阵列天线在OFDM系统下行链路中的应用

正交频分多址(OFDM:orthogonal frequency division multiplexing)技术由于其在多径环境下克服码间干扰的固有特点,在移动通信中已得到广泛地应用。利用阵列天线上行链路信号到达角估计实时信息,计算OFDM系统下行链路阵列天线权重,将阵列天线应用于下行链路中,最后给出系统误码率性能的计算机仿真结果。     

无线传感器网络MAC层协议的对比研究

无线传感器网络是二十一世纪新兴的网络技术，它的出现使网络的发展进入一个新的阶段。针对无线传感器网络MAC层协议的研究一直是人们普遍关注的问题。总结了近年来的研究成果并针对TDMA，IEEE802．15．4，S—MAC，T—MAC几种典型的MAC层协议进行了对比分析，根据其各自的优点提出将来工作的方向和建议。     

An efficient clustering scheme using support vector methods

Support vector clustering involves three steps—solving an optimization problem, identification of clusters and tuning of hyper-parameters. In this paper, we introduce a pre-processing step that eliminates data points from the training data that are not crucial for clustering. Pre-processing is efficiently implemented using the R*-tree data structure. Experiments on real-world and synthetic datasets show that pre-processing drastically decreases the run-time of the clustering algorithm. Also, in many cases reduction in the number of support vectors is achieved. Further, we suggest an improvement for the step of identification of clusters.     

硅尖阵列-敏感薄膜复合型阴极真空微电子压力传感器特性的测试

封装、测试了硅尖阵列-敏感薄膜复合型阴极的真空微电子压力传感器，在计算机模拟计算的基础上，对封装好的真空微电子压力传感器进行了实物测试，得出实物测试场发射电流曲线（开启电压低，发射电流曲线与计算机模拟曲线一样，电压45V时发射电流可达到86mA，平均每个硅尖为21μA）、压力特性曲线（呈线性变化，与计算机模拟计算的曲线相近）及灵敏度数据。电压1.5V即可测试并且其压力特性成线性变化，灵敏度为0.3μA/kPa。     

利用单片机实现的空气干燥器控制仪

为了满足不同生产实际的需要 ,介绍了利用单片机实现的空气干燥器控制仪的基本组成和工作原理 ,重点介绍了温度测量和A/D转换方法 ,进一步指出了提高测量准确度的途径。经实际应用表明 ,各项指标满足控制要求。     

定量确定纤维织构轴密度分布的矢量法

本文将大幅度减少衍射极图测试数目的织构分析矢量法应用于定量确定纤维织构材料的晶粒取向分布;采用蒙特卡罗方法计算系数矩阵σ_(pn)(hkl)。对立方晶系的研究结果表明,由一张极图甚至一张不完整极图即可准确地构建纤维轴密度分布图。     

溶胶—凝胶法制备基于荧光猝灭原理的光纤氧传感器在线监测水中溶解氧

利用氧分子对金属钌化合物的荧光具有猝灭作用的特性,构造出基于荧光猝灭原理的光纤氧传感器。就用于水中溶解氧在线监测的光纤光谱仪的搭建、传感器探头的设制及传感膜的制作过程进行探索,并对传感器的响应性能进行考察。结果表明以联吡啶钌等作为荧光指示剂以溶胶-凝胶法制备的传感膜对溶解氧的响应具有良好的可逆性,稳定性,较快的响应时间和较长的使用寿命。与标准法相对照,用本仪器系统测定了不同盐度的人工海水中的溶解氧浓度,两种方法在不同浓度水平下的溶解氧测定值均无显著性差异。本法的日内和日间RSD在1.7％～5.0％之间。     

基于人工神经网络的混合气体定量检测方法

将气体传感器阵列与人工神经网络相结合，设计了用于混合气体定量检测的人工嗅觉系统；构造了局部连接的前馈神经网络的结构和基于递推预报误差的网络训练算法；通过实验对CO，H2，CH4三种气体的混合物进行了分析，实验结果证明气体传感器阵列和人工神经网络用于混合气体定量检测是可行的。     

Accumulation of amplified target DNAs using thiol/biotin labeling, S1 nuclease, and ferrocene-streptavidin-magnetic system and a direct detection of specific DNA signals with screen printed gold electrode

Combinations of PCR-based amplification platform using 5′ thiolated and biotinylated specific primers, S1 nuclease-PCR products treatment, ferrocene-streptavidin (Fc-Stv)-magnetic binding for DNA accumulation, and screen printed gold electrode for the DNA allocation, were applied to Hoechst 33258-induced DNA aggregation and signals induction system for direct signals detection and DNA quantification in food samples. Thiolated and biotinylated at each 5′ terminus enabled DNA purification through S1 nuclease treatment for primers and non-specific DNA elimination and enabled DNA trapping with a ferrocene-streptavidin-magnetic system. This facilitated the accumulation of target DNAs at higher concentration, resulting in enhanced signals. After allocation of DNA on the surface of gold electrode via thiol binding, intensity of DNA signals through these treatments could be measured directly after being induced by Hoechst 33258. Wider amplitude changes in anodic current peaks between negative and positive samples (increasing from 3.70 to 10.10 μA) compared with those applied with no treatment combinations (decreasing from 3.92 to 1.23 μA) were observed. This enhancement of the signals allowed a greater efficiency of DNA quantification. When this combination was used for GMOs content estimation in reference samples, results revealed an improved accuracy from 66% to 96%. The combined biosensor system, although more costly than the standard Hoechst 33258/carbon electrode system, provided an alternative choice for DNA quantification, offering labor-free immobilization of probe onto electrode surface, easy test administration, and efficient semi-quantitative test without expensive instruments.     

Diffusion-controlled size-selective chloride ion sensing in the presence of bromide ion using a thin, nanoporous, plasma-polymerized coating on an Ag/AgCl electrode

We have developed a diffusion-controlled size-selective method for sensing chloride ion in the presence of bromide ion, based on a thin, nanoporous, plasma-polymerized coating of hexamethyldisiloxane on an Ag/AgCl electrode. Sub-nanometer-sized pores responsible for a highly cross-linked polymer network in the plasma-polymerized coating allowed diffusion-controlled permeation of chloride ion while blocking the larger bromide ion. An electrode coating of thickness greater than 70 nm enabled chloride detection in the concentration range 1-10 mM in the presence of 0.63 mM bromide ion. Advantages of this approach are: (1) simple design compared with ionophore-based strategies and (2) compatibility with microfabrication and mass production processes.