压缩空气冷冻胶粉生产技术研究

介绍了利用新型离心式粉碎机和人字形槽动静压混合式气体轴承透平膨胀机，采用普冷与压缩空气膨胀制冷相结合来生产精细胶粉的工艺路线及关键设备。这种技术具有操作方便、车间干净卫生、能耗低、关键设备可靠性好、生产效率高等特点     

Low-temperature methanol synthesis in a circulating slurry bubble reactor

A circulating slurry bubble reactor was developed to synthesise methanol via methyl formate from the gas mixture of carbon monoxide and hydrogen at low temperature. The strategy for designing and scaling up the bubble reactor involved a preliminary understanding of fluid dynamics in a cold model, continuous operations under industrial conditions and a parallel experiment in an autoclave. Per-pass syngas conversion was investigated during 100-h operations. The axial profile of solid catalyst concentration was measured just before the shutdown and the composition of liquid product was analysed after the shutdown. These results show that the circulating slurry bubble column will become a potential reactor for the commercial process of low-temperature methanol synthesis after the catalyst system has been improved.     

旋流器内空气核的形成机理和形状的实测研究

首次采用先进的高速摄象机对旋流器内空气核的出现、发展直至形成的整个过程以及形成后的形状进行了全面系统的实测研究。研究发现空气核的形成经历了孕育、发展及形成三个不同的阶段;在旋流器内不同的高度,空气核的形状有所不同,在底流口上端发生最大程度的偏摆,而在溢流管内出现类似“葫芦”形状;旋流器的进口流量和锥角对空气核的形成过程及形状尺寸有着重要的影响。空气核的形成运动过程为一随机过程,这是造成分离过程具有随机特性的主要因素之一。     

环己烷在Au-Co/SBA-15上选择性氧化的研究

以沉积-沉淀法制备了Au-Co/SBA-15催化剂,在没有任何有机溶剂或助剂的条件下,研究了以空气为氧化剂的环己烷选择性氧化。当Au-Co/SBA-15催化剂中金的质量百分含量为1.0%,催化反应在423 K 3.0 MPa下进行120 m in时,催化效果最好,此时环己烷的转化率为22.7%,环己酮和环己醇的总选择性为95.2%,酮醇比为2.9,且催化剂重复使用五次后活性基本不变。     

鼓泡床内气泡-液体两相湍流代数应力模型的数值模拟

现有的气泡 -液体两相流动的数值模拟中 ,或者不考虑湍流 ,或者仅仅考虑液体湍流 ,但是直接模拟和PIV测量结果都表明气泡由于尾迹的作用有强烈的湍流脉动 .本文首次推导和封闭了同时模拟气泡湍流脉动和液体湍流脉动的二阶矩输运方程两相湍流模型 ,并在此基础上建立了代数应力气泡 -液体两相湍流模型 .用代数应力模型模拟了二维矩形断面鼓泡床内气泡 -液体两相流动 .预报结果给出了气泡和液体两相速度场、两相Reynolds应力及湍动能分布和气泡体积分数分布 .模拟结果与PIV测量结果符合很好 ,表明了模型的合理性 .研究结果表明 ,原先静止的液体在气泡因浮力而产生的上升运动的作用下产生回流流动 ,而气泡则只有上升运动 .气泡速度始终大于液体速度 .在床内气泡湍流脉动确实始终很强烈 .液体则由于气泡的作用以及自身速度梯度产生的双重作用而发生湍流脉动 .气泡的脉动显著地大于液体的脉动 .两相湍流脉动都是各向异性的 ,而且气泡湍流脉动的各向异性比液体的更强烈     

Settling velocities of particles in bubbly gas-liquid mixtures

The axial dispersion-sedimentation model is commonly used to describe the axial concentrations of solids in three phase bubble columns at low liquid velocities. When the two parameters of this model, the particle settling velocity and the solids axial dispersion coefficient, are uncoupled by the use of various assumptions, physically unrealistic values of these parameters often result. Direct experimental measurements of solids settling rates in bubbly gas-liquid mixtures were carried out. The measured mean settling velocities decreased slightly with gas flow rate and were equal to or slightly less than the single particle free settling velocity in the liquid alone. Solids axial dispersion coefficients were also obtained from the solids settling rate distribution data, and gave values considerably less than the experimental liquid axial dispersion coefficient.     

用CCD摄像法测量下喷环流反应器内的气泡行为

本文开发了一种集高速视频分析系统和计算机数字图像处理技术于一体的具有普适性的动态高速ＣＣＤ摄像系统，并利用该系统测定了两相三维下喷环流反应气内的环境气泡行为，考察了不同喷咀和操作条件对气泡行为及平均传质比表面积的影响。     

Air sampling of volatile sex pheromone components in a closed jar

A cotton wool plug, used as the source for pheromone release, was placed in closed 1-quart Mason jars, either at the mouth or at the rear of the jar. Air sampling of the two components of the sex pheromone (total 2.2 mg at the source) of the almond moth (Ephestia cautella) female showed that the saturation period near the source in still air was 20–22 hr and that far from the source was 40–50 hr, reaching a level of less than 1 ng/ml air. The ratio between the components (Z,E)-9,12-tetradecadienyl acetate, designated D, and (Z)-9-tetradecenyl acetate designated M, in the air was close to the original ratio for both sampling sites, albeit somewhat richer in the more volatile (Z)-9-tetradecenyl acetate (source 77.023.0 DM, air 73.0– 74.327.0–25.7; source 80.119.9, air 77.622.4; source 25.174.9, air 23.976. 1 DM). The total amount of pheromone per milliliter of air was two to three times larger near the source than far from it at the early stages of the evaporation and saturation process. When the amount of pheromone applied to the source was tripled (7 mg), the amount far from the source was almost tripled, or the saturation time was cut by factor of two to three.