渤海湾盆地复式油气聚集带高勘探程度区进一步挖潜的领域

渤海湾盆地复式油气聚集区经过了40年的勘探,目前已进入了高勘探程度区.油气聚集的复杂规律表明,渤海湾盆地仍具有巨大的资源潜力,进一步挖潜的领域非常广阔.以第三系为烃源岩的含油气层系的勘探精度仍有待于进一步提高,同时必须将以古生界、中生界和中上元古界为烃源岩的含油气层系作为今后挖潜的重要领域.渤海湾盆地任何层系都可能形成和聚集油气,因此仍有多种复杂的油气藏类型尚待进一步认识和发现.     

AlSn20Cu/Steel双金属板(带)复合轧制过程的厚度匹配

通过对AlSn20Cu/Steel双金属板(带)复合轧制过程变形区变形规律的分析，确定了轧制过程的总变形率与各分层变形率的关系，解决了实际生产中各分层原料的厚度匹配问题。     

SO_4~(2-)(S_2O_8~(2-))/Fe_2O_3-SiO_2固体超强酸对乙酸/丁醇酯化反应的催化性能研究

研究了SO2 -4/Fe2 O3 SiO2 固体超强酸对乙酸 /丁醇酯化反应的催化作用 ,得到合适的工艺条件 :复合氧化物中n(Fe)∶n(Si) =1∶2 ,浸渍的H2 SO4浓度 1mol/L ,5 5 0℃预焙烧活化 3h ,催化剂用量 0 .8g ,酯化反应时间 4h ,乙酸的转化率达 96 .3%。在此条件下制得S2 O2 -8/Fe2 O3 SiO2 固体超强酸催化剂 ,并考察了其催化活性 ,实验结果显示该固体超强酸具有更高的催化活性 ,乙酸转化率高达 98.6 %。     

碳/环氧复合材料的冲击拉伸

该文研究了T300碳纤维单向增强的环氧复合材料,在应变率从10~(-3)/s到10~3/s范围内的冲击拉伸行为.通过对实验数据进行拟合,得出该范围内材料对应变率具有弱的敏感性,表现在破坏强度及破坏应变随应变率增加不显著变化,平均模量几乎不受应变率的影响.分析了试件的几何尺寸效应,讨论了应力波作用对破坏形态的影响以及实验中观察到的拔出现象.从应变率在10~2～10~3/s附近材料行为某些非确定性,指出在更宽范围内了解其性能的必要性.     

Comparison of interfaces in Ti composites reinforced with uncoated and TiB2/C-coated SiC fibres

Interfaces play an important role in determining the mechanical properties of composite materials. The interfaces established between a titanium-alloy matrix (Ti-6Al-4V) and uncoated and TiB₂/C-coated SiC fibres are analysed by scanning electron microscopy, transmission electron microscopy and X-ray techniques. Emphasis is placed upon the interfacial morphology and microstructure, identification of reaction products, and the stability of the coating layer. Complex multi-reaction layers are observed frequently in the interfacial zones. Previous, often contradictory, reports about the interlayers are reviewed. Experimental observation demonstrates that the type and distribution of interlayers vary in a given system, due to prolonged treatment of the samples at temperature. The formation and distribution of the interlayers are discussed further, with respect to these and previous findings. Methods of reducing interfacial reactivity are discussed.     

Prediction of the elastic behaviour of hybrid and non-hybrid woven composites

A micromechanical model called MESOTEX is presented for prediction of the elastic behaviour of composites reinforced with non-hybrid weave (plain weave, satin weave and twill weave) and hybrid weave (hybrid plain weave and hybrid twill weave) fabrics. By using the classical thin laminate theory applied to each woven structure, this analytical model takes into account the strand undulations in the two directions and also integrates the geometrical and mechanical parameters of each constituent (resin, fill and warp strands). A representative volume is chosen for each woven composite and the fibre architecture is described by several functions. To determine the effectiveness of this analysis, the elastic properties predicted for each woven composite are compared with experimental results and results extracted from the literature. This correlation shows excellent agreement between measured and predicted values, with a very low calculation cost (CPU time of less than 0·01 s).     

Mechanical performance of ceramic matrix composite I-beams

Experimental studies have been performed on ceramic matrix composite (CMC) I-sections, which typify joint designs for CMC components. Axial loads and moments have been applied to activate delamination mechanisms. The maximum load bearing capacity has large variability, governed by the severity of manufacturing flaws located in the transition region of the I-section. This variability leads to an unsatisfactory design situation. Delaminations that form from these flaws arrest and behave in a stable manner, subject to a remanent load bearing capacity. This remanent capacity has minimal variability. Hence, design based on the remanent load would be robust. An expression for this design criterion is presented.     

黄河淤积粉土的两种复合稳定方案与性能对比

为探索路基工程中黄河淤积粉土的稳定技术和性能保障方案,针对德州齐河县境内的黄河淤积粉土,在乳化沥青复合稳定粉土(AE稳定土)的研究基础上,采用无机/有机复合材料制备出一种复合固化剂(FG固化剂),研究了AE稳定土和FG稳定土2种稳定方案下粉土的抗压强度性质、水稳定性和抗冻融能力;结合XRD、SEM表征技术,探讨了FG固化剂的稳定机理。研究认为,FG固化剂稳定土较AE稳定土有着更高的无侧限抗压强度、回弹模量和承载能力,水稳定性良好,在抗冻融能力上有着比AE稳定土更好的效果。XRD与SEM分析表明,FG固化剂提供了活性矿物质,其复合胶凝效应和填充增强保障了粉土的抗压强度,高分子物质起到粘结颗粒界面、填塞孔隙的作用,降低了内部孔隙率;两者造成土体的最大干密度变大;与AE稳定土的稳定机理不同。FG固化剂的使用为黄河粉土的稳定和工程应用提供了参考方法。     

新型陶瓷与熔融盐复合蓄热材料优化组合的数值模拟

将高温熔融盐相变蓄热材料和陶瓷固相蓄热材料进行复合 ,成功地研制成了能快速吸热和放热且蓄热密度高、蓄热量大的新型复合蓄热材料。分别以Al2 O3 ,MgO ,SiC为代表的陶瓷材料与 6 0LiF 40NaF ,5 0LiF 5 0KF ,6 0 .1NaCl 39.9MgCl2 ,LiH等为代表的 10余种高温熔融盐材料为复合研究对象 ,对复合蓄热材料的蓄热密度等与温度、复合材料中熔融盐的含量、材料种类间的关系进行了数值模拟研究 ,得到了对复合材料的优化设计具有指导意义的结论