Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

Oxidation of some aliphatic polyols on anodically deposited MnO2

Galvanostatic steady state current potential measurements were carried out for oxidation of a series of aliphatic alcohols having varying number of hydroxyl groups. The anodically deposited layer of MnO₂ on platinum was used as the electrode material. The deposit was characterised by scanning electron microscopy (SEM), energy dispersive X-ray analysis (EDAX) and electrode potential measurements. The catalytic role of MnO₂ in the electro-oxidation of alcohols was indicated by the chronopotentiograms and the cyclic voltammograms. An analysis of the electrochemical data indicated a catalytic EC mechanism in which Mn (V) is generated electrochemically and consumed chemically in succession. Based on this and the hydrogen bonding interaction between alcoholic hydroxyl groups and MnO₂ layer, a mechanism was proposed which accounts for the variation in the observed electrochemical reaction orders. Tafel behaviour was found to be followed only approximately. Current efficiency of the electrochemical oxidation of polyols was studied. Replacement of platinum by carbon as current collector was found to leave the electrocatalytic activity of the MnO₂ deposit practically unaltered.     

NMR studies of poly(2-hydroxy ethyl methacrylate-co-2-vinyl pyridine)

Copolymers of 2-hydroxy ethyl methacrylate-2-vinyl pyridine (H/V) of different composition were synthesized by free radical bulk polymerization using azobisisobutyronitrile (AIBN) as an initiator under nitrogen atmosphere. The copolymer compositions were calculated from ¹H NMR spectra. The reactivity ratios for H/V copolymers obtained from a linear Kelen-Tudos method (KT) and nonlinear error-in-variables method (EVM) are r_H = 0.50 ± 0.10, r_V = 1.04 ± 0.08 and r_H = 0.55, r_V = 1.06 respectively. The complete spectral assignment of methine, methylene, methyl, carbonyl, and aromatic carbon regions in term of compositional and configurational sequences of H/V copolymers were done with the help of ¹³C{¹H} NMR, distortionless enhancement by polarization transfer (DEPT), two-dimensional heteronuclear single quantum coherence (HSQC) along with total correlated spectroscopy (TOCSY). © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Synthesis and characterization of polyaniline films using Fenton reagent

The chemical oxidation of aniline to form polyaniline (PANI) films and powder samples was made using Fenton reagent as an oxidizing agent in aqueous sulfuric acid medium. The PANI films were monitored by using the quartz crystal microbalance and the electronic absorption techniques. The optimum concentration was determined and the results were justified by measuring the UV–vis absorption spectra for the in situ PANI films. The conductivity for the PANI films and powder samples, prepared in different conditions, was measured. Also, the IR spectra, X‐ray and the thermogravimetric analysis for the PANI powder formed in the bulk were measured and compared with the polymer prepared using ammonium peroxydisulfate. A preliminary investigation to the dielectric properties of the polymer powder was measured and discussed. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Coincidence Doppler broadening spectroscopy in polyvinyl chloride after doping with Al2O3

Coincidence Doppler broadening of annihilation radiation (CDBAR) and Vickers hardness techniques were performed to study pure Al₂O₃, pure polyvinyl chloride (PVC), and doped PVC with different concentrations of Al₂O₃ (10–50%). The CDBAR ratio curves with respect to pure PVC were presented and reflect the momentum distribution of all the samples. The peak around 14.5 ×10^?3 m_oC in the CDBAR ratio curves suggests a large contribution of positron annihilation with the Al₂O₃. There is a linear correlation between the height of this peak and the Al₂O₃ concentration. The S‐ and W‐parameters were extracted from the CDBAR spectra and increase with increasing the Al₂O₃ concentration showing discontinuity at 30% of Al₂O₃ concentration on PVC. The present data confirmed that there is no positronium formation in pure Al₂O₃ as a result of smaller S‐parameter. The Vickers hardness increases with increasing the Al₂O₃ concentration in PVC showing a linear dependence with two different slopes depend on the Al₂O₃ concentration range. A correlation between the Vickers hardness (macroscopic data) and the W‐parameter (microscopic data) was observed. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

橡胶Mooney—Rivlin模型材料系数对轴向刚度影响分析

在橡胶小变形范围内，采用理论推断的方法，得到在相同硬度下橡胶Mooney—Rivlin模型材料系数由C2／C1决定的关系式。并采用ABAQUS有限元软件分析的方法，结合橡胶轴向刚度常规解，分析了C2／C1不同值对橡胶轴向刚度的影响进行，结果显示其影响呈现一定规律性。     

Concomitant Crystallization of Copper(II) Sachharinato Complexes with 2-methylpyrazine as a Monomer and an One-dimensional Polymer: Syntheses,Crystal Structures,Spectroscopic and Thermal Properties

The reaction of [Cu(sac)₂(H₂O)₄] · 2H₂O with 2-methylpyrazine (mpyz) leads two complexes, concomitant crystallization of a mononuclear complex [Cu(sac)₂(mpyz)(H₂O)₂] (1) and a polymeric complex [Cu(sac)₂(μ-mpyz)]_n (2). Both complexes have been characterized by elemental analyses, magnetic measurements, FT-IR and ESR, TG-DTA and single-crystal X-ray diffraction analyses. Single-crystal X-ray analyses show that complex 1 consists of discrete molecules in which the copper(II) ions exhibits a square-pyramidal coordination geometry. The individual molecules of 1 are connected into a hydrogen-bonded chain structure, which is further assembled to form a three-dimensional network by π–π stacking interactions. Complex 2 is an 1D coordination polymer in which copper(II) centers are bridged by the mpyz ligand. The chains are further assembled to form two-dimensional frameworks by π–π and C–H···π stacking interactions.     

Isobaric vapor–liquid equilibria for mixtures of tetrahydrofuran, 2-propanol, and 2,2,4-trimethylpentane at 101.3 kPa

Vapor–liquid equilibrium (VLE) at 101.3 kPa have been determined for a ternary system (tetrahydofuran + 2-propanol + 2,2,4-trimethylpentane) and its constituent binary systems (tetrahydrofuran + 2-propanol, tetrahydrofuran + 2,2,4-trimethylpentane, and 2-propanol + 2,2,4-trimethylpentane). The activity coefficients of liquid mixtures were calculated from the modified Raoult's law. Thermodynamic consistency tests were performed for all VLE data. The VLE data of the binary mixtures and ternary mixtures were correlated using the Margules, Wilson, NRTL, and UNIQUAC activity-coefficient models. The models with their best-fitted interaction parameters of the binary systems were used to predict the ternary vapor–liquid equilibrium. All VLE data are also used to calculate the reduced excess molar Gibbs free energy g^E/RT and the deviations in the boiling point ΔT. The calculated quantities of g^E/RT and ΔT were fitted to variable-degree polynomials in terms of liquid composition.     

Characterization of supported Pd-Pt catalysts by chemical probes

The temperature programmed (palladium) hydride decomposition appeared very effective method for diagnosing the extent of alloying in Pd-Pt/SiO₂ catalysts. Introduction of Pt to Pd catalysts moves the TPHD peak gradually towards lower temperatures and the shift in hydride decomposition peak is accompanied by a decrease in the amount of released hydrogen. The catalysts prepared the direct redox method showed much better alloy homogeneity than the samples prepared by coimpregnation. The results of probing with other techniques, i.e. catalytic probing with hydrodechlorination of CCl₂F₂ and XRD, were in line with TPHD data. The catalytic probing showed the presence of synergistic effect, a clear indication of Pd-Pt mixing. XRD data of post-reaction samples showed carbon incorporation into Pd-rich phase, whereas separate Pt-rich phase did not experience any bulk carbiding.