Multistage Zeolite Drying for Energy-Efficient Drying

This work discusses the potential of three multistage zeolite drying systems (counter-, co-, and cross-current) with a varying number of stages. The evaluation showed that for 2-4 stages with heat recovery the efficiency of the systems ranges between 80 and 90%. Additionally, by introducing a compressor, the latent heat in the exhaust air from the regenerator is recovered and used to heat the inlet air for an additional drying stage. As a result, for the counter-current drying system and compressor pressure 1.5-2 bar, a maximum energy efficiency of 120% is achieved, which results in halving the energy consumption compared to conventional drying systems.     

Mass transfer kinetics of neodymium(III) extraction by calix[4]arene carboxylic acid using a constant interfacial area cell with laminar flow

BACKGROUND: Thermodynamics and kinetics data are both important to explain the extraction property. In order to develop a novel separation technology superior to current extraction systems, many promising extractants have been developed including calixarene carboxylic acids. The extraction thermodynamics behavior of calix[4]arene carboxylic acids has been reported extensively. In this study, the mass transfer kinetics of neodymium(III) and the interfacial behavior of calix[4]arene carboxylic acid were investigated. RESULTS: The rate constant (K_ao) becomes constant when the stirring speed was controlled between 250 rpm and 400 rpm. The activation energy (E_a) was calculated to be 21·41 kJ mol^?1 or 88·17 kJ mol^?1 (dependent on temperature) from the slope of log K_ao against 1000/T. The linear relationship between the specific area and the extraction rate is the characteristic of an interfacial reaction control. The minimum bulk concentration of the extractant necessary to saturate the interface (C_min) is lower than 4·19 × 10^?4 mol L^?1. CONCLUSION: The effect of stirring speed, temperature, and species concentration on the extraction rate demonstrates that the extraction regime depends on the extraction conditions. The chemical reaction control governs the extraction regime at temperatures below 303 K and a mixed control regime occurs when the temperature is between 303 K and 318 K. The probable locale for the chemical reaction is at the liquid–liquid interface and the rate equation is deduced to be: ? d[Nd³⁺]_(a)/dt = k_f[Nd³⁺]_(a)[H₄A]_(o)^0·727[H⁺]_(a)^?0·978. The rate‐controlling step was suggested by the analysis of the experimental results. Copyright © 2008 Society of Chemical Industry     

Identification and modelling of aerobic hydrolysis – application of optimal experimental design

Hydrolysis mechanism plays a dominant role in the delicate balance of electron donor/electron acceptor ratios in BNR and EBPR systems as an important carbon source. In this study, the surface‐saturation‐type hydrolysis kinetics was investigated based on respirometric measurements, within the context of the theoretical and the practical identifiability of mathematical models. The identifiable parameters of a selected model were derived from respirograms. In addition, the information from the experiments was evaluated on the basis of Optimal Experimental Design (OED) methodology for different initial conditions of the batch respirometric experiment. © 2003 Society of Chemical Industry     

环己酮肟液相重排反应机理及动力学研究

研究了环己酮肟重排反应生成己内酰胺的机理及反应动力学方程。在建立用分光光度法测定环己酮肟浓度方法的基础上,实验研究了反应温度为20~45℃范围内的液相重排反应动力学。提出了此反应的化学反应动力学速率方程式: -r肟= k0exp (-E/RT)Ca肟Cb硫酸,其中环己酮肟反应级数a为2,硫酸反应级数b为1,活化能为-E/R = -19.86 kJmol-1, 频率因子k0为1.35×1027。通过实验研究证实了作为催化剂的硫酸参与重排反应的机理,认为重排反应过程中游离SO3不参与反应,仅作为水的吸收剂,此结论对环己酮肟液相重排反应的生产技术改造提供了有力依据,并在生产中得到了应用。     

Drying of Uncoated Paper with Gas-Fired Infrared Emitters—Optimum Emitters' Location Within a Paper Machine Drying Section

This article theoretically investigates the drying of uncoated paper with gas-fired infrared (IR) emitters installed within the drying section of a given commercial paper machine. Specifically, it presents the ideal location of two opposing IR emitters within the drying section. The ideal location of the two opposing IR emitters corresponds to the highest machine speed with specified average moisture content of paper sheet at the end of the drying section. This article also presents the average evaporation rate, temperature, and moisture content of the paper sheet as it travels through the drying section with the two opposing IR emitters operating at the optimum location. In addition, the temperature and moisture profiles in the sheet thickness direction, before and after the IR emitters, are provided. This article is not concerned with the potential effects of drying with IR emitters on paper sheet properties and machine runnability issues.     

Sorption of Acid Green 25 on chitosan: Influence of experimental parameters on uptake kinetics and sorption isotherms

Acid Green 25, which is a diazoic dye bearing two sulfonic groups, is efficiently sorbed on chitosan. The protonation of chitosan may explain the electrostatic attraction of this anionic dye and that its optimum pH is close to 3. Preliminary protonation of amine groups (obtained by contact with a sulfuric acid solution) reduced the variation of solution pH following sorbent addition but significantly reduced sorption performance: the maximum sorption capacity of raw chitosan, 525 mg dye/g (0.84 mmol dye/g), was halved by acidic preconditioning. The acidic conditioning also reduced the kinetic rate—the time necessary to reach equilibrium increased up to threefold depending on the experimental conditions. The size of sorbent particles influenced sorption kinetics and equilibrium because of resistance to intraparticle diffusion, but the sorption appeared to occur not only at the surface of the sorbent but also in the intraparticle network of the polymer. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1073–1080, 2003     

The process window for diamond deposition from the vapor phase with sulfur in the C–H–O feed gas mixtures

Theoretical predictions using a modified radical species ternary diagram for C–H–O system indicate that addition of sulfur expands the C–H–O gas phase compositional window for diamond deposition. Sulfur addition to no-growth domain increases the carbon super-saturation by binding the oxygen and the addition of sulfur to the non-diamond domain reduces the heavy carbon super-saturation by decreasing C_nH_m species concentration in the gas phase. The overall effect of sulfur addition to gas phase mixtures is characterized as that of oxygen addition to the C–H system, i.e. expansion of the compositional window over which diamond can be deposited from the gas phase. In addition, the increasing sulfur concentration to diamond domain feed gases beyond 2000 ppm did not affect the steady state gas phase composition but the quality of diamond was reduced.     

Non-steady-state model for kinetics of free radical polymerization, 4. Direct thermal initiation

This paper deals with the non-steady-state kinetics of direct thermal initiated polymerization. The initiation is assumed to be a bimolecular reaction of the monomer. The relationship between the radical concentration and the monomer conversion is rigorously derived. In further treatment a few very close approximations are introduced based on the fact that the number of monomer molecules reacting in the initiation step is much less than that consumed in the propagation step for a process producing high polymer, and the value of the rate constant for propagation or chain transfer is much lower than that for chain termination. Expressions for various molecular parameters, such as molecular weight distribution, number-average and weight-average degrees of polymerization, and dispersity, are given. Several numerical examples are provided.     

Significance of fluid regime in biological filtration

A dispersed flow model previously developed to study substrate utilization in unsaturated media was experimentally verified and its practical application was considered. For this purpose, measurements were made using tap water and a synthetic feed solution. The importance of the change in fluid regime as regards to the simultaneous transport and reaction within biological filters were demonstrated. The effect of drop formation and the breakage of liquid jets inside the filters on substrate utilization was also shown.     

环氧油一步合成的反应机理和动力学研究

研究了环氧油一步合成的反应机理和动力学；结合实验结果和理论分析动力学模型，首次提出：在适当的反应条件下，油脂的一步环氧化反应动力学模型可以表示为过氧酸生成反应动力学模型；其实验动力学模型方程为：ｒ０＝ｋ［Ｈ２Ｏ２］（０．９９）［ＨＯＡｃ］（０．９７），其中ｋ与催化剂用量有关。