Modeling Condensation and Evaporation on Fruit Surface

Rewarming of fruits and vegetables after cooling is characterized by heat and mass transfer processes, which leads commonly to condensation of water on the produce surface at temperatures below the dew point. This effect may affect the produce quality due to microbial growth at unfavorable environmental conditions. The amount of condensed water is a function of the produce surface temperature and of the surrounding conditions as air temperature, air humidity, and air flow. Under practical conditions, both the warming and the condensation are strongly affected by the packaging system used. Depending on the flow conditions close to the produce surface, parameters of heat and mass transfer under laboratory conditions were measured. A mathematical model was developed for the determination of the amount of condensed water on fruit surfaces, its reevaporation, and its total dwell time dependent on the environment air conditions. The model describes the heat and mass transfer processes on single fruits. The process of diffusion of humidity in air and proceed of surface temperature is the basis for the model.     

一种蒸发式冷凝器的新型设计方法

蒸发式冷凝器设计方法的粗糙和繁琐限制其广泛应用,特别是限制其应用于民用和小型商用建筑中。针对上述问题,作者通过实验研究了蒸发式冷凝器的影响因素（进风湿球温度、最小截面风速和喷淋水量）对蒸发式冷凝器热质交换的影响。同时提出了一种新型设计方法,此方法简单,精度较高。适合工程设计、选型和生产应用。     

关于彩涂压型钢板构件设计中的选材问题

近年来 ,在彩涂压型钢板构件设计应用中 ,由于不重视、不了解如何合理选材 ,在实际工程的材料订货中也都不提出对材料性能的技术要求 ,致使供货材质、材性不能满足使用要求 ,存在降低彩板构件承载力或减少其使用寿命的隐患 ,应引起设计人员的注意。同时对当前如何按使用条件及材料供应条件合理地选定彩板材料的性能技术要求 ,包括基板钢材的级别及力学性能、板厚及公差控制要求、镀锌层质量与彩涂层类别以及参照的技术标准等 ,提出了一些建议 ,供设计应用参考。最后还对板的强度、厚度以及镀铝锌板的选用问题进行了讨论     

电解法烟道气二氧化硫在线监测系统的设计

介绍了一种烟道气中SO2在线检测系统，该系统可以实现24h不间断地监测烟道气中SO2的体积分数和质量浓度，同时将信息经网络传送给环保有关部门，具有一定的新颖性、可靠性、准确性。     

强耦合表面磁极化子的基态能量和有效质量

采用Landau-Pekar变分理论研究强耦合表面磁极化子的性质。分别计算了强耦合表面磁极化子的基态能量和有效质量，并讨化了表面磁极化子的基态能量，振动频率和有效质量随磁场的变化关系。对KCL晶体进行了数值计算，结果表明，强耦合表面磁极化子的振动频率和有效质量随磁场的增加而增加，基态能量随磁场的增加而减少。     

Rapid analysis of polymer homologues and additives with SFE/SFC-MS coupling

A rapid and easy analysis method for polymers is presented. The method involves sample preparation by SFE, separation of the extracted compounds by SFC and simultaneous quantitative detection by FID, as well as identification of unknowns by MS. The applications illustrate how structural research work and routine polymer analysis can be done with this time saving method.     

Volatile constituents of palm wine and palm sap

Palm wine and pasteurised palm sap volatiles were collected, concentrated on a Tenax GC and analysed by gas chromatography and gas chromatography-mass spectrometry. Eighty-two components were identified: 47 esters, 9 alcohols, 5 acids, 6 carbonyls, 2 acetals, 4 terpenes and 9 hydrocarbons. These had all been found previously in conventional wines. Odour evaluation of the separated palm wine components as they eluted suggested that no one compound is responsible for the characteristic palm wine odour. The acetates of higher alcohols and the ethyl esters of straight-chain aliphatic C₆-C₁₀ acids seemed to be important and may play a big role in imparting the fruity nuances of characteristic palm wine odour. Their association with alcohols seemed also to be necessary for the expression of typical palm wine odour. The qualitative difference between palm sap aroma and palm wine aroma appeared to be due mainly to the presence of these esters and alcohols in palm wine and their apparent absence from palm sap, as well as to the presence of some low-boiling esters and alcohols in palm sap and their apparent absence from palm wine.     

三峡工程临时船闸坝段4.5 m升层混凝土施工

三峡临时船闸2号坝段甲块混凝土因大坝蓄水验收要求，须在50d内完成28．5m高的混凝土浇筑，如按常规大坝混凝土施工是无法完成的。工程实施中，采用了4．5m大升层混凝土施工方案，通过加快混凝土入仓速度，改进混凝土施工工艺，加强混凝土模板设计，注重混凝土初期冷却，缩短混凝土间歇期等一系列措施，提前7d完成了目标计划。临时船闸2号坝段4．5m升层混凝土的施工经验，可供大体积混凝土施工借鉴。     

水平井筒变质量分散泡状流压降的理论与实验研究

由于水平井筒和常规水平管道中气液两相流动的相似和差别，可以预知常规水平管流的压降计算方法对于井筒流动来说就需要进行修正或扩展。本文对气、液两相分别应用质量守恒方程和动量守恒方程，考虑管壁存在人流或出流对于分层流流型压降的影响，得到水平井筒气液两相变质量流动分散泡状流流型的压降计算方法。同时，设计并建立了水平井筒流体流动模拟实验装置，在轴向为气液两相流动的前提下分别进行了上管壁单孔眼注入和下管壁单孔眼注入的压降实验研究，获得了大量的实验数据。实验数据和理论计算结果吻合很好，这表明该计算方法具有实际应用价值。     

Reactor modelling for electrochemical processes

This paper presents a relatively straightforward approach to the modelling of electrochemical reactors operated in batch or continuous modes. The models are based on ideal flow assumptions of either well-mixed or plug flow and incorporate reaction rate models based on electrochemical kinetics and mass transport at one electrode. General characteristics of the reactor models are described, particularly with regard to the need for good mass transport in metal recovery applications. An example is given on the use of the model in the recovery of a heavy metal (Cd²⁺) from an acidified solution containing Cd(II) and Fe(III) ions. The reaction rate model is based on experimental data.