00Crl8Nil0N奥氏体不锈钢200 - 600℃高温疲劳性能的研究

试验用00Cr18Ni10N钢（/%:0.018C,0.41Si,1.68Mn,18.18Cr,10.38Ni,0.16N）经1t EAF-AOD-ESR冶炼,锻成Φ30 mm材和1 050℃固溶处理,进行了00Cr18Ni10N钢200～600℃光滑（K_t=1）、缺口（K_t=3）的轴向高周疲劳性能研究,绘制了疲劳S-N曲线、计算了疲劳极限,并对疲劳试样的典型断口进行了SEM观察。结果表明,光滑试样的疲劳极限随试验温度升高而降低,缺口试样的疲劳极限对试验温度变化不敏感。当应力集中系数由K_t=1提高到K_t=3时,00Cr18Ni10N钢的200、400、600℃下10⁷周次条件疲劳极限分别从530、506、410 MPa,降低到323、370、392 MPa。表明在高温下00Cr18Ni10N钢存在疲劳极限对应力集中敏感,且应力集中敏感性随着试验温度的升高而降低。疲劳试样的断口形貌由疲劳源区、疲劳裂纹扩展区和瞬断区组成,疲劳起源于表面加工刀痕的不连续位置,呈韧性断裂特征。     

Zr对Cu—Zn—Al形状记忆合金相变的影响

采用示差扫描热分析(DSC)、X射线衍射及透射电镜,研究了Zr对Cu-Zn-Al合金高温相变、马氏体正逆转变以及形状记忆效应的影响。结果表明,添加Zr0.35wt-％时,能有效地抑制α,γ相析出,促进β_2→DO_3→18RM转变。(M_s-M_f)及(A_s-A_f)温度区间较窄,马氏体相变激活能最低,马氏体变体间界面的可动性好,形状记忆效应最佳。     

3Cr2W8V钢锻件表面裂纹的成因及预防措施

通过对难变形钢3Cr2W8V进行实验,证明了合理地选择锻造工艺参数,也是解决表面裂纹的重要途径之一。     

反应堆A0纯铝的点蚀模拟

测量A0纯铝在去离子水中的极化曲线用来模拟反应堆池壳的点蚀.研究表明A0纯铝在去离子水中很容易钝化.实验中用美国EG&G普林斯顿应用研究公司生产的273型恒电位/恒电流仪测量模拟孔电位,极化曲线表明模拟腐蚀坑处于钝化状态,即便是氧化膜破裂,腐蚀坑也发展得很慢.用pH计测量孔中pH的变化,并得到其工作曲线,此曲线表明带有氧化膜的点蚀坑坑内存在明显的酸化现象.并对A0铝池壳的服务寿命进行了估计.     

锡磷青铜合金水平连铸工艺参数的优化

铸造锡磷青铜合金组织中存在显微缩松、枝晶偏析和反偏析是冷加工报废的主要原因.通过连铸工艺参数的正交实验,建立了轧制成材率与主要工艺参数之间的神经网络描述,网络模型与遗传算法结合对工艺参数的组合进行了优化,改善了铸坯的组织,提高了轧制带材成材率.     

Influence of expandable graphite on fire resistance and water resistance of flame-retardant coatings

Expandable graphite (EG) coating and ammonium polyphosphate-pentaerythritol-melamine (APP-PER-MEL) coating were prepared. Thermal degradation and char formation of the coatings were investigated by differential thermal analysis (DTA), thermogravimetry (TG), X-ray diffraction (XRD), scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS). The results have shown that the anti-oxidation and fire-resistant properties of expandable graphite coating containing EG with size of 74 μm are better than those of APP-PER-MEL coating. The static immersion test was applied to study water resistance of the coatings, and the fire protection test and mechanical test were used to analyse heat insulation and mechanical properties of coatings before and after water immersion. The fire-resistant and mechanical properties of APP-PER-MEL coating were severely damaged by water immersion, whereas EG coating containing 8.5% EG with size of 74 μm could retain the good fire resistance even after 500 h water immersion.     

ZrC含量对TiC基金属陶瓷组织和性能的影响

真空烧结制备了TiC-ZrC-Co-Ni系金属陶瓷,研究了ZrC对TiC基金属陶瓷显微组织和室温力学性能的影响。结果表明:未加ZrC的TiC基金属陶瓷的显微组织表现为经典的黑芯-灰壳组织,硬质相形状多为球形;而加入ZrC后的金属陶瓷随着ZrC加入量的增多,组织逐渐细化,硬质相形状大多数为方形,硬质相与粘结相界面呈现直线,在黑芯周围出现白色球状(Ti,Zr)C固溶体。由于Co、Ni对ZrC的润湿性不理想,金属陶瓷的致密度随着ZrC含量的增加而下降,室温力学性能(抗弯强度、硬度、断裂韧性)也随之降低。     

Fluorinated Polyphosphazenes: A Survey

A general survey of fluorinated phosphazene polymers starting from their synthesis in 1965 to recent times is presented. Various types of fluorinated phosphazenes are described depending on the way fluorine atoms are connected to the polyphosphazene skeleton. The characterization, properties and practical utilization of these compounds in different domains are critically discussed.     

6-硝基-1,2-重氮氧基-4-萘磺酸及其杂质的高效液相色谱分析

本文以反相高效液相色谱对6-硝基-1，2-重氮氧基-4-茶磺酸及有机杂质进行了分析，选择了流动相、离子对、检测波长，研究了不同牌号ODS C18色谱柱的重现性，得到了6-硝基-1，2-重氮氧基-4-萘磺酸及杂质(1，2-重氮氧基-4-萘磺酸、8-硝基-1，2-重氮氧基-4-萘磺酸)的相关系数分别为：0.99956、0.99991、0.99317；标准偏差和变异系数分别为：0.214250％、0．016890％、0．564557％、0.012695%、0.488467％、0.014560％得到了准确度数据，确定了最小检出量。     

Intraspecific variation and interspecific differences in sex pheromones of sibling species inCtenopseustis obliquana complex

The specific status ofCtenopseustis obliquana pheromone-types I, II, and III has been more fully examined. Females of types I and III produce a mixture of (Z)-8- and (Z)-5-tetradecenyl acetates (Z8-14:Ac, Z5-14: Ac). The previously reported different ratios of these two components in females of the two types (type I=8020, III=9010) have been reinvestigated. The median ratios of each type differed significantly, although there was some overlap in the ranges of these ratios. A field cage trial showed that males of type III are attracted to females of type I, so the observed differences may be ascribed to intraspecific variation. In contrast to females of types I or III, females of type II produce Z5-14Ac but no Z8-14Ac. The electroantennogram (EAG) profile of antennae of type II males shows a maximum response to Z5-14Ac, while the EAG profiles of types I and III show a strong response to Z8-14Ac. In wind tunnel tests using mixtures of these two compounds, type II males prefer blends consisting of all or mostly Z5-14: Ac, while type I males showed a preference to a mix of 70% Z8-14Ac plus 30% Z5-14Ac. We found that type I males are attracted to type I females when offered a choice between type I and type II females in a field cage test and that type II males similarly prefer type II females. Males of types I and II have specialist cells for Z8-14Ac and Z5-14Ac but differ with respect to relative densities of these cells and to further cell types responsive to other alkenyl acetates. Type IIC. obliquana is considered therefore a sibling species of types I and III. In addition, the amount of Z5-14Ac produced by type II females varied geographically. Females from the North Island produced significantly less (median=1.2 ng) Z5-14Ac than females from the South Island (median=2.2 ng). Type II populations in the North Island morphologically resembled sympatric type I, rather than type II from the South Island and are designated as type II (North Island). Type II (North Island) populations have so far been found only at Rukuhia (near Hamilton) and from Kerikeri. In contrast, type II populations are sympatric with type III populations over much of the South Island. In a field cage trial, males of types II and II (North Island) were attracted to females of both II and II (North Island). We tentatively ascribe the differences between type II and type II (North Island) to intraspecific variation.