脱酮肟型有机硅建筑密封胶的研制

本文介绍了脱酮肟型有机硅建筑密封胶的配制原理、工艺、产品性能及其影响因素     

用增钙粉煤灰配制高强混凝土的试验研究

本文探讨了利用增钙粉煤灰配制高强混凝土的可行性。研究结果表明，增钙粉煤灰的品质，取代水泥率等因素对混凝土的性能产生直接影响，采用品质较好的增钙粉煤灰取代２０％左右的水泥（超量系数为１．２），可配制Ｃ６０等级的高强混凝土，其它物理力学性能均满足高强混凝土要求。     

减水剂对超低水泥Al_2O_3－Cr_2O_3ZrO_2质浇注料流变性能的影响

对添加三种有机高分子减水剂和两种聚磷酸盐碱水剂的Ａｌ２Ｏ３－Ｃｒ２Ｏ３－ＺｒＯ２质浇注料桨体与泥料流变参数进行对比。研究表明，在加有Ａｌ２Ｏ３、ＣｒＯ３超细粉，以纯铝酸钙水泥为结合剂的浇注料中，有机减水剂的作用效果更为显著。对减水剂的作用机理和作用规律以及ξ电位，流变参数和流动值的关系作了探讨。     

离子交换膜间水的电离及其应用

本文通过分析纯水的电离,讨论了普通电渗析(ED)和填充床电渗析(EDI)中水的电离现象及其相关 机理。EDI过程中水电离产生的H+和OH-离子可以自再生离子交换树脂。文中简单介绍了已得到产业化的EDI 技术和正在推广中的离子交换树脂的电再生技术。     

空心环管壳式换热器工业应用概况

本文概括介绍了空心环管壳式换热器自１９９１年以来在硫酸、石化以及空气压缩机制造行业的工业应用情况，在工业系统中所起的节能降耗作用，以及同国内外同类先进技术的比较。     

水泥棒磨机预粉磨技术的增产节能效果

随着水泥工业结构调整，传统的一级圈流短磨水泥粉磨系统已经难以满足高产、优质、低耗的产业政策要求，必须进行必要的技术改造。文章分析了一级圈流磨存在的技术问题及其产生原因，介绍了对其实施增产节能改造的系统工艺技术方案和主机设备的内部结构改造方案。从两个厂的改造实施情况看，技改效果显著。     

Moisture Distribution and Dewatering Efficiency for Wet Materials

This review paper summarizes current research efforts toward a comprehensive view of wet material dewatering, considering the binding energy as the strength to hold water, and rupture energy given to remove moisture from materials.     

Controlled release of insecticide carbaryl from sodium alginate,sodium alginate/gelatin,and sodium alginate/sodium carboxymethyl cellulose blend beads crosslinked with glutaraldehyde

Interpenetrating network polymeric beads of sodium alginate (NaAlg) and its blend with gelatin (gels) or sodium carboxymethyl cellulose (NaCMC) have been prepared by crosslinking with a common crosslinking agent, glutaraldehyde (GA), for the release of insecticide carbaryl (Carb). The prepared beads were characterized by Fourier transform infrared spectroscopy and scanning electron microscopy. Scanning electron microscopy confirmed the spherical nature and surface morphology of the particles. Bead characteristics, such as carbaryl entrapment efficiency, particle size, equilibrium swelling degree, and carbaryl release kinetics, were determined. The effects of the preparation conditions, such as Carb/NaAlg ratio, time of exposure to GA, blend ratio, and temperature of release medium on the carbaryl release, were investigated for 25 days at 25°C. It was observed that the carbaryl release decreased with increase in crosslinking of network, while it increased with increase in Carb/NaAlg ratio and temperature. The release of carbaryl also increased with increase in Gel or NaCMC content in the blend beads. The highest carbaryl release was found to be 100%, for the beads that were prepared with 1 : 1 NaAlg/Gel at 16 days. The diffusion coefficients have been calculated for the transport of insecticide through the polymeric beads, using initial time approximation method. These values were also consistent with the carbaryl release data. The carbaryl release from most of the bead formulations followed the Fickian trend. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 99: 1310–1319, 2006     

Hygrothermal aging of rubber‐modified and mineral‐filled dicyandiamide‐cured DGEBA epoxy resin. III. Dielectric spectroscopy investigation

The effects of moisture absorption on the dielectric properties of a rubber‐modified, mineral‐filled, epoxy resin based on the diglycidyl ether of bisphenol A cured with dicyandiamide are reported. Samples of the resin were aged by immersing in deionized water, or 5% w/w NaCl solution, at elevated temperatures. Dielectric measurements were carried out over the frequency range 10^?1 to 6 × 10⁵ Hz. A featureless dielectric spectrum was observed with both real and imaginary dielectric permittivity increasing with the amount of absorbed water. The change in the dielectric properties with absorption of water was independent of presence of salt, temperature of exposure, and aging history, although a hysteresis of the hydration–dehydration process was observed at low frequencies. Two types of absorbed water were observed—water molecularly dispersed within the epoxy matrix and clustered water in spherical microcavities. The time dependence of the real dielectric permittivity measured at 10 kHz was found to closely resemble that of the water absorption, which allowed the activation energy of diffusion to be calculated from both dielectric and gravimetric data. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 1011–1024, 2002; DOI 10.1002/app.10368     

凹凸棒粘土用作高水速凝注浆悬浮剂

以凹凸棒粘土作为高水速凝固化充填材料的悬浮稳定剂，考察了不同制浆机械对凹凸棒粘土制浆率的影响。采用高剪切混合乳化机预制的1％凹凸棒粘土浆配制高水速凝固化充填材料甲、已料单浆可获得满意的悬浮稳定效果。其充填体结石抗压强度早期发展迅速，后期持续增长。采用此工艺，注浆料的材料成本仅增加2％。