Modeling Condensation and Evaporation on Fruit Surface

Rewarming of fruits and vegetables after cooling is characterized by heat and mass transfer processes, which leads commonly to condensation of water on the produce surface at temperatures below the dew point. This effect may affect the produce quality due to microbial growth at unfavorable environmental conditions. The amount of condensed water is a function of the produce surface temperature and of the surrounding conditions as air temperature, air humidity, and air flow. Under practical conditions, both the warming and the condensation are strongly affected by the packaging system used. Depending on the flow conditions close to the produce surface, parameters of heat and mass transfer under laboratory conditions were measured. A mathematical model was developed for the determination of the amount of condensed water on fruit surfaces, its reevaporation, and its total dwell time dependent on the environment air conditions. The model describes the heat and mass transfer processes on single fruits. The process of diffusion of humidity in air and proceed of surface temperature is the basis for the model.     

Analysis and Optimization Laminar Viscous Flow Through a Channel

Optimizing of laminar viscous flow through a pipe by two dimensionless values is investigated analytically. Dimensionless entropy generation and pumping power to heat transfer rate ratio are used as basis for constant viscous and the temperature dependence on the viscosity. For this matter we calculate entropy generation and pumping power for a fully developed in a pipe subjected to constant wall temperature for either constant viscosity and the variable viscosity. The variation entropy generation increase along the pipe length for viscous fluid is drawn, either the variation summation dimensionless entropy generation and the pumping power to heat transfer rate ratio are varying the fluid inlet temperature for fixed pipe length and are varying pipe length for fixed fluid inlet temperature are drawn. For low heat transfer conditions the entropy generation due to viscosity friction becomes dominant and the dependence of viscosity with the temperature becomes essentially important to be considered.     

Predicting posttraumatic growth in breast cancer survivors.

Wide variability exists with respect to how breast cancer survivors respond to common psychological and psychosocial challenges of their disease, ranging from posttraumatic stress disorder to posttraumatic growth. This cross-sectional study examined contextual, disease-related, and intraindividual predictors of posttraumatic growth in 224 randomly selected breast cancer survivors. A series of hierarchical regression analyses found that age at diagnosis, marital status, employment, education, perceived intensity of disease, and active coping accounted for 34%, 35%, and 28% of the variance in growth in relationships with others, new possibilities, and appreciation for life. These findings suggest that a more comprehensive model of growth will be helpful in understanding the various factors that play a role in breast cancer survivors' perception of psychological and psychosocial growth. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Substance use as a robust correlate of school outcome measures for ethnically diverse adolescents of Asian/Pacific Islander ancestry.

School psychologists are generally not provided with the knowledge and skills to address both educational and psychosocial issues of Asian American and Pacific Islander students. The present study is the first of its kind in examining 36 independent (i.e., demographic, social, cultural, psychological) variables in association with four school outcomes (i.e., grade point average, absences, suspensions, and school infractions) with a large sample of Caucasian, Filipino, Native Hawaiian, Japanese, mixed/non-Hawaiian, and "other" Hawai'i high school students (N = 2,833). Given the relatively unique sample in question and the sheer number of variables, an exploratory approach was utilized with the goal of determining the most robust independent variables, with the unique inclusion of Hawaiian cultural identification. A cross-validation technique was used, whereby stepwise regressions were performed for each of two cross-validation samples; only common variables were retained in a final stepwise model for each of the four school outcomes. The results indicated that, remarkably, substance use accounted for the most variance (i.e., 8.4% -16.1 %) in the four school measures. Further analyses detailed the relationship, including the finding that smoking cigarettes regularly, accounted for the most variance compared to the other five substance use items. Further research and implications of the findings are discussed, including the need for prevention and intervention programs that incorporate substance use as a component, both within and outside of school environments. (PsycINFO Database Record (c) 2011 APA, all rights reserved)     

Discrete Modeling and Suggested Measurement of Heat Transfer in Gas-Solids Flows

This article presents a two-dimensional transient model for gas-solids flow and heat transfer through pipes using the coupled Computational Fluid Dynamics and Discrete Element Method approach. Numerical simulations have been conducted to examine the modification of fluid thermal structure due to the presence of particles in a pneumatic transport pipeline. Modeled results have demonstrated the key role of transversal motion of rebounding particles in the pipe cross section in altering fluid temperature. Further implementation of this modeling technique in air-drying processes is discussed and possible experimental methods for the measurement of in situ particle and fluid motion and temperature profile are cited.     

Electrical conductivity in iodine-doped ethyl cellulose

The electrical conductivity of solution-grown ethyl cellulose (EC) films, 5–30 μm thick, has been studied in the sandwich configuration (metal–EC–metal) as a function of iodine concentration from 0.5 to 5.0 wt% ratio. The studies were conducted in the temperature range 333–383 K, while the field was varied over the range (3.0–5.5) × 10⁴V/cm. Aluminium was used as the lower electrode, while the upper electrode was of Al, Ag, Cu, Au or Sn. Certain transient effects such as a large burst of current immediately after the application of field were observed. An attempt was made to identify the nature of the current by comparing the observed dependence on electric field, electrode material and temperature with the respective characteristic features of the existing theories of electrical conduction. The results show that the electrical conduction follows Ohm's law at lower fields, while at higher fields, space-charge limited current (SCLC) was observed. It was also found that Richardson–Schottky emission was responsible, to some extent, for the transport of charge carriers in the polymer. The conductivity of the films increased on doping with iodine. The dopant molecules are considered to act as additional trapping centes and provide links between the polymer molecules in the amorphous region, thus resulting in the formation of charge transfer complexes.     

Optical data storage by novel photoelectrochromic polymer

A novel elastic polymer containing 4,4′-bipyridinium salts with tetrakis[3,5-bis(trifluoromethyl)phenyl]borate as part of the main chain was synthesized. The cast film showed persistent and reversible colour changes due to photoinduced electron transfer upon excitation of an ion-pair charge-transfer band (_ex >365 nm) in vacuo. The lifetime of the coloured state markedly depended on temperature. The optically written data were stored without decay below 0°C and were erased thermally at elevated temperatures. The colour changes were reversibly repeatable for many times.     

Integration of solvent extraction and liquid membrane separation: An efficient tool for recovery of bio-active substances from botanicals

An integrated process based on simultaneous solid-liquid extraction and liquid membrane separation is proposed for recovery and isolation of valuable species from botanicals. This integration provides complete exhausting of the solid material even in the case of very low solubility of the specified solute in the extracting solvent. Selectivity of the liquid membrane ensures a preferential transport of the desired solute from the native extract into the strip solution, while the other co-extracted species remain predominantly in the native extract.     

Cover Picture: Light‐Emitting Organic Solar Cells Based on a 3D Conjugated System with Internal Charge Transfer (Adv. Mater. 22/2006)

The cover image illustrates the dual photovoltaic and electroluminescence function of a single‐layer device based on a thienylenevinylene–triphenylamine with internal charge transfer (ICT), as reported by Cravino, Roncali, and co‐workers on p. 3033. The material forms an organic glass with isotropic electronic properties while ICT leads simultaneously to an extension of the photoresponse to the red and to an increase of the open circuit voltage. The use of an additional layer of C₆₀ further improves the photovoltaic. Images of the sun and moon courtesy NASA/JPL–Caltech.     

Photodegradation mechanism and stabilization of polyphenylene oxide and rigid‐rod polymers

Poly(2,4‐dimethyl‐1,4‐phenylene oxide) (PPO), poly(benzo[1,2‐d:5,4‐d′]bisoxazole‐2,6‐diyl‐1,4‐phenylene) (PBO) and poly(benzo[1,2‐d:4,5‐d′]bisthiazole‐2,6‐diyl‐1,4‐phenylene) (PBZT), which are polymers with extended conjugated structures, undergo a self‐sensitized photo‐induced electron‐transfer reaction. A second component is not required. This article presents many similar observations on these polymers when they are exposed to light and evidence to support the proposed photo‐induced electron‐transfer mechanism. Methods to stabilize these polymers against photo‐oxidation are also described. Workers investigating other conjugated polymeric systems may find the experimental methods, observations and polymer stabilization approaches discussed in this review useful. Copyright © 2005 Society of Chemical Industry