乳化剂种类与乳化炸药压力减敏关系研究

测量了含3种不同乳化剂的乳化炸药受冲击波作用前后的水中爆炸冲击波参数,依据这些参数计算出压力减敏程度.比较3种乳化炸药在冲击波作用后的压力减敏程度,结果表明在各个组分的含量和制造工艺完全相同的情况下,含有乳化剂B的乳化炸药最不容易发生压力减敏;此外,分析了乳化剂种类对乳化炸药压力减敏的影响机理,研究表明,除了敏化剂被破坏,局部破乳是乳化炸药压力减敏的重要原因.     

Mannans as stabilizers of oil-in-water beverage emulsions

The stabilizing effect of spruce galactoglucomannan (GGM) on a model beverage emulsion system was studied and compared to that of guar gum and locust bean gum galactomannans, konjac glucomannan, and corn arabinoxylan. In addition, guar gum was enzymatically modified in order to examine the effect of the degree of polymerization and the degree of substitution of galactomannans on emulsion stability. Use of GGM increased the turbidity of emulsions both immediately after preparation and after storage of up to 14 days at room temperature. GGM emulsions had higher turbidity than the emulsions containing other mannans. The initial turbidity increased with increasing GGM content, but after 14 days storage at room temperature, the turbidity was the highest for GGM/oil ratio of 0.10:1 when ethanol-precipitated GGM was used. Increasing the storage temperature to +45 °C led to rapid emulsion breakdown, but a decrease in storage temperature increased emulsion stability after 14 days. Confocal microscopy showed that the average particle size in the bottom part of GGM emulsions stored for 14 days was smaller than 1 μm. A low degree of polymerization and a high degree of substitution of the modified galactomannans were associated with a decrease in emulsion turbidity.     

Interfacial and emulsifying behaviour of crayfish protein isolate

The interfacial behaviour of adsorbed protein films constituted with a crayfish protein derivate that is typically produced as by-product from the food industry, has been studied at the air-water and oil-water interfaces. An analysis of the surface pressure under compression-expansion cycles of this protein was carried out as a function of time, concentration and pH (2 and 8). Besides, interfacial tension and adsorption kinetics also were determined as a function of time at different concentrations and pH values. Interfacial rheological properties were studied under dilatational deformations applied to a single droplet, either at the initial step of film formation or once the interfacial tension was at equilibrium and the film was completely formed. The contribution of the interfacial properties to the behaviour of oil-in-water emulsions stabilised with this protein derivative were also analysed. Finally, droplet size distributions obtained for concentrated emulsions stabilised by crayfish protein were analysed and related to the interfacial tension behaviour. We have demonstrated that crayfish proteins at pH 8 show higher solubility, smaller aggregates and better interfacial activity (higher surface pressure and lower interfacial tension) with higher interfacial viscoelasticity, than at pH 2. A two-dimensional model of the results showed that oil-water and air-water interfaces are clearly related to the improved stability of emulsion made with crayfish proteins at pH 8.     

乳化包埋法制备花椒精油微胶囊的研究

采用乳化包埋法制备花椒精油微胶囊,可减少花椒精油香气成分的挥发.以阿拉伯胶、大豆蛋白、麦芽糊精、可溶性淀粉、β-环状糊精为壁材,以包埋率为主要评定指标.在单因素试验基础上,采用L9(345)正交试验设计.结果表明,阿拉伯胶:麦芽糊精:大豆蛋白为3:9:4;壁材:芯材为3:1;乳化剂比例即蔗糖酯:单甘酯为1:1,其添加量为芯材的1%;固形物质量分数为26%,其包埋率可达59.76%,在模拟胃液中存在时间为1 h.     

Rheological properties and stability of model salad dressing emulsions prepared with a dry-heated soybean protein isolate–dextran mixture

The rheological characteristics of model salad dressing emulsions, incorporating a dry-heated soybean protein isolate (SPI)–dextran mixture as emulsifier, were investigated by applying dynamic rheometry tests in an attempt to probe the emulsion structure and to elucidate the mechanism of their stability against creaming. Both the viscoelastic properties and the creaming behaviour of the dressings were greatly influenced by the extent of protein–dextran conjugation and also by xanthan gum addition. The results are discussed in terms of emulsion droplet interactions which, depending on the extent of glyco-conjugation, may be dominated by depletion or ‘bridging’ flocculation effects and, thereby, influence the droplet network structure collapse during ageing.     

Response surface modeling for optimization of formulation variables and physical stability assessment of walnut oil-in-water beverage emulsions

The effect of Arabic gum content (5-10% w/w) and walnut-oil concentration (3-6% w/w) on properties of prepared walnut oil/water emulsion, including turbidity loss rate, density, size index, particle size and stability, was investigated using response surface methodology (RSM). For each response, a second-order polynomial model with high coefficient of determination (R²) values ranging from 0.907 to 0.989 was developed using multiple linear regression analysis. The lack of significant difference between the experimental and predicted values proved the adequacy of response surface equations for describing the physical changes of emulsions. An increase of Arabic gum content in range and initial concentration of walnut oil were associated with high emulsion stability and minimum droplet size. It can be concluded that RSM can determine the most suitable formulation (3% w/w walnut oil and 9.62% w/w Arabic gum) to achieve the highest stability in a developed beverage emulsion based on walnut oil.     

Influence of molecular character of chitosan on the adsorption of chitosan to oil droplet interfaces in an in vitro digestion model

The relationship between the adsorption of chitosan to oil droplet interfaces (surface adsorption) and the molecular characteristics of the chitosan (molecular weight and charge density) was examined using an in vitro digestion model. This model involved adding different concentrations (3–10 wt%) of oil droplets to a 0.1 wt% chitosan solution at pH 3 to simulate consumption of an oil-containing meal after ingestion of chitosan. The pH was then incrementally raised to investigate pH variations that occur when a food material passes through the human digestive tract at an oil concentration of 3%. The amount of chitosan adsorbed to the oil droplet interface decreased with decreasing molecular weight (MW) and with increasing degree of deacetylation (DDA): ≈132, 85, and 78 g of oil per g of chitosan for MWs of 200, 500 and 750 kDa (all 90% DDA), respectively; and, 47, 65, and 78 g of oil per g of chitosan for DDAs of 40%, 70% and 90% (all 750 kDa), respectively at pH 3. In addition, the extent of droplet aggregation and the nature of the aggregates formed (strong versus weak; large versus small) also depended on chitosan characteristics. The pH dependence of the interaction between anionic oil droplets and cationic chitosan molecules depended on both MW and DDA. Microscope images showed formation of large flocculated structures at pH > 7 except for low DDA chitosan which remained soluble at all pH levels. Our results may have important consequences for understanding the bioactivity of chitosan, and for designing functional food ingredients to reduce lipid digestion and absorption.     

Effect of concentrated flaxseed protein on the stability and rheological properties of soybean oil-in-water emulsions

Flaxseed protein concentrate containing-mucilage (FPCCM) was used to stabilize soybean oil-in-water emulsions. The effects of FPCCM concentration (0.5, 1.0, 1.5% w/v) and oil-phase volume fraction (5, 10, 20% v/v) on emulsion stability and rheological properties of the soybean oil-in-water emulsions were investigated. Z-average diameter, zeta-potential, creaming index and rheological properties of emulsions were determined. The result showed that FPCCM concentration significantly affected zeta-potential, creaming rate and emulsion viscosity. The increasing of FPCCM concentration led to a more negative charged droplet and a lower creaming rate. Oil-phase volume fraction significantly affected Z-average diameter, rheological properties, creaming index and creaming rate. With the increase of oil-phase volume fraction, both Z-average diameter and emulsion viscosity increased, while creaming index and creaming rate decreased. The rheological curve suggested that the emulsions were shear-thinning non-Newtonian fluids.     

Stability of oil‐in‐water emulsions as influenced by thermal treatment of whey protein dispersions or emulsions

Properties of whey protein concentrate stabilised emulsions were modified by protein and emulsion heat treatment (60–90 °C). All liquid emulsions were flocculated and the particle sizes showed bimodal size distributions. The state and surface properties of proteins and coexisting protein/aggregates in the system strongly determined the stability of heat‐modified whey protein concentrate stabilised emulsions. The whey protein particles of 122–342 nm that formed on protein heating enhanced the stability of highly concentrated emulsions. These particles stabilised protein‐heated emulsions in the way that is typical for Pickering emulsions. The emulsions heated at 80 and 90 °C gelled due to the aggregation of the protein‐coated oil droplets.     

乳状液膜法处理制浆黑液的研究现状

介绍了液膜分离技术应用于制浆黑液处理的方法和研究现状。