掺杂Yb的TiO2光催化剂的制备和性能

采用溶胶-凝胶法制备了Yb掺杂TiO2纳米光催化剂,并通过XRD和BET等手段进行了表征.以对苯二甲酸作为探针分子,结合化学荧光技术研究了光催化剂表面羟基自由基的生成;并以苯酚为光催化降解反应模型化合物,考察了光催化剂的活性.测定了苯酚在TiO2和Yb掺杂TiO2光催化剂上的吸附常数.结果表明：Yb掺杂使TiO2的粒径减小,比表面积增大,同时导致羟基自由基的生成速率增大.Yb掺杂有利于反应底物在催化剂表面的吸附,Yb的最佳掺入量为Yb/Ti摩尔比=0.8%.     

Colour Centres and Energy Transfer in BaF2-xClx:Eu2+ Phosphors

The optical absorption spectra of BaF2-xClx:Eu2 after ultraviolet (UV) light excitation were investigated.The differences between the absorption spectra after and before excitation (DAS) were observed.The DAS increase at both the high and the low energy side of F band in BaF2-xClx:Eu2 after 245 nm UV light excitation.The bleach effect of UV light and the absorption of electrons in the valence band may account for the former and the formation of Fa centres (association of F(Cl-) centres), whose absorption band matches the HeNe laser better, may explain the latter.In the write-in process, the transfer of electrons is via tunneling.In the readout process, the transfer of electrons captured in F(F-) and Fa centres is more likely via tunneling, and that of F(Cl-) centres is more likely via conduction band.     

High Temperature Oxidation Behavior of La2O3-MosSi3/MoSi2 Composites

The oxidation behavior of 0. 8% La2O3- Mo5Si3/MoSi2 composites at 1200℃ in air was investigated. The results reveal that the oxidation resistance of the material with 0. 8% La2O3 and Mo5Si3 is impaired. The oxidation resistance is decreased with increasing Mo5Si3 content. The mass loss follows a linear law in the initial oxidation. With oxidation time prolonging, a continuous and dense oxidation scale prevents oxygen from diffusing increasing when and leads to mass change a Mo5Si3 content is less than 30%. However, the composite shows ＂PEST＂ with the addition of 40% Mo5Si3. With increasing Mo5Si3 content, the oxidation resistance of 0.8% La2O3- Mo5Si3/MoSi2 decreases. This attributes to the poor oxidation resistance of M05Si3 and the relative density decreasing of 0. 8% La2O3-Mo5Si3/MoSi2 composite.     

数据包络分析模型及其应用研究

通过对传统的C^2R模型进行研究并加以改进，建立了C2RHZ模型,利用有色金属矿采选业1993-2001年科技创新的相关数据进行了计算分析。说明了C^2RHZ模型的应用价值．     

Effect of calcination conditions on phase formation and particle size of nickel niobate powders synthesized by solid-state reaction

The solid-state mixed oxide method via a rapid vibro-milling technique is explored in the preparation of single-phase nickel niobate (NiNb₂O₆) powders. The formation of the NiNb₂O₆ phase in the calcined powders has been investigated as a function of calcination conditions by TG-DTA and XRD techniques. Morphology, particle size and chemical composition have been determined via a combination of SEM and EDX techniques. It has been found that the minor phases of unreacted NiO and Nb₂O₅ precursors and the Ni₄Nb₂O₉ phase tend to form together with the columbite NiNb₂O₆ phase, depending on calcination conditions. More importantly, it is seen that optimization of calcination conditions can lead to a single-phase NiNb₂O₆ in an orthorhombic phase.     

2-环戊基环戊酮香料的制备与应用

以尼龙酸副产物2-亚环戊基环戊酮为原料，液体镍为催化剂，催化加氢制得了2-环戊基环戊酮。经元素分析、GCMS、IR、^1HNMR、^13C NMR检测，认为结构正确，色谱纯度大于99．9％。大鼠口服LD50雄性5381．5mg／kg，雌性5087．5mg／kg。具有留兰香样的香气，可用作食用和日用香料。     

In situ formation of multi scale reinforcing phases to improve performance of Al2O3-SiC C castables

In order to improve the physical properties and slag corrosion resistance of refractory materials for hot metal pretreatment, different contents of composite metal powders (CMP) were introduced into Al2O3-SiC-C refractory castables. The effect of CMP on the microstructure, physical properties and slag corrosion resistance of Al2O3-SiC-C refractory castables were studied. The results show that the multi scale reinforcing phases including flake crystals, rod shaped fibers, filamentous fibers and whiskers are in situ formed in the samples with addition of CMP, which result to the improvement of the cold modulus of rupture and cold crushing strength. When the addition of CMP is 6 wt.%, the high temperature modulus of rupture increases by 231%, the thermal shock resistance increases by 77% after thermal shock by water cooling 5 times and the percentage of the slag resistant area reduces by 37.2%.     

以表面负载季铵盐阳离子型苯/丙乳胶粒为模板制备ZrO_2空心微球

以C9油与甲基丙烯酰氧乙基三甲基氯化胺的共聚物P(C9-DMC)为乳化剂制备苯/丙阳离子乳胶粒,并以其为模板,利用直接包覆法制备了由17 nm左右微晶体堆成的ZrO2空心微球。所制得的样品采用FT-IR、XRD、TEM和SEM等进行了表征。     

Potential tissue implants from the networks based on 1,5-dioxepan-2-one and ε-caprolactone

The synthesis and characterization of degradable polymeric networks for biomedical applications was performed. Cross-linked films of poly(ε-caprolactone) (PCL) and poly(1,5-dioxepan-2-one) (PDXO) having various mole fractions of monomers and different cross-link densities were successfully prepared using 2,2′-bis-(ε-caprolactone-4-yl) propane (BCP) as cross-linking agent. Reaction parameters were carefully examined to optimise the film-forming conditions. Networks obtained were elastomeric materials, easy to cast and remove from the mould. Effect of CL content and cross-link density on the final properties of the polymer network was evaluated. High CL content or degree of cross-linking led to increase in Young's modulus and decrease in elongation at break. An increase in crystalline domains in films having a higher CL content was observed by optical microscopy. A greater thermal stability was observed in films having a high CL content. The hydrophilicity of the materials could be tailored by changing the CL content. The surface of the films became rougher with higher CL content.     

Optical switching properties of RCo2-type alloy thin films by electrochemical hydrogenation

The switchable optical properties of Pd-protected RCo₂-type Ho_0.6Mm_0.4Co₂ alloy thin films have been investigated in a KOH electrolyte. The reversible optical switching has been carried out simultaneously by measuring transmitted light through the thin film during electrochemical charging–discharging of hydrogen. The dependence of switching speed and cyclic durability of the film on the charging and discharging current density as well as concentration of KOH electrolyte has been studied. In addition, cyclic voltammetric measurements have been performed to examine the hydride formation and decomposition reactions.