ANALYSIS OF EXPERIMENTAL AND NUMERICAL RESULTS OF A TURBULENT SWIRLING FLOW IN A TUBE

In many applications swirling flow is used to enhance heat and mass transfer. One of the problems of modelling a turbulent swirling flow is the choice of the turbulent closure model which is acceptable for engineering purposes. To evaluate which model performs best, numerical results are compared with experimental data. Local velocity measurements are carried out on a swirling flow in a circular tube. The measurement method is hot-wire anemometry combined with visualization techniques. The numerical analysis is carried out using the k-ε model and the Algebraic Stress Model. In the experiment a symmetrical swirl was observed, Comparing the experimental data with the numerical results shows that the Algebraic Stress Model represents the experimental data quite well, whereas the k-ε model fails.     

经食道心房调搏的放射性核素心血管造影

本文应用反符合电路剔除调搏脉冲干扰的方法,制成经食道心房调搏心电心音门电路触发装置,用于经食道心房调搏的核素心血管造影。参考Tzivoni标准,当逐级增加调搏心率至140次/min或亚极量心率后发现:冠心病人有调搏后EF降低;急性心肌梗塞病人EF减低更为明显,并呈室壁反向运动。因此,心房调搏核素心血管造影有助于冠心病,特别是心肌梗塞的诊断。     

The generation of surface roughness during slurry erosion-corrosion and its effect on the pitting potential

Results of experiments performed to isolate the effect of surface roughness generated during slurry erosion-corrosion of 304L stainless steel are presented. Surfaces prepared by grinding to different finishes show that increasing the roughness lowers the pitting potential in chloride solution. Subsequent erosion by an aqueous sand slurry then alters this pitting potential (E_p), as measured in the solution phase alone, in a manner dependent on the initial surface roughness. Surfaces which were initially rougher show a pronounced rise in _p after erosion, while those with an initially smoother finish show a fall in E_p after erosion. Measurement of E_p during erosion-corrosion does not fit either process, with values of _Ep lower than those predicted from the surface roughness alone.     

使用Visual C+ +实现串行通讯

以VisualC 为工具，探讨了在RS-232C接口协议下DTE设备之间通讯的实现问题。     

碳纳米管及稀土元素钇(Y)对高Ni含量Ti(C,N)基金属陶瓷组织与性能的影响

研究了不同含量的碳纳米管及0.8%稀土Y对高Ni含量Ti(C,N)基金属陶瓷组织性能的影响.将不同成分的试样分别于1400℃、1410 ℃、1420℃真空烧结,测试抗弯强度、洛氏硬度,观察背散射电子形貌、断口形貌并做能谱分析.结果表明,加入质量分数(下同)为0.8%Y及0.3%～1.0%的碳纳米管时,碳纳米管含量为0.5%的组织较均匀,芯壳结构明显,抗弯强度及硬度均较高.     

曲轴R处缺陷的超声探伤及定位问题的研究

针对曲轴R处缺陷的探伤和定位问题进行了探讨和研究,并设计了能对缺陷进行实时定位的程序.     

Intraspecific variation and interspecific differences in sex pheromones of sibling species inCtenopseustis obliquana complex

The specific status ofCtenopseustis obliquana pheromone-types I, II, and III has been more fully examined. Females of types I and III produce a mixture of (Z)-8- and (Z)-5-tetradecenyl acetates (Z8-14:Ac, Z5-14: Ac). The previously reported different ratios of these two components in females of the two types (type I=8020, III=9010) have been reinvestigated. The median ratios of each type differed significantly, although there was some overlap in the ranges of these ratios. A field cage trial showed that males of type III are attracted to females of type I, so the observed differences may be ascribed to intraspecific variation. In contrast to females of types I or III, females of type II produce Z5-14Ac but no Z8-14Ac. The electroantennogram (EAG) profile of antennae of type II males shows a maximum response to Z5-14Ac, while the EAG profiles of types I and III show a strong response to Z8-14Ac. In wind tunnel tests using mixtures of these two compounds, type II males prefer blends consisting of all or mostly Z5-14: Ac, while type I males showed a preference to a mix of 70% Z8-14Ac plus 30% Z5-14Ac. We found that type I males are attracted to type I females when offered a choice between type I and type II females in a field cage test and that type II males similarly prefer type II females. Males of types I and II have specialist cells for Z8-14Ac and Z5-14Ac but differ with respect to relative densities of these cells and to further cell types responsive to other alkenyl acetates. Type IIC. obliquana is considered therefore a sibling species of types I and III. In addition, the amount of Z5-14Ac produced by type II females varied geographically. Females from the North Island produced significantly less (median=1.2 ng) Z5-14Ac than females from the South Island (median=2.2 ng). Type II populations in the North Island morphologically resembled sympatric type I, rather than type II from the South Island and are designated as type II (North Island). Type II (North Island) populations have so far been found only at Rukuhia (near Hamilton) and from Kerikeri. In contrast, type II populations are sympatric with type III populations over much of the South Island. In a field cage trial, males of types II and II (North Island) were attracted to females of both II and II (North Island). We tentatively ascribe the differences between type II and type II (North Island) to intraspecific variation.     

百菌清及其三氟衍生物对番茄早疫病菌的室内抑菌活性比较

采用生长速率法测定了不同浓度的百菌清及其三氟衍生物对番茄早疫病菌Alternaria solani(Ell,et Mart.)Jones es Gmut的室内杀菌毒力。试验结果表明，百菌清及其三氟衍生物的ED50值分别为6089．89mg／L和156．43mg/L。，前者是后者的38．93倍。百菌清三氟衍生物的毒力明显高于百菌清。     

High resolution XPS characterization of chemical functionalised MWCNTs and SWCNTs

High resolution XPS analysis of chemical functionalised multi-wall carbon nanotubes (MWCNTs) and single wall carbon nanotubes (SWCNT) was done with ESCA300 (overall instrument resolution of 0.35 eV). Information to the degree of functionalisation was ascertained by argon ion bombardment of the samples followed by XPS analysis to detect the functional groups, the percentage atomic concentration of various elements present and whether or not the detected functional groups imposed a chemical shift on the CNT atoms. The results show that true chemical functionalisation was achieved and by argon ion bombardment these functional groups can be altered relative to the C 1s carbon atoms of the CNT. The choice of chemicals used for functionalisation, the techniques employed and the types of nanotubes treated are important factors in chemical characterisation. The carbon atom on the nanotube ring to which the functional group (atom) is bonded, the chirality of the CNT, the electronegativity of the functional group, the bond type and whether the CNT is single-wall or multi-wall, or cut (short) could play a role in determining the chemical shift on the CNTs atoms. These investigations are relevant to chemical functionalisation of carbon nanotubes for various applications for example DNA sensors and other biomedical sensors.     

Technological parameters that influence the production of ozone in A .D. C. Corona discharfe

Experiments using dry oxygen in a wire–to–cylinder ozone generator, submitted to D.C. corona discharges show that technological parameters (diameter and composition of wire and cylinder, length of cell, gas flow and transit time of the gas) greatly influence ozone production. The cell geometry to be used depends on the polarity of the D.C. voltage applied to the wire and, for a predetermined design, the maximum ozone production rate will be obtained by seeking the most suitable gas flow. Lining up a series of optimized cells can give significant results.