Ce3+离子对掺Er3+碲酸盐玻璃光谱性质的影响

研究了Ce3 + 对掺Er碲酸盐玻璃荧光光谱性质的影响 ,比较了不同的Ce3 + 掺杂浓度下Er3 + 离子荧光发光强度的变化 ,分析了Ce3 + 离子对Er3 + 离子作用的原理 ,应用经典方程计算了Er3 + 离子 4I1 1 / 2 能级的荧光寿命及其变化     

Changes in the dielectric relaxations of water in epoxy resin as a function of the extent of water ingress in carbon fibre composites

Dielectric relaxation measurements are reported over a frequency range from 10⁻¹ to 10⁹ Hz as a function of exposure time for an epoxy resin-carbon fibre composite, ageing at 60 °C in water. Investigation of the nature of the dipole relaxation of the water molecules, indicates the nature of their interaction with the polymer matrix. Analysis of the dielectric relaxation spectra allow identification of processes that can be attributed to ‘free’ and ‘bonded’ water, water in micro-cracking, located in carbon fibre disbonds and plasticizing the polymer matrix. Identification of the various types of location in which water exists was aided by use of the N_g factor from the Kirkwood-Frölich equation, which describes the constraints on free dipole ration nature imposed by the environment in which it is located. These data indicate the power of the dielectric technique for quantitative analysis of water ingress into epoxy composites.     

Electrical characterization of waterside corrosion films formed on ZrNb(1%)O(0.13%)

Oxide films formed by water oxidation at 360°C on ZrNb(1%)O(0.13%) for several durations (50-300 days) were studied by impedance spectroscopy (IS) in gaseous atmosphere. The electrical behavior of oxide layers was investigated as a function of the temperature (25-300°C) at constant oxygen partial pressure (0.3 Pa). Cole-Cole diagrams suggest a frequency-temperature equivalence. A simple electrical model has been derived from the as-deduced 14 decade master curve. Equivalent circuit includes a series association of two layers exhibiting different dielectric properties: a dense layer near the oxide-metal interface and a porous layer at the waterside. Electronic conductivity is predominant within the whole temperature range, but ionic contribution was proposed to increase for temperature higher than 170°C. During the parabolic oxidation step, the oxide thickness of the barrier layer increases but oxide growth would not be only a geometrical one. The kinetic modification to a constant oxidation rate was observed to be correlated to the increase of the dense layer thickness. Such a behavior suggests that the mechanism controlling oxidation rate is not a pure mechanism of oxygen diffusion through this layer. Finally, a qualitative model of activated electrons transport based on an hopping mechanism was proposed in order to take into account that the Arrhenius diagrams of both total conductivity and dispersion factor are characterized by a break point with two activation energy values.     

Characterization of edible oils,butters and margarines by Fourier transform infrared spectroscopy with attenuated total reflectance

The combination of attenuated total reflectance (ATR) and mid-infrared spectroscopy (MIRS) with statistical multidimensional techniques made it possible to extract relevant information from MIR spectra of lipid-rich food products. Wavenumber assignments for typical functional groups in fatty acids were made for standard fatty acids: Absorption bands around 1745 cm⁻¹, 2853 cm⁻¹, 2954 cm⁻¹, 3005 cm⁻¹, 966 cm⁻¹, 3450 cm⁻¹ and 1640 cm⁻¹ are due to absorption of the carbonyl group, C−H stretch, =CH double bonds of lipids and O−H of lipids, respectively. In lipid-rich food products, some bands are modified. Water strongly absorbs in the region of 3600–3000 cm⁻¹ and at 1650 cm⁻¹ in butters and margarines, allowing one to rapidly differentiate the foods as function of their water content. Principal component analysis was used to emphasize the differences between spectra and to rapidly classify 27 commercial samples of oils, butters and margarines. As the MIR spectra contain information about carbonyl groups and double bonds, the foods were classified with ATR-MIR, in agreement with their degree of esterification and their degree of unsaturation as determined from gas-liquid chromatography analysis. However, it was difficult to differentiate the studied food products in terms of their average chainlength.     

Possible tactics to improve the growth of single-walled carbon nanotubes by chemical vapor deposition

The growth time, growth mode and the method of preparing the supported catalysts play an important role in the growth of single-walled nanotubes (SWNTs). Their effects on the chemical vapor deposition (CVD) growth of SWNTs with MgO-supported catalysts were investigated in this study. It is shown that the growth rate of SWNTs was large during the initial few minutes of growth, however the quality of the tubes was low owing to the formation of many defects. Long term growth may favor the formation of tubes with high quality and high yield, but the introduction of other forms of carbon (impurities) is also unavoidable. There was a balance between the increase in yield and quality and sacrifice of the purity during growth of SWNTs. MgO-supported catalysts prepared by the co-precipitation method were found to be more effective for the synthesis of SWNTs than those prepared by the widely used impregnation method. The size and dispersion state of the catalyst were found to be crucial in enhancing the growth of SWNTs. In addition, growth on the surface of SWNTs over nanosized catalyst films was shown to be more favorable for the synthesis of tube products with higher quality, yield and purity.     

A study on the interaction between ibuprofen and bilayer lipid membrane

Ibuprofen is a well-known nonsteroidal anti-inflammatory drug, which can interact with lipid membranes. In this paper, the interaction of ibuprofen with bilayer lipid membrane was studied by UV-vis spectroscopy, cyclic voltammetry and AC impedance spectroscopy. UV-vis spectroscopy data indicated directly that ibuprofen could interact with lipid vesicles. In electrochemical experiments, ibuprofen displayed a biphasic behavior on bilayer lipid membrane supported on a glassy carbon electrode. It could stabilize the lipid membrane in low concentration, while it induced defects formation, even removed off bilayer lipid membrane from the surface of the electrode with increasing concentration. The mechanism about the interaction between ibuprofen and supported bilayer lipid membrane was discussed.     

Temperature Dependence of the Raman Spectrum in Lithium Oxide Single Crystal

Temperature dependence of the Raman spectrum of lithium oxide single crystal has been measured over a temperature range of 80 to 1073 K. The frequency shift and the line width of the Raman spectrum in lithium oxide were about 531 and 4.5 cm^-1 at 80 K, respectively. At 1073 K, the frequency shift and the line width attained the values of 464 and 112 cm^-1, respectively. The strong temperature dependence of the frequency shift and line width was compared with data from some crystals with a fluorite structure.     

Understanding chemical reactions between carbons and NaOH and KOH: An insight into the chemical activation mechanism

Direct mixing of an anthracite with hydroxides (KOH or NaOH) and heat treatment up to 730 °C has shown to be a very good activation procedure to obtain activated carbons with very high surface areas and high micropore volumes. The reactions involved during the heat treatment of these hydroxide/anthracite mixtures have been analysed to deep into the fundamental of the knowledge of this chemical activation process, that has not been studied before. For this purpose, the present paper analyses the drying process, the atmosphere during the carbonisation, the chemical state of the activating agents (NaOH, KOH and Na₂CO₃) and the chemical reactions occurring during the heat treatment which have been followed by FTIR and TPD. The analysis of our results allows us to conclude that steam is a good atmosphere for the carbonisation process, alone or joined with nitrogen, but not as good as pure nitrogen. On the other hand, during the activation process, the presence of CO₂ should be avoided because it does not develop porosity. The reactions, and chemical changes, involved during this chemical process are discussed both from a thermodynamical point of view as well as identifying the reaction products (H₂ by TPD and Na₂CO₃ by FTIR). As a result, this paper helps to cover the present lack of understanding of the fundamentals of the reactions of an anthracite with hydroxides which are necessary to understand the activation of the material.