Investigation of structural properties of ITO thin films deposited on different substrates

The influence of the substrate nature on the structure and morphology of ITO thin films grown by thermal evaporation in vacuum is investigated. The as-prepared metal films with Sn/In molar ratio of 0.1 were subsequently annealed for 2 h at 723 K in air (to obtain tin doped indium oxide), then annealed in vacuum at 523 K, followed by UV irradiation (to reduce the electrical resistivity). Irrespective of substrate nature, XRD data evidence a (222) preferential orientation in films. Substrate nature, annealing in vacuum and UV irradiation influence the structure, morphology, optical, electrical and surface wetting properties of the films' surface.     

晶体硅薄膜电池制备技术及研究现状

晶体硅薄膜太阳电池近些年来得到广泛的研究和初步的商业化探索。根据所采用的晶体硅薄膜沉积工艺中温度范围的不同，晶体硅薄膜电池研究可分为高温路线和低温路线两个不同发展方向。本文分别从这两个方向综述了目前国外晶体硅薄膜电池制备技术的最新进展，最新实验室研究结果。报导了晶体硅薄膜电池商业化进展状况，指出了晶体硅薄膜电池实现产业化必须解决的问题。     

炼油化工装置技术改造的决策与实施

针对炼油和石化工业装置技术改造的特点，系统地总结了技术改造的类型和改造方案的制定、决策及实施的原则、程序和方法，指出对炼化装置实施技术改造是一项极其复杂、极具难度的系统工程，必须结合实际情况，以投资回报最大化为原则，通过深入细致地研究和反复比选优化改造方案，并结合现场情况制定切实、可靠、安全的实施方案。     

单壁碳纳米管的制备及生长特性研究

采用Fe/MgO作为催化剂 ,催化裂解CH4制备了较纯的单壁碳纳米管 ,用TEM和Raman对碳纳米管进行了表征 ,对不同生长温度下制备的碳纳米管Raman径向呼吸振动峰 (RBM)进行了分析 ,研究了生长温度对单壁碳纳米管生长特性和结构特性的影响     

钕电解阳极过电位的测定

用慢扫描示波法测定了钕电解的阳极过电位 .考察了温度、阳极电流密度、Nd2 O3添加量、电解质组成等因素对阳极过电位的影响 ,探讨了降低阳极过电位的可能途径 .结果表明 ,阳极过电位随阳极电流密度的增加而增大 ,随温度的升高而减小 ,一定范围内 ,阳极过电位与阳极电流密度的对数呈线性关系 ,满足塔菲尔方程 ;电解质中LiF和Nd2 O3浓度增加 ,阳极过电位降低 ;适当控制阳极电流密度、升高温度、增加电解质中LiF和Nd2 O3的浓度并尽可能减小极间距 ,均有利于降低阳极过电位     

唐钢ER70S-6焊丝钢的生产工艺研究及质量分析

介绍了唐钢ER70S-6焊丝钢的特点，对盘条质量进行了分析。对该钢化学成分、冶炼和轧制工艺进行了优化研究，使其综合性能明显改善。     

The aligned Si nanowires growth using MW plasma enhanced CVD

New and simple modification of vapor-liquid-solid process for Si nanowires growth based on microwave plasma enhanced chemical vapor deposition that uses solid-state Si target as a source of Si atoms was developed. The method was temperature and pressure controlled evaporation of solid phase of Si source in hydrogen microwave plasma. Aligned growth of Si nanowires was performed in local electric field by applying of constant negative bias to substrate holder. Deposited Si nanowires were studied by scanning electron microscopy (SEM), Raman and photoluminescence spectroscopy. Correlation between photoluminescence spectra and Si nanowires properties were studied.     

Deep‐UV Photochemistry and Patterning of (Aminoethylaminomethyl)phenethylsiloxane Self‐Assembled Monolayers

The 193 nm photochemistry of (aminoethylaminomethyl)phenethylsiloxane (PEDA) self‐assembled monolayers (SAMs) under ambient conditions is described. The primary photodegradation pathways at low exposure doses (< 100 mJ cm^–2) are benzylic C–N bond cleavage (ca. 68 %), with oxidation of the benzyl C to the aldehyde, and Si–C bond cleavage (ca. 32 %). Amine‐containing photoproducts released from the SAM during exposure remain physisorbed on the surface, where they undergo secondary photolysis leading to their complete degradation and removal after ca. 1200 mJ cm^–2. NaCl(aq) post‐exposure rinsing removes the physisorbed materials, showing that degradation of the original PEDA species (leaving Si–OH) is substantially complete after ca. 450 mJ cm^–2. Consequently, patterned, rinsed PEDA SAMs function as efficient templates for fabrication of high‐resolution, negative‐tone, electroless metal and DNA features with good selectivity at low dose (i.e., ca. 400 mJ cm^–2) via materials grafting to the intact amines remaining in the unirradiated PEDA SAM regions.     

A new bubble-point-pressure correlation for the binary LiBr/H2O solution

In accord with the increasing concern about the global environmental issues, the absorption refrigeration heat-pump systems are currently being considered very promising and attractive. For the purpose of supporting the advanced R&D technology in this area, we have developed a novel correlation to represent the bubble-point pressures of LiBr H₂O solutions. The developed correlation covers the most extensive range of validity ever proposed: 273–483 K for temperatures, 0.05 kPa to 1.0 MPa for pressures. and 29 76 wt% LiBr for concentrations.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994. Boulder, Colorado, U.S.A.