Copper(II) removal from aqueous solutions by fly ash

The removal of Cu(II) by adsorption on fly ash has been found to be concentration, pH and temperature dependent. The kinetics of adsorption indicates the process to be diffusion controlled. The Langmuir constants have been calculated at different temperatures, and the adsorption has been found to be endothermic (ΔH = 15.652 kcal mol^?1). The maximum removal is observed at pH 8.0, and variation in adsorption with pH has been explained on the basis of surface ionisation and complexation.     

Significance of fluid regime in biological filtration

A dispersed flow model previously developed to study substrate utilization in unsaturated media was experimentally verified and its practical application was considered. For this purpose, measurements were made using tap water and a synthetic feed solution. The importance of the change in fluid regime as regards to the simultaneous transport and reaction within biological filters were demonstrated. The effect of drop formation and the breakage of liquid jets inside the filters on substrate utilization was also shown.     

一种新型润滑油添加剂的质谱研究

采用独特的分离方法和途径，综合使用多种质谱分析技术，如电子轰击谱（ＥＩ／ＭＳ）、场解吸谱（ＦＤ／ＭＳ）、快速原子轰击谱（ＦＡＢ／ＭＳ）、色／质联用等，对高档齿轮油的主剂－含磷极压剂的结构组成进行了较为详尽的分析研究，提出了复酯胺盐的结构组成。     

Carbon fibre cloth as an electrode material: electrical conductivity and mass transfer

The paper deals with carbon fibre cloth electrodes, employed in the fabrication of composite materials. The electrical conductivity of single bundles, groups of bundles and cloth is studied. Ohm's law applies to the electrical conduction in the direction of the fibre length, but bundle conductivity decreases with the number of fibres in the bundle. Electrochemical mass transfer between a flowing electrolyte and a cloth arranged as a flow-through or a flow-by porous electrode indicates the existence of double porosity in the material. Due to double porosity, only the external surface of the cloth works as an electrode. This finding shows that the material is not suitable for such an application.     

宣钢近北庄铁矿露采边坡稳定的结构分析

以宣钢近北庄铁矿露采边坡稳定性研究为例，说细说明了岩体结构分析方法的应用。     

地应力及其测量法简介

地应力对工程岩体的稳定性影响很大，工程实践中常需定量地确定工程范围内的地应力。本文简要地介绍了地应力的概念、应用及常用的测量方法。     

Dynamic analysis and drilling degrees of freedom

Finite element methods for dynamic analysis employing elements with drilling degrees of freedom are presented. The formulation is based on a variational principle in which displacements and rotations are interpolated independently. The issue of zero masses corresponding to rotational degrees of freedom is addressed and techniques for defining consistent and lumped rotational mass matrices are presented.     

Evaluation of a system of wind tunnels for field studies of ammonia loss from grassland through volatilisation

Rates of ammonia (NH₃) loss from a ryegrass sward measured using a system of small wind tunnels were compared with concurrent measurements made using a micrometeorological mass balance method. Measurements were made during two experiments within a circular plot (radius 10m) treated with urea at a rate of 200kgNha^?1. In the first experiment, air speed through the tunnels was adjusted as necessary to maintain a value of approximately 1ms^?1. This value differed on most occasions from the mean ambient wind speed which was measured at a height of 250mm and which ranged from 0.61 to 2.95ms^?1. Rates of loss measured using the wind tunnels differed by a factor of between two and five from those measured using the mass balance method; there was no consistent pattern in the differences between the rates of loss. The total losses of NH₃ measured during 15 days were equivalent to 49.1 and 30.2kg Nha^?1 for the mass balance and wind tunnel methods, respectively. In the second experiment, air speed through the tunnels was adjusted as necessary to maintain a value as close as possible to the mean ambient wind speed measured at a height of 250mm. Rates of NH₃ loss measured using the two methods did not differ significantly; total losses of NH₃ during 17 days were equivalent to 96.9 and 101kg Nha^?1 for the mass balance and wind tunnel methods, respectively. The difference between the findings of the two experiments could be attributed to the direct effect of air speed through the tunnels rather than to differences between ambient temperatures and those inside the tunnels. During and following periods of rain the rates of loss measured using the tunnels were up to six times greater than those observed with the mass balance method. Rates of loss measured by the two methods became similar again when the tunnels were moved following rain. The study demonstrates that enclosures can be designed and operated to provide reliable measurements of the rate of NH₃ loss from grassland. Potential applications of the two methods are discussed.     

Evaluation of the reactivity of titanium with mould materials during casting

A methodology for evaluating the reactivity of titanium with mould materials during casting has been developed. Microhardness profiles and analysis of oxygen contamination have provided an index for evaluation of the reactivity of titanium. Microhardness profile delineates two distinct regions, one of which is characterised by a low value of hardness which is invariant with distance. The reaction products are uniformly distributed in the metal in this region. The second is characterised by a sharp decrease in microhardness with distance from the metal-mould interface. It represents a diffusion zone for solutes that dissolve into titanium from the mould. The qualitative profiles for contaminants determined by scanning electron probe microanalyser and secondary ion mass spectroscopy in the as-cast titanium were found to be similar to that of microhardness, implying that microhardness can be considered as an index of the contamination resulting from metal-mould reaction.     

节理岩体的代表单元集合体模型及弹性参数预测

本文明确提出了节理岩体“代表单元集合体”的概念和模型，通过对节理岩体的“代表单元集合体”进行数值模拟，研究了节理岩体的“代表单元集合体”的变形特性，建立了节理岩体的弹性模型，提出了预测节理岩体宏观等效弹性参数的计算机模拟方法，并将其应用于岩体工程稳定性分析中。