SIP协议在VoIP终端的设计和实现

SIP是下一代网络中的重要协议,而基于SIP协议的VoIP业务已经对传统话音业务形成了重要的威胁,并成为各大运营商竞争的重点业务之一.概述了VoIP业务的发展现状,介绍了SIP协议的实体、消息机制以及它所提供的业务,通过对SIP协议的原理及工作流程的分析,论证了其在实现一个VoIP系统中的优势,在此基础上设计并实现了一个基于SIP协议的VoIP终端.     

基于C6711处理器cdma2000 1X系统前向信道信号的处理

在cdma20001x前向信道中,要对一段信号进行传送,一般选用QPSK调制,因为QPSK调制比QAM更适合噪音环境。采用TI6000系列的TMS320C6711芯片处理前向信道信号,可以对复杂性和实时性较高的信号做采集、量化、编码、调制等实时处理,主要功能通过软件编程实现,从而使系统具有结构灵活、可靠性高、可扩展等优点。     

1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

Cu-Mg/Al_2O_3催化乙醇和乙二胺合成N-乙基乙二胺

在固定床反应器内,乙醇和乙二胺经分子间催化胺化反应合成了N-乙基乙二胺(NEED),考察了一系列铜系催化剂的活性,并筛选出催化性能较好的Cu-Mg/A l2O3催化剂;通过X射线衍射和透射扫描电子显微镜方法表征了助剂Mg对Cu/A l2O3催化剂的改性作用;考察了助催化剂Mg含量、反应温度、反应压力、进料量和乙二胺含量等对Cu-Mg/A l2O3催化剂性能的影响。实验结果表明,Cu-Mg/A l2O3催化剂具有很好的活性和选择性;在200℃、3.0MPa、质量分数20%的乙二胺乙醇溶液、进料量1.0mL/m in的条件下,乙二胺的转化率为71.56%,产物NEED的选择性和收率分别为92.62%和69.86%;经过20 d的连续使用表明,Cu-Mg/A l2O3催化剂具有良好的稳定性。     

三网互联的几个关键技术

对三网互联的几个关键技术进行分析与研究，介绍利用IP技术解决有线电视网地址选择问题，探讨怎样将ATM技术与IP技术相互融合，使真正的信息高速公路成为现实，阐述利用H．323标准全面解决视频网络方案。     

Synchronous Full-Scan for Asynchronous Handshake Circuits

Handshake circuits form a special class of asynchronous circuits that has enabled the industrial exploitation of the asynchronous potential such as low power, low electromagnetic emission, and increased cryptographic security. In this paper we present a test solution for handshake circuits that brings synchronous test-quality to asynchronous circuits. We add a synchronous mode of operation to handshake circuits that allows full controllability and observability during test. This technique is demonstrated on some industrial examples and gives over 99% stuck-at fault coverage, using test-pattern generators developed for synchronous circuits. The paper describes how such a full-scan mode can be achieved, including an approach to minimize the number of dummy latches in case latches are used in the data path of the handshake circuit.     

抗乙肝病毒表面抗原PreS1(20-47)的单链抗体在转基因烟草根分泌物中的初步表达

为探索利用植物根分泌表达重组蛋白的可行性，构建了含有抗乙肝病毒表面抗原PreS1(20—47)单链抗体(ScFv)基因的表达载体。该ScFv基因转化烟草后在烟草根部细胞的细胞质和内质网中获得表达。实验结果表明，5’端融合ER导向信号肽的重组ScFv可通过根分泌表达。     

蓬莱19-3 FPSO和渤中25-1 FPSO设计的一些特点研究

通过多年在蓬莱19-3油田FPSO和渤中25-1油田FPSO设备维护和管理的经历,从船体、上部模块、单点系泊等方面,对这两艘FPSO上的一些系统和设备在设计方面各自的特点进行对比和分析     

BaxSr（1—x）TiO3多层膜椭偏光谱研究

用溶胶－凝胶技术在Bi(100）衬底上制备了单层和渐变型多层的BaxSr(1-X)TiO3薄膜，其膜层组分分别为：Ba0.7Sr0.3TiO3,Ba0.8Sr0.2TiO,Ba0.9Sr0.1TiO3,BaTiO3，对生长制备出的多层BaxSr(1-X)TiO3薄膜进行了变角度椭偏光谱测量，通过椭偏光谱解谱分析研究，首次得到了BaxSr(1-X)TiO3多层膜结构不同膜层的膜厚和光学常数，其结果显示：椭偏光谱分析得到的不同膜层的膜厚与卢瑟福背向散射测量得到的结果基本相符；渐变型多层膜中BaTiO3薄膜的折射率比单层BaTiO3薄膜折射率大许多，与体BaTiO3的折射率相接近，这说明渐变型多层膜中BaTiO3薄膜的光学性质与体材料的光学性质接近。     

微机械可调谐滤波器的研制

利用 Ga As/Al Ga As分布反馈 Bragg反射镜在 Ga As衬底上制作了一个微机械的调谐滤波器 .该器件在 7V调谐电压下调谐范围达28nm