循环式活性污泥法处理炼油污水

研究为在炼油污水的CAST工艺的主反应区中 ,通过恰当控制pH值和DO(污水中溶解氧含量 )值 ,可以使硝化与反硝化反应同步进行 ,在去除COD ,BOD的同时 ,也可提高其脱氮效果 ,从而得出DO的最佳值为 0 .8mg/L ,pH为 7.3～ 7.7之间。     

Modelling the effects of human papillomavirus in cervical cells

Worldwide, cervical cancer is the second most common cancer in women, after breast cancer. The prevalence of this malignant disease is estimated at 1.4 million cases worldwide, causing about 290,000 deaths and 500,000 new cases per year, of which 80% correspond to women living in developing countries. In this work we propose a family of ordered models for basal cells of the cervix corresponding to different stages ranging from normal cells to the formation of precancerous lesions. We analyse the first member of the family analytically and for the second member we developed a non-standard numerical method in order to extract some biological information.     

碰撞式混合器的设计和使用

从反应注射成型过程对混合器的结构设计、操作条件等的要求出发，对碰撞式混合器的设计和使用应注意的问题进行了分析探讨，并提出了相应的解决办法和处理措施。     

Propagation of the Chain Explosive‐Decomposition Reaction in Silver Azide Crystals

The velocity of the chain explosivedecomposition reaction in silver azide whiskes has been measured (1500 m/sec). The measured velocity is identified as the propagation velocity of the diffusion front of holes generated in the course of explosive decomposition.     

Critical evaluation of coupling particle size distribution with the shrinking core model

The shrinking core model (SCM) is widely used to model fluid-solid reactions such as the leaching of metals from minerals. In most cases, however, the particle size distribution (PSD) of the solid material was disregarded. In this paper the erroneous shift in the control regime when neglecting PSD was quantified and the dependence of the shift on the coefficients of variation (CV) and the type of PSD was analysed. By coupling the SCM with a Gamma PSD, it was found that neglecting the PSD would shift the control regime from chemical reaction to inert/ash layer diffusion, when the CV was between 0.7 and 1.2. For a system controlled by liquid film diffusion, neglect of the PSD, would shift the control regime to chemical reaction when CV is between 0.3 and 0.7 or to inert/ash layer diffusion when CV is greater (0.9-1.5). It was therefore postulated that some researchers had unknowingly made invalid conclusions about the control regime due to the neglect of PSD. However, an inert/ash layer diffusion-controlled process was insensitive to the neglect of PSD. When CV<0.3, neglect of the PSD would not cause any erroneous shifts, irrespective of the control regime. Experimental data confirmed the observation. For a given CV, the deviation in the fraction reacted from the mono-PSD increases with CV and decreases with time. The maximum deviation, which occurs at the beginning, is about 10% with a gamma PSD of CV=0.3. The percent deviation is dependent of the type of PSDs. Gamma PSD gives the lowest deviation while Gaudin-Schuhmann results in the largest deviation (maxi. ∼19%, with CV=0.3) in the first half of dissolution process. Log-normal distribution gives a larger deviation than gamma but quickly approaches the latter with time. The deviation for Rosin-Rammler is between log-normal and Gaudin-Schuhmann. For systems with CV less than 0.3, the SCM can be fairly used without considering PSD. When CV is greater than 0.3, particularly in the early stage of a dissolution process with a PSD other than gamma, PSD should be included to avoid substantial errors.     

棉籽油间歇式酯交换反应动力学的研究

生物柴油(棉籽油甲酯)可以由棉籽油与甲醇在催化剂KOH存在下通过酯交换反应制得。故对棉籽油间歇式酯交换反应动力学进行了研究,并考察了反应温度和催化剂浓度对产物棉籽油甲酯浓度的影响。用液相色谱法分析棉籽油的组成;用气相色谱法分析产物中棉籽油甲酯的含量。由实验数据绘制的动力学曲线得到酯交换反应在开始阶段为准二级反应,以后紧接转为一级反应和零级反应,与文献报导的棕榈油酯交换反应动力学结果一致。由实验数据求出酯交换反应在开始阶段的动力学参数,35℃、45℃时的反应速率常数分别为0.9179Lmol-1min-1和1.049Lmol-1min-1,酯交换反应的活化能为10.88kJmol-1。根据实验结果得到棉籽油酯交换反应的最佳反应温度为45℃,最佳催化剂为1.1%KOH。     

Photoelectric conversion of photosynthetic reaction center in multilayered films fabricated by layer-by-layer assembly

Multilayered protein films which contained ordered layers of photosynthetic reaction center (RC) from Rhodobacter Sphaeroides (RS601) were assembled by means of alternate electrostatic adsorption with positively charged poly(diallyldimethylammonium chloride) (PDDA). The assembly of RC was monitored by spectrometry and photocurrent measurement. Linear film growth was observed up to about 20 cycles of adsorption. For the monolayer film, the photocurrent was about 8.5 nA cm⁻². For the multilayered film, the total photocurrent was about 77 nA cm⁻² for the 24-layer RC film, while the average photocurrent increment per adsorption cycle was about 3.2 nA cm⁻². The overall light-to-electricity conversion efficiency for a 24-layer film was about eight times higher than that for the monolayer one. The effects of electrode potential and pH on the photocurrent were also measured to illustrate the light-to-electric converting mechanism.     

Reactive compatibilization of PE/PS blends. Effect of copolymer chain length on interfacial adhesion and mechanical behavior

This paper deals with in situ compatibilization of PE/PS blends via Friedel-Crafts reaction, performed at the interphase. Two polyethylenes having different molecular weights, and the same PS, were used along a wide range of catalyst concentration. The influence of the graft copolymer architecture and content on the efficiency of blend compatibilization was studied. The emulsifying effect, morphological aspects and mechanical behavior were also assessed for these blends. The amount of copolymer formed increases with catalyst concentration and the short chain length fraction of the homopolymers. The high molecular weight (MW) copolymers behaved as better compatibilizers as they showed, at the cmc, greater graft copolymer concentration than the low MW ones. A substantial increase in interfacial adhesion and particle size reduction was observed, even at catalyst concentrations as low as 0.3 wt%. In correspondence, mechanical properties, like ductility and yield strength, were enhanced by the effect of this Friedel-Crafts reaction's compatibilization.     

抗氧剂3114合成反应热力学和动力学的研究

研究了常温溶剂法合成抗氧剂3114反应热力学和动力学过程。控制温度在117±2℃,研究结果表明,反应是零级反应,反应速率常数k=1.91×10-3/min,反应的平衡常数K=138.4(mol/L)-6,反应活化能Ea=1366.2J/mol。     

Correlation of reactivity and electrical resistivity of coke

A correlation between the reactivity and electrical resistivity of a series of cokes was determined using cokes prepared from blends of medium- and high-volatile coals. After correcting for the ash yield of the coke and the density of the resistivity specimen, a statistically significant relation between reactivity and resistivity was established. As the resistivity test requires much less time to perform than the reactivity test, it can be considered as an alternative approach to reactivity testing currently performed for quality control purposes.