小弥散的第二相粒子,并使α-Fe晶格发生严重畸变,从而引起材料表面强化。 相似文献
88.
The causes of lightning outage are subdivided into direct lightning strokes and induced lightning strokes, which are identified by the characteristics of the lightning overvoltage. In the past, lightning protection devices were directed mainly toward the latter, and attention has been focused on the installation of lightning protection devices, ground wires, and reinforcement of insulators. However, lightning outages continue to occur. Thus it is extremely important to clarify the fault characteristics of lightning surges and to study the effectiveness of various lightning protection devices by considering both direct lightning stroke and induced lightning stroke in order to prevent lightning outage in the future. In this research, the electromagnetic transients program (EMTP) has been applied to the direct lightning stroke, and the induced lightning outage analysis program for multiple conductor systems has been applied to the induced lightning stroke to study the effectiveness of lightning protection devices provided by combination of various lightning protection devices. The most effective lightning protection schemes are analyzed and evaluated based on verification tests on the full scale models as well as economic considerations. 相似文献
89.
Motoharu Fujigaki In Hong Yang Yoshiharu Morimoto Eung Kyo Han 《NDT & E International》1996,29(4):197-203
There is no good method to measure the shape and the strain distributions of a structure changing with time. We have previously proposed the Fourier transform grid method (FTGM) to measure the three-dimensional shape and surface strain distributions of stationary objects by analysing the two-dimensional grating images recorded with two cameras. In the stereoscopic method, it is very important to determine the accurate geometric parameters of the camera system. In this paper, the positions and the directions of cameras are accurately determined using the FTGM applied to images of a reference object on which a two-dimensional grating is drawn. Applications for analysing shape and strain distributions of vibrating rubber plates and a moving human skin are shown. 相似文献
90.