英台地区天然水驱油藏的开发特点及稳产技术

掌握边底水运动规律，控制并利用活跃的边底水能量，是成功开发天然水驱油藏的关键。英台地区的英台、四方坨子和一棵树等三个油田均为天然水驱油藏，天然能量充足。油藏投入开发后初期含水较高，含水上升极快，造成产油量大幅度递减。针对其开发特点，适时采用大泵、电潜泵提液强采，通过大量补孔层间接替以及加密调整和扩边等稳产技术措施，确保了油藏以3％-5％的采油速度长期稳产，水驱采收率高达50％以上。     

Oxidative radical generation via nitrogen dioxide dimer conversions induced by amide groups of macromolecules

The features of initiation of free radical reactions in polymers by dimers of nitrogen dioxide are considered. The conversion of planar dimers into nitrosyl nitrate in the presence of amide groups of macromolecules has been revealed. Nitrosyl nitrate initiates radical reactions in oxidative primary process of electron transfer with formation of intermediate radical cations and nitric oxide. As a result of subsequent reactions, nitrogen‐containing radicals are produced. The dimer conversion has been exhibited by estimation of the oxyaminoxyl radical yield in characteristic reaction of p‐benzoquinone with nitrogen dioxide on addition of aromatic polyamide and polyvinylpyrrolidone to reacting system. The isomerization of planar dimers is efficient in their complexes with amide groups, as confirmed by ab initio calculations. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

新区采油速度与稳产时间、递减率变化关系研究

针对新区稳产时间以及递减期递减余率大小难以确定等问题,通过对中原油田61个独立小区块进行分析对比,得出采油速度与稳产时间,不同采油速度下无因次采油速度与时间关系曲线,对于新区开发预测稳产时间以及预测递减期产量变化有着重要意义.     

Wind turbine response to parameter variation of analytic inflow vortices

As larger wind turbines are placed on taller towers, rotors frequently operate in atmospheric conditions that support organized, coherent turbulent structures. It is hypothesized that these structures have a detrimental impact on the blade fatigue life experienced by the wind turbine. These structures are extremely difficult to identify with sophisticated anemometry such as ultrasonic anemometers. This study was performed to identify the vortex characteristics that contribute to high‐amplitude cyclic blade loads, assuming that these vortices exist under certain atmospheric conditions. This study does not attempt to demonstrate the existence of these coherent turbulent structures. In order to ascertain the idealized worst‐case scenario for vortical inflow structures impinging on a wind turbine rotor, we created a simple, analytic vortex model. The Rankine vortex model assumes that the vortex core undergoes solid body rotation to avoid a singularity at the vortex centre and is surrounded by a two‐dimensional potential flow field. Using the wind turbine as a sensor and the FAST wind turbine dynamics code with limited degrees of freedom, we determined the aerodynamic loads imparted to the wind turbine by the vortex structure. We varied the size, strength, rotational direction, plane of rotation, and location of the vortex over a wide range of operating parameters. We identified the vortex conformation with the most significant effect on the blade root bending moment cyclic amplitude. Vortices with radii on the scale of the rotor diameter or smaller caused blade root bending moment cyclic amplitudes that contribute to high damage density. The rotational orientation, clockwise or counter‐clockwise, produces little difference in the bending moment response. Vortices in the XZ plane produce bending moment amplitudes significantly greater than vortices in the YZ plane. Published in 2005 by John Wiley & Sons, Ltd.     

皮革加油原理及注意事项

本文从乳液出发，阐述乳液形成，稳定，破乳以及皮革加油过程。要求使用最少的油剂达到最佳的目的。     

Structural and surface properties of thermally prepared Ti/RhxTi(1−x)Oy electrodes: I—influence of preparation parameters

Electrodes of Rh_xTi_(1−x)O_y nominal composition were prepared by thermal decomposition of the chloride or nitrate precursor salts dissolved in strongly acidic medium and applied by brush to both sides of a Ti° support. A systematic study of the influence of calcination temperature and time as well as oxygen flux was conducted. The coatings were characterised by SEM, EDAX, XRD, open circuit potential measurements and cyclic voltammetry (CV). Visible-ultraviolet spectrophotometry was employed to identify the chemical form of the precursor in solution while thermogravimetric analysis (TGA) was used to assess the decomposition temperature ranges. Optimisation of the coating preparation parameters showed coatings obtained from [Rh(H₂O)₆](NO₃)₃ precursor dissolved in HNO₃ 1:2 (v/v) and fired at 430 °C for 2 h in a 5 l min⁻¹ oxygen stream-furnished stable electrodes having the highest electrochemically active surface area.     

SYMMETRIC STABLE SEQUENCES WITH MISSING OBSERVATIONS

Abstract. A procedure for evaluating optimal linear estimates of missing values in the minimum dispersion sense is proposed for stationary symmetric stable processes. Analytical expressions for the estimates are obtained for the autoregressive moving-average process and it is shown that the finite variance setting results are special cases. Cases of one and more than one missing value are considered.     

基于水化学和环境同位素的准格尔煤田地下水循环特征

为揭示准格尔煤田地区地下水循环特征,运用水化学技术、水汽轨迹模型和环境同位素等方法分析不同水体水化学特征、环境同位素特征、大气降水主要来源、地表水及地下水转化关系。结果表明:地表水矿化度低,呈弱碱-偏碱性,水化学类型以HCO_3·SO_4·Cl-Ca型水为主;地下水整体矿化度低,偏弱碱性,主要以HCO_3-Na·Ca型、Cl-Na型、HCO_3-Ca·Mg型、HCO_3·Cl-Na型水为主;黄河水δ(D)平均值为-79.6‰、δ(~(18)O)平均值为-10.47‰,第四系地下水δ(D)平均值为-66.25‰、δ(~(18)O)平均值为-9.1‰,白垩系地下水δ(D)值为-70.6‰、δ(~(18)O)值为-9.3‰,石炭-二叠系地下水δ(D)平均值为-77.07‰、δ(~(18)O)平均值为-9.9‰,寒武-奥陶系地下水δ(D)平均值为-75.73‰、δ(~(18)O)平均值为-10.06‰;大气降水受极地气团和季风影响,主要来源为西风带水汽、地表水和地下水水汽蒸发再循环;断层带、褶皱轴部裂隙带为不同含水层间主要导水通道,大气降水和黄河为地下水主要补给来源;高承压水头寒武-奥陶系岩溶裂隙水越流补给第四系松散孔隙水和砂岩裂隙水,第四系松散孔隙水通过地层间不整合接触面裂隙发育带向下补给石炭-二叠系砂岩裂隙水,黄河水对寒武-奥陶系地下水的补给比例受地质构造发育的影响较大。     

具有时变状态滞后2-D离散系统的稳定与镇定(英文)

针对一类由局部状态空间(LSS)Fornasini-Marchesini(FM)第二模型描述的,具有时变状态滞后的2-D离散系统,其中时变滞后项的上、下界均为正实数,研究了其稳定性和控制综合问题。首先,利用Lyapunov-Krasovski泛函方法,提出了系统的稳定性准则。再根据这一准则,分别设计状态反馈和动态输出反馈控制器保证系统的稳定性。状态反馈控制律和输出反馈矩阵可由线性矩阵不等式(LMI)求得。最后,通过数值算例说明所得结果的有效性。     

Globally asymptotic stabilization for nonlinear time-delay systems with ISS inverse dynamics

The output feedback stabilization is considered for a class of nonlinear time-delay systems with inverse dynamics in this paper.An appropriate state observer is constructed for the unmeasurable system states in order to realize the control objective.By adopting the backstepping and Lyapunov-Krasovskii functional methods,a systematic design procedure for a memoryless output feedback control law is presented.It is shown that the designed controller can make the closed-loop system globally asymptotically stable while keeping all signals bounded.An illustrative example is discussed to show the effectiveness of the proposed control strategy.