Integration of solvent extraction and liquid membrane separation: An efficient tool for recovery of bio-active substances from botanicals

An integrated process based on simultaneous solid-liquid extraction and liquid membrane separation is proposed for recovery and isolation of valuable species from botanicals. This integration provides complete exhausting of the solid material even in the case of very low solubility of the specified solute in the extracting solvent. Selectivity of the liquid membrane ensures a preferential transport of the desired solute from the native extract into the strip solution, while the other co-extracted species remain predominantly in the native extract.     

Oxygen transport rate on Rhodococcus erythropolis cultures: Effect on growth and BDS capability

The influence of oxygen transport rate on Rhodococcus erythropolis cultures has been studied in a stirred tank bioreactor under different transport and uptake conditions. Oxygen uptake rate has been measured by applying a modified dynamic method and a kinetic model is proposed, obtaining the kinetic parameter values: specific maintenance and yield coefficients. The volumetric mass transfer coefficients under inert conditions, k_La, and during the bioprocess, K_La, have been determined. The values obtained are different and a biological enhancement factor E, has been considered. These parameters have been predicted by the theoretical model and good agreement with experimental data under the conditions studied has been found. The oxygen limitation has been expressed by a modified dimensionless Damköhler number, Da, the relationship between transport and biological reaction rates. This number decreases with increasing stirrer speed; that is, when mass transport resistance decreases. The efficiency of oxygen utilization can be determined by a film effectiveness factor, η. The effectiveness factor was found to be a strong function of Damköhler number and decrease with increasing Da. Furthermore, oxygen concentration into culture depends on the mass transfer and consumption rates. The theoretical model proposed is able to reasonably predict the evolution of dissolved oxygen concentration with time of cultivation.     

大规模定制下的质量控制系统框架设计

大规模定制为生产带来了变革和影响。针对新的生产方式的要求，根据推动大规模定制的过程方法和技术来分析他们对于质量控制产生的影响和要求，给出了大规模定制条件下的质量控制系统的建议，并给出了一个简要的系统模型。     

导数火焰原子吸收法对调味品中锌的测定

将微量脉冲进样技术和导数火焰原子吸收法结合，建立了测定调味品中锌含量的新方法。该方法的检出限为0．013μg／mL，精密度4．46％，回收率96．67～113．33。     

Nonaqueous Phase Liquid Pool Dissolution as a Function of Average Pore Water Velocity

Bench-scale reactor experiments were performed to study the dissolution of a binary naphthalene-in-nonane mixture nonaqueous phase liquid (NAPL) pool over a wide range of average pore water velocities, vx (≈0.1–60 m/day). Experimental NAPL pool dissolution flux values were determined using a steady-state mass balance approach. The experimental flux data were compared to model predictions made assuming either local equilibrium or mass-transfer limited conditions. The local equilibrium model could describe the trends in the average effluent concentration and dissolution flux with 0.110?m/day. Data determined to be under mass-transfer limited conditions were fit to the nonequilibrium model to estimate values for an overall mass-transfer coefficient. The calculated overall mass-transfer coefficients had an average value of 0.407 m/day and showed no correlation with vx, probably due to mass-transfer resistance becoming dominated by the diffusional resistance in the NAPL. These results suggest that the nonequilibrium approach is better suited for describing high velocity (vx>10?m/day) dissolution of multicomponent NAPL pools, and that flushing of groundwater at very high velocities may not be an effective approach for enhancing NAPL-pool dissolution flux.     

成像光谱技术发展的科学背景和现状

本文分析与阐述了成像光谱技术发展的科学背景与现状。     

用αβ谱仪测量人工αβ放射性气溶胶体积活度的试验研究

本文介绍了用αβ谱仪系统同时测量αβ谱、实现Ｒｎ／Ｔｈ子体补偿、确定超铀α核素气溶胶体积活度及人工放射性气溶胶总β体积活度的技术途径。利用ＲａＡ、ＲａＣ′ａ峰的二段时间计数可确定空气中ＲａＡ、ＲａＢ、ＲａＣ的气溶胶体积活度，相应的，也能给出ＲａＢ、ＲａＣ对总β计数的贡献。根据一般环境条件下的平衡比，用ＴｈＣ′的。计数修正Ｔｈ子体对αβ测量的影响。￣［２３９］ｐｕ或／和￣［２４１］Ａｍ人工核素的α计数，可通过两段时间分别扣除ＲａＡ、ＲａＣ′拖尾的方法确定；β计数分别扣除Ｒｎ／Ｔｈ子体β贡献即可确定。在本文规定的测量条件下，对室内天然Ｒｎ子体水平在１５Ｂｑ／ｍ￣３以下，超铀α核素气溶胶体积活度的测量下限可达到０．１Ｂｑ／ｍ￣３；即使在７５Ｂｑ／ｍ￣３环境下，人工核素总β的测量下限也可达ｌＢｑ／ｍ￣３以下。     

Effects of growth with ethanol on fermentation and membrane fluidity of Saccharomyces cerevisiae

Saccharomyces cerevisiae HSc was grown with ethanol at concentrations up to 10% (v/v). The immediate effects of additions of externally added ethanol on CO₂ production and O₂ consumption of washed organisms were studied by stopped-flow membrane inlet quadrupole mass spectrometry. Fermentative activities of organisms grown with ethanol (0–5% v/v) showed similar sensitivities to inhibition by ethanol, whereas those grown with 10% (v/v) ethanol had become protected and were markedly less sensitive. The fluidity of subcellular membrane fractions was measured by determination of the temperature dependence of the rotational order parameter of the spin label 5-doxyl stearic acid (free radical) by electron spin resonance. Mitochondria prepared from yeasts grown with 0, 7 and 9% (v/v) ethanol showed similar overall fluidity, although differences in temperature-dependent behaviour indicate altered lipid composition or lateral phase separations. On the other hand the microsomal fraction from organisms grown with 9% ethanol showed a remarkable increase in fluidity. These data suggest that the protective effects of growth with ethanol near the limit of tolerance on fermentative activities may arise from altered plasma membrane fluidity properties.     

Degassing of molten polymers

Degassing is a key-step in polymer processing. Low-molecular-weight components are removed from a polymeric system. The transport of these components takes place by diffusion to the polymer-vapour interface. This interface can be formed by free surfaces of single-phase polymer melts or by bubbles. In this study, the transport with and without bubble nucleation is investigated independently from each other in a special designed apparatus similar to a degassing extruder.The mass transport in thin films and in rotating pools with surface renewal is measured. High surface renewal rates and thick films enhance the mass transfer for single phase flow and bubbly flow. Dimensionless mass transfer coefficients are given as a function of the surface renewal rate, the area of the free surface and the total mass of the polymer. The conditions for bubble nucleation and foam formation are investigated. The bubble nucleation is observed in the rotating pool in the area of high shear velocity.     

Artificial Neural Network Modeling of Osmotic Dehydration Mass Transfer Kinetics of Fruits

Artificial neural network (ANN) models were developed for the prediction of transient moisture loss (ML) and solid gain (SG) in osmotic dehydration of fruits using process kinetics data from the literature. ANN models for ML and SG were developed based on data over a broad range of operating conditions and ten common processing variables: temperature and concentration of osmotic solution, immersion time, initial water and solid content of the fruit, porosity, surface area, characteristic length, solution-to-fruit mass ratio, and agitation level. The trained models were able to accurately predict the outputs with associated regression coefficients (r) of 0.96 and 0.93, respectively, for ML and SG. These ANN models performed much better than those obtained from linear multivariate regression analysis. The large number of process variables and their wide ranges considered along with their easy implementation in a spreadsheet make them very useful and practical for process design and control.