低负荷稳燃和高负荷防结渣复合型燃烧器研究开发

针对电站燃煤锅炉实际存在的低负荷稳燃和高负荷防结渣的矛盾，设计了一种新型复合型燃烧器。为确切了解复合型燃烧器的气固两相流动情况，在单喷口冷模实验台和四角喷燃炉冷模实验台上，对不同结构型式和尺寸的复合型燃烧器进行了大量的冷模试验，推荐了合理的结构和尺寸，为复合型燃烧器在电站锅炉上的应用提供了依据。实炉试验结果表明，设计达到了预期设想。     

基于非线性反馈方法的连续时间稳定线性系统的混沌反控制

提出了连续时间线性稳定系统跟踪任意混沌系统实现混沌化的一般方法，该控制器通过非线性反馈取得，其中的反馈增益矩阵的求取与所跟踪的混沌系统无关，只与原连续时间线性稳定系统的状态矩阵有关。通过跟踪Rossler混沌系统和Lorenz混沌系统说明了该方法的设计过程。仿真结果表明了该方法的有效性和快速性。     

Evaluation of the fracture toughness properties of polytetrafluoroethylene

Polytetrafluoroethylene (PTFE) (Dupont Tradename Teflon) is a common polymer with many structural applications including sheet, gaskets, bearing pads, piston rings and diaphragms. The interest here developed because this polymer is being considered as the major component of a newly proposed `reactive' material with a possible application as a projectile to replace common inertial projectiles. Little mechanical property data is available on this material since it is commonly used only as a coating material with the dominant properties being its low friction coefficient and high application temperature. Previous work (Joyce, 2003) on commercially available sheet PTFE material has demonstrated the applicability of the normalization method of ASTM E1820 (1999), the elastic-plastic fracture toughness standard to develop fracture toughness properties of this material over a range of test temperatures and loading rates. Additional work on the aluminum filled `reactive' derivative of the basic PTFE polymer (Joyce and Joyce, 2004) has also recently been completed. In this work, standard ASTM E1820 fracture toughness specimens machined from sintered pucks of PTFE were tested at four test temperatures and at a range of test rates to determine the J _Ic and J resistance curve characteristics of the PTFE material. The major results are that while crack extension is difficult at standard laboratory loading rates at ambient (21 °C) temperature or above, for temperatures slightly below ambient or for elevated loading rates, a rapid degradation of fracture resistance occurs and cracking occurs in a ductile or even nearly brittle manner.     

W(x,t)普遍结果的推导

用分离变量法求解数理方程定解问题时，要求其第一、二、三类边界条件必须是齐次的。若为非齐次的，必须寻求恰当的辅助函数W(x，t)，进行变换，将其化为齐次的。从稳定条件下的线性非齐次边界条件出发，给出了W(x，t)的统一形式，进而将其推广到非稳定条件下的非齐次边界条件，得到W(x，t)的一般的结果。     

扭轮摩擦传动静力学分析

讨论了扭轮摩擦传动机构稳定运行的力学条件，扭轮所受驱动力和扭轮轴线之间的夹角．驱动力矩机构轴向栽荷与扭轮和传动轴间正压力的关系．通过分析得出了驱动力矩、扭轮所受的来自于传动轴圆周切向驱动力主要取决于扭轮与传动轴间的正压力，扭轮所受驱动力的方向和扭轮轴轴线的夹角随着扭轮与传动轴间正压力和传动轴的轴向栽荷的变化而变化的结论．     

Microcrystalline silicon: An emerging material for stable thin‐film transistors

Abstract— Top‐gate and bottom‐gate microcrystalline‐silicon thin‐film transistors (TFTs) have been produced at low temperature (150–250°C) by the standard radio‐frequency glow‐discharge technique using three preparation methods: the hydrogen dilution of silane in hydrogen, the layer‐by‐layer technique, and the use of SiF₄‐Ar‐H₂ feedstock. In all cases, a stable top‐gate TFT with mobility values around 1 cm²/V‐sec have been achieved, making them suitable for basic circuit on glass applications. Moreover, the use of SiF₄ gas combined with specific plasma treatments of the a‐SiN:H dielectric produces large columns, even at the interface with the dielectric. This leads to stable bottom‐gate TFTs, fully compatible with today's a‐Si:H production facilities, reaching mobility values up to 3 cm²/V‐sec. These devices are an interesting alternative to laser‐crystallized polysilicon thin films in a growing number of applications.     

基于改进粒子群算法的中药提取过程PID优化控制

提出了一种适合于中药提取过程的基于改进粒子群算法的PID优化控制方法;针对粒子群算法存在早熟和局部收敛的问题对算法进行了改进,采用一种非线性动态自适应方法作为惯性因子权值调整策略,使惯性权值随粒子目标值的变化而自动改变;将该法应用于中药提取温度控制系统PID控制器参数优化设计,首先利用广义Hermite-Biehler定理计算控制对象的PID控制器参数稳定域;然后在参数稳定域范围内采用改进粒子群算法寻优得到了满足指定性能指标(ITAE)最小的最佳控制器参数值;最后针对中药提取工段的温度控制二阶时滞系统进行了仿真,验证了该方法的有效性。     

压杆钢构件的抑制失稳研究

首先阐述了受压钢构件失稳被动控制的设计思路,介绍了几种典型失稳被动控制技术的相关研究进展,提出了几种新颖的失稳被动控制约束装置,最后总结了失稳被动控制技术的设计和分析计算要点、适用性以及在失稳控制研究中需要进一步研究的问题．     

三河发电厂脱硫系统有关设计细节优化的探讨

主要针对三河发电厂脱硫系统的一些设计细节问题进行了探讨,并提出了相应的优化措施,以期进一步提高三河发电厂脱硫系统的运行稳定性。     

真稳定类与辩论语义

稳定类语义和辨论语义是逻辑程序语义学研究方面突出的两种语义统一框架理论,它们统一了一些很重要的语义,因为它们有着不同的直觉和概念,它们的相互关系并不清楚。我们在它们最基础的概念层次上证明了,常规逻辑程序句法下二者是等价的,它们有着同样的语义统一能力。基于这个结果,我们为有前途的辨论语义指明一种迭代构造的方法。