Prediction of minimum fluidization velocity for vibrated fluidized bed

The prediction of minimum fluidization velocity for vibrated fluidized bed was performed. The Geldart group A and C particles were used as the fluidizing particles. The method based on Ergun equation was used to predict the minimum fluidization velocity. The calculated results were compared with the experimental data.The calculated results of minimum fluidization velocity are in good agreement with experimental data for Geldart group A particles. For group C particles, the difference between the calculated results and experimental data is large because of the formation of agglomerates. In this case, the determination of agglomerate diameter is considered to be necessary to predict the minimum fluidization velocity.     

大型下行式循环流化床反应器颗粒浓度分布研究

采用双光路光纤密度探头研究了内径418mm,高18米大型下行式循环流化床（其中下行床部分长度6．5m)反应器中的颗粒浓度分布，结果表明大直径下行床中颗粒浓度沿径向呈现中心均匀，近壁处存在高浓环形区的分布，这类似于小直径反应器中的结果，随着反应器直径的增加，颗粒浓度分布最大值的径向位置向边壁方向移动，即：当下行床放大时，中心颗粒浓度均匀分布区的面积占整个床层截面积的比例增大，在一种特殊设计的下行床边壁结构中测量了颗粒浓度沿径向的分布，实验结果说明边壁效应对下行床近壁区颗粒浓环的形成起到了重要作用，研究结果将有助于了解下行床反应的放大特性。     

基于1H NMR测定和基团贡献法预测石油馏分的热化学性质

测定了两种原油 2 0个石油馏分的¹H NMR谱和氢、碳元素含量等结构参数 ,以及馏分的燃烧焓、蒸发焓等热化学性质 .假设每个石油馏分仅由CH₃ 、CH₂ 、CH、ACH和C这 5种简单基团构成 ,基于¹H NMR测定和元素分析结果解出石油馏分平均分子结构中的基团数目 ,再用纯有机物的基团贡献法预测石油馏分的燃烧焓、蒸发焓 ,预测值与实验数据吻合良好     

Geochemical implications of trace elements and sulfur in the saturate, aromatic and resin fractions of crude oil from the Mara and Mara Oeste fields, Venezuela

Ten trace elements (Cr, Zn, Fe, Mn, Cu, Co, Ni, Mo, V and Sr) and sulfur were determined in the saturate, aromatic and resin fractions of 15 crude oils from Mara (DM) and Mara Oeste (DMO) fields of the Maracaibo Basin, Venezuela. The oils studied are classified as unaltered or altered by biodegradation. In the altered oil, the depletion of n-alkanes, the absence of isoprenoids and the presence of steranes and hopanes unaltered by biodegradation are indicative of moderate biodegradation. The elements Zn, Fe, Mn, Cu, Ni, and Sr were detected in the saturated hydrocarbon fraction; Cr and V were detected in the aromatic fraction in addition to the above elements; whereas the elements detected for the resin fraction were Cr, Zn, Fe, Cu, Ni, Mo, V, and Sr. Co was not detected in any fractions of the oils analyzed. Sulfur was found in all fractions of the oils studied. It was proposed that Fe, Zn, Sr, and Mn could have entered the oil during migration or Fe, Zn and Mn as pollutants during oil extraction. Cr and Cu may be of biological origin and Mo could be incorporated into the reservoir through bacteria. Only S, V, and Ni in the resin fractions can be used as indicators of the origin and correlation of Mara and Mara Oeste oils. Based on the results obtained in this work, it can be established that the V/(V+Ni) ratio in the resin fraction can be used as a correlation parameter, for these oils.     

A STUDY OF SILICONE OIL-IN-WATER EMULSIONS

Emulsions of silicone oil-in water were formed using a Brinkmann Polytron homogenizer with Igepal CO-530 as an emulsifier. Silicone viscosities ranged from 10 to 33,000 mPa.s at 25°C. Rheological characteristics and particle size analyses of silicone oil-in-water emulsions were studied. At high volume fraction of the dispersed phase (70%-75%), silicone oil-in-water emulsions were stable. At lower volume fractions (50%-60%), emulsions formed were less stable and the two phases easily separated in a few days. The emulsions formed with high volume fraction silicone oil show highly non-Newtonian behavior (shear thinning). Emulsions made with low viscosity oils had lower viscosities than those made from high viscosity oils. Relative viscosity-concentration data could be correlated by the Frankel and Acrivos Equation. Increasing the emulsifier concentration of 70% oil-in-water emulsions resulted in a decrease in mean droplet size and an increase in emulsion viscosity. Increasing the intensity of agitation also resulted in higher viscosity and smaller droplet size until a critical energy input above which droplet size increased. Emulsification with low shear mixing provides more control in decreasing mean droplet size with time.     

FCC汽油馏分在水热处理Zn/HZSM-5催化剂上的芳构化反应

制备了300 ℃、350 ℃、400 ℃和500 ℃不同水热处理温度下的Zn/HZSM-5催化剂，并用于FCC汽油馏分的芳构化反应。考察了水热处理温度对芳构化反应性能的影响，并与吡啶吸附红外光谱(FT-IR)相关联，研究了水热处理温度对催化剂表面酸性的影响。结果表明，水热处理Zn/HZSM-5的芳构化活性稳定性得以改善, 与未经水热处理的催化剂相比，400 ℃水热处理的Zn(2%)/HZSM-5催化剂芳构化反应36 h时，芳烃质量分数仍高达74.25%。随着水热处理温度的升高， B酸酸中心数在300～400 ℃变化不大，500 ℃显著减少，L酸酸中心数升高，400 ℃达到最大值后呈降低趋势，烯烃转化率、烷烃转化率和产品芳烃含量升高，水热处理400 ℃时均达到最大值，分别为83.62%、95.44%和92.23%，表明此时B酸中心和L酸中心比例协调性最佳。     

Oxidation by UV and Ozone of Organic Contaminants Dissolved in Deionized and Raw Mains Water

Organic contaminants dissolved in deionized pretreated and raw mains water were reacted with ultraviolet light and ozone. Ozone first was used for partial oxidation followed by ozone combined with ultraviolet radiation to produce total oxidation. The reduction of TOC level and direct oxidation of halogenated compounds were measured throughout the treatment process. The rate of TOC reduction was compared for ozone injected upstream and inside the reactor.     

谈谈C5的综合利用

本文简单地介绍了C5的产量和现状。主要讨论了C5综合利用，其中包括C5生产TAME、石油树脂、叔戊醇、加氢制戊烷、在超强酸条件合成金刚烷和某厂利用C5流程图。C5资源的合理利用不仅是有效利用石油资源的组成部分，也是改善产品结构，提高产品质量、增加企业效益的重要途径之一。     

The voidage function and effective drag force for fluidized beds

Here, an experimental investigation on the effective drag force in a conventional fluidized bed is presented. Two beds of different particle size distribution belonging to group B and group B/D powders were fluidized in air in a diameter column. The drag force on a particle has been calculated based on the measurement of particle velocity and concentration during pulse gas tests, using twin-plane electrical capacitance tomography. The validity of the voidage function “correction function”, (1−ε_s)ⁿ, for the reliable estimation of the effective drag force has been investigated. The parameter n shows substantial dependence on the relative particle Reynolds number , and the spatial variation of the effective static and hydrodynamic forces. It is also illustrated that, a simple correlation for the effective drag coefficient as function of the particle Reynolds number (Re_p), expressed implicitly in terms of the interstitial gas velocity, can serve in estimating the effective drag force in a real fluidization process. Analysis shows that, the calculated drag force is comparable to the particle weight, which enables a better understanding of the particle dynamics, and the degree of spatial segregation in a multi-sized particle bed mixture. The analogy presented in this paper could be extended to obtain a generalized correlation for the effective drag coefficient in a fluidized bed in terms of Re_p and the particle physical properties.     

Characterization of NOM and THM formation potential in eutrophic reservoir water

Resin adsorption technique with XAD-8 and XAD-4 was used to characterize the raw water from Erlong reservoir in Jilin province of China. The NOM chemical composition sequences of four organic fractions in the raw water,from high to low,are fulvic acid (FA) fraction,hydrophilic non-acid (HPINA) fraction,hydrophilic acid (HPIA) fraction,and humic acid (HA) fraction. Experimental results show that FA is the main precursor of THMFP among the four organic fractions. However,HA or hydrophobic acid exhibits the highest chlorination activity in forming THMs. It is also found that the value of FI/DOC or SUVA and the specific THMFP have better positive correlation. It is implied that certain source water has unique nature of NOM and DBPs.