全文获取类型
收费全文 | 7499篇 |
免费 | 144篇 |
国内免费 | 107篇 |
专业分类
电工技术 | 140篇 |
综合类 | 187篇 |
化学工业 | 2154篇 |
金属工艺 | 339篇 |
机械仪表 | 189篇 |
建筑科学 | 1129篇 |
矿业工程 | 249篇 |
能源动力 | 177篇 |
轻工业 | 331篇 |
水利工程 | 326篇 |
石油天然气 | 131篇 |
武器工业 | 5篇 |
无线电 | 113篇 |
一般工业技术 | 313篇 |
冶金工业 | 843篇 |
原子能技术 | 158篇 |
自动化技术 | 966篇 |
出版年
2024年 | 3篇 |
2023年 | 46篇 |
2022年 | 72篇 |
2021年 | 96篇 |
2020年 | 106篇 |
2019年 | 107篇 |
2018年 | 111篇 |
2017年 | 104篇 |
2016年 | 171篇 |
2015年 | 167篇 |
2014年 | 284篇 |
2013年 | 313篇 |
2012年 | 283篇 |
2011年 | 506篇 |
2010年 | 451篇 |
2009年 | 520篇 |
2008年 | 409篇 |
2007年 | 493篇 |
2006年 | 512篇 |
2005年 | 409篇 |
2004年 | 403篇 |
2003年 | 380篇 |
2002年 | 278篇 |
2001年 | 211篇 |
2000年 | 173篇 |
1999年 | 146篇 |
1998年 | 104篇 |
1997年 | 116篇 |
1996年 | 103篇 |
1995年 | 113篇 |
1994年 | 80篇 |
1993年 | 82篇 |
1992年 | 62篇 |
1991年 | 67篇 |
1990年 | 53篇 |
1989年 | 36篇 |
1988年 | 34篇 |
1987年 | 35篇 |
1986年 | 41篇 |
1985年 | 27篇 |
1984年 | 12篇 |
1983年 | 5篇 |
1982年 | 6篇 |
1981年 | 3篇 |
1980年 | 14篇 |
1978年 | 1篇 |
1977年 | 1篇 |
1973年 | 1篇 |
排序方式: 共有7750条查询结果,搜索用时 437 毫秒
1.
使用钡盐法对铬废水处理,对p H值在废水中的初值、反映温度计量结果、重铬酸钾的浓度等,在回收六价铬的影响效果进行了分析。对废水中的六价铬使用了源自吸收的分光光度法回收。经过处理后,废水中的p H为8~9的时候,六价铬的回收在9%。废水中的六价铬随着其浓度不断上升增加。超过10℃的时候,六价铬的反应没有非常大的影响,但是当温度降低到10℃以下的时候,回收率就逐步下降了。经过处理之后,六价铬的浓度达到了0.276 7 mg/L,达到了相关规定的标准。 相似文献
2.
The use of ozone to increase the cation exchange capacity (CEC) of two chars produced from pyrolysis of Douglas fir (Pseudotsuga menziessii) and a control bituminous coal activated carbon (AC) is reported. Chars were produced from the wood fraction of Douglas fir (DFWC) and the bark (DFBC) at 500 °C using an auger driven reactor with a nitrogen sweep gas under mild vacuum. Five ozone treatment times, ranging from 5 min to 60 min, were investigated. The initial properties of each char were found to differ significantly from the other samples in terms of surface area, proximate composition, and elemental composition. DFWC did not show significant mass loss or temperature variation during ozone treatment; however, after 1 h of oxidation both DFBC and AC samples resulted in 20% and 30% mass loss, respectively, and reactor temperatures in excess of 60 °C. Analysis of the pore size distribution of each treatment shows that ozone treatment did not significantly affect small micropores after 30 min of treatment for any material, but did reduce the apparent surface area of mesopores. Increases in carboxylic groups were identified with ozone treatment and found to correlate strongly with changes in measured CEC. The formation of lactone was found to correlate positively with reactor temperature during oxidation. These results indicate that the properties of chars, including surface area, pore structure, and chemical composition, as well as reactor conditions strongly affect the ozone oxidation of chars. 相似文献
3.
《Contact lens & anterior eye》2020,43(1):54-59
PurposeTo determine whether orthokeratology (OK) induced treatment zone (TZ) diameter can be reduced by altering OK lens design, and if so the impact of modifying TZ diameter on relative peripheral refraction (RPR).Methods16 subjects (mean age 23.4 ± 1.5 years; 8 female) completed the study. Standard (Control) OK lens design (PJ, Capricornia, Australia) or a modified version (Test) where the back optic zone diameter was reduced, and back optic zone asphericity and intermediate lens curves were altered, were worn overnight only for 7-nights in a randomised double masked order, with a minimum 1-week wash out (no lens wear) between lens designs. Full correction of refractive error was targeted. Refraction; best corrected visual acuity (BCVA); RPR (Shin-Nippon NVision-k 5001) along the horizontal and vertical meridians; and corneal topography (Medmont E300) were measured before starting lens wear and in the morning after lens removal after the seventh night of lens wear for both lens designs. TZ diameter and decentration was calculated from corneal topography.ResultsAfter 7-nights of wear both lens designs created -2.00D refraction effect with no significant difference in refractive effect or change to BCVA between the designs. The Test design created a significantly smaller horizontal (4.78 ± 0.37 vs 5.70 ± 0.37 mm, p < 0.001) and vertical (5.09 ± 0.51 vs 5.92 ± 0.51 mm p < 0.001) TZ diameter. The TZ was decentered inferior temporal with no significant difference between designs. There was no significant difference between the lens designs in RPR along the horizontal and vertical meridians at any measurement period.ConclusionsOK induced TZ diameter can be reliably reduced by altering OK lens design without detrimentally effecting lens centration or refractive effect. Reducing TZ diameter did not alter RPR, though measurement artifacts could be responsible for masking an effect. Longitudinal studies are needed to assess whether smaller TZ OK lens designs increase efficacy for slowing progression of myopia. 相似文献
4.
The present study was carried out to evaluate the effects of ozone on rice grains for the following three conditions: saturation time, decay rate, and half-life of ozone. Experiments were performed in different bed thicknesses (5 and 10 cm) and moisture content (11.4 and 14.2% wb) at atmospheric conditions. The lowest saturation time of ozone was 119 min, with the concentration of 516 ppm for rice grains ozonated at 5-cm bed thickness with 11.4% (wb) moisture content. The decay rate kinetics of ozone obtained were consistent with a first-order model. Regarding the half-life of ozone, the lowest value obtained was 6.78 min for rice grains ozonated at 10-cm bed thickness with 14.2% (wb) moisture content. 相似文献
5.
根据洗浴废水的水质特征,采用原水→混凝沉淀-过滤→固定化生物活性炭(Immobilized Biological Activated Carbon,IBAC)→微滤膜(MF)→UV消毒→出水的工艺流程.混凝沉淀-过滤物化预处理单元可以有效地减少洗浴废水中的各类污染物.IBAC生化处理单元,实现有机污染物、LAS、浴臭等有效去除,是保证出水合格的根本措施.微滤膜发挥物理截留作用、UV消毒杀死细菌和总大肠菌群.出水水质达到<城市供水水质标准>(CJ/T 206-2005). 相似文献
6.
我公司使用天津华特DXDK-70型包装机4台,在生产中出现的主要问题及解决方法作了详尽阐述,以供同行探讨。 相似文献
7.
采用遥感技术与地面调查相结合的方法,组织多学科综合调查研究,对云南滇池流域水土流失状况及程度进行了调查分析。初步查明了引起水土流失灾害的原因并提出相应的防止对策。 相似文献
8.
威海市污水处理深海排放工程是为改善其水域环境而建设的一英包括市区排水系统,污水预处理厂,输水管道和海洋放流管系统在内的完整而典型的工程,因此其工程设计扣的经验将会对同类项目的设计与工程建设有所借鉴。 相似文献
9.
10.
Tatsuya Hanaoka Hisashi Ishitani Ryuji Matsuhashi Yoshikuni Yoshida 《Applied Energy》2002,72(3-4):705-721
The objective of this study is to evaluate the potential for recovering fluorocarbons as measures for the abatement of global warming. In this study, we focused on the three different kinds of fluorocarbons: CFCs, HCFCs and HFCs, and targeted refrigerant use because of the availability of relevant data. We first estimated future fluorocarbon emissions from the targeted appliances; we next compared those emissions in the units of CO2 equivalent to the level of CO2 emissions in 1990 from a quantitative point of view. As the result of this study, it was found that fluorocarbon emissions in 1999 and 2010 would be equal to approximately 7 and 3% of the level of CO2 emissions in 1990 respectively. Moreover, if we implement a 100% recovery rate in every recovery route, we can reduce a large amount of emissions which correspond to approximately 2–5% of the level of CO2 emissions in 1990, even if we take into account the energy-related CO2 emissions by the transportation and decomposition of fluorocarbons. 相似文献