888脱硫催化剂在焦炉煤气脱硫中的应用

针对焦炉煤气H2S含量超标问题,通过优化煤气脱硫工艺,改造脱硫设备,选用新型高效888脱硫催化剂,生产出合格城市煤气,解决了公司长期煤气H2S含量超标的难题。     

FCC汽油馏分在水热处理Zn/HZSM-5催化剂上的芳构化反应

制备了300 ℃、350 ℃、400 ℃和500 ℃不同水热处理温度下的Zn/HZSM-5催化剂，并用于FCC汽油馏分的芳构化反应。考察了水热处理温度对芳构化反应性能的影响，并与吡啶吸附红外光谱(FT-IR)相关联，研究了水热处理温度对催化剂表面酸性的影响。结果表明，水热处理Zn/HZSM-5的芳构化活性稳定性得以改善, 与未经水热处理的催化剂相比，400 ℃水热处理的Zn(2%)/HZSM-5催化剂芳构化反应36 h时，芳烃质量分数仍高达74.25%。随着水热处理温度的升高， B酸酸中心数在300～400 ℃变化不大，500 ℃显著减少，L酸酸中心数升高，400 ℃达到最大值后呈降低趋势，烯烃转化率、烷烃转化率和产品芳烃含量升高，水热处理400 ℃时均达到最大值，分别为83.62%、95.44%和92.23%，表明此时B酸中心和L酸中心比例协调性最佳。     

The effect of waste oil-cracking catalyst on the compressive strength of cement pastes and mortars

Epcat, one of the spent fluid catalytic cracking (FCC) catalysts from oil-cracking refineries, shows pozzolanic activity. In this study, pastes and mortars with Epcat were prepared and cured, and their compressive strengths after 3, 7 and 28 curing days were measured. The water/binder (W/B) ratios were 0.2, 0.25 and 0.3, and the replacement levels of cement by Epcat were 0, 5, 10 and 15 wt.%. Proper amount of superplasticizer was added into each mix to ensure similar workability.The results indicate that the presence of Epcat would increase the compressive strength of mortars substantially, but increase the compressive strength of the related pastes only slightly. Epcat mortars with W/B=0.25 show more strength-enhancing effect than those with W/B=0.3, and this effect increases with the catalyst content. Therefore, the mix (W/B=0.25) incorporated 15% Epcat exhibits the greatest compressive strength (92.3 MPa). For mortars with W/B=0.2, the strength-enhancing effect occurs only for those containing 5% catalyst; this effect becomes unclear when mixes containing 10% Epcat or more because high dosage of superplasticizer was added in obtaining proper workability and that affects the strength development. The improvement in the mechanical properties of mortars is attributed to the increase in the hydrated cement paste itself and, more importantly, improved bonds between the cement paste and aggregate.     

Hydrocarbon synthesis over sulfide catalysts. Break-down of the Anderson-Schulz-Flory distribution

The kinetics of hydrocarbon synthesis over sulfide-based catalysts was studied. It appears that the formation of methane follows another reaction path than that of higher hydrocarbons. This might explain the very high selectivities for ethane and propane as compared with conventional Fischer-Tropsch catalysts. Reference is made to testing of the catalysts at industrial conditions.     

一步法制二甲醚工艺及催化剂的研究

本文采用共沉淀沉积法制备了一步法合成二甲醚的双功能催化剂，并在固定床高压流动反应装置上对其催化性能进行研究，考察了MnO2助剂对Cu—ZnO—ZrO2／HZSM—5催化剂性能的影响以及工艺条件对二甲醚合成的影响。采用TPR、XRD等测试方法对催化剂进行了表征，结果证明：MnO2助剂的加入，能够增加活性中心数量，提高催化剂的活性。     

EFFICIENT DESIGNS FOR NONLINEAR MODELING

In the modeling of physical systems, such as chemical reactions, nonlinear models in a set of unknown parameters are commonly developed. Using the method of least squares for model fitting the efficiency of the process is measured by the large sample variance of the parameter estimates. Designs which yield desirable properties in the linear case, such as factorial and central composite designs, are often utilized in the nonlinear model setting. In this paper a method for transforming these standard designs, yielding more efficient estimators, in the nonlinear model case is proposed. The procedure is demonstrated on a typical kinetic reaction model.     

NH3-SCR of NO at low temperatures over sulphated vanadia on carbon-coated monoliths: Effect of H2O and SO2 traces in the gas feed

The objective of this research is to asses the impact of the addition of H₂O, SO₂, and both in the SCR of NO at low temperatures over sulphated vanadia on carbon-coated monoliths. The sulphated catalyst keeps a 100% conversion and total selectivity to N₂ in the low temperature range, i.e. 473–500 K, when either H₂O or SO₂ is added to the gas feed. However, a decline of steady state conversion and selectivity occurs when both H₂O and SO₂ are added simultaneously because H₂O speeds up the deposition of ammonium sulphate salts. This decrease of catalyst performance is reversed when the reaction is carried out under dry conditions at temperatures higher than 473 K but not at lower temperature (453 K). Thus, the catalyst has demonstrated to be a good candidate for the SCR of NO at low temperatures even in stack gases containing traces of undesired components.     

低雾化低挥发性汽车用新型聚氨酯泡沫塑料助剂

康普顿公司开发了一系列适用于消除或减少汽车内饰件中胺扩散或雾化的添加剂，其中包括快速、有效的生产用零扩散催化剂和低雾化表面活性剂。该系列添加剂能大大降低泡沫制品中的胺扩散，与异氰酸酯和多元醇原料能组成最佳组合，以保持良好的泡沫物理性能。     

双峰分子量分布聚乙烯的研究进展

双峰聚乙烯是目前用途很广、市场前景很好的一种通用树脂。国内外双峰分子量分布聚乙烯研究取得了很大进展，重点领域为双峰分子量分布聚乙烯制备工艺和催化剂的研究。双峰聚乙烯具有优异的性能，为进一步开拓市场，我国应着力开展这方面的研究开发生产工作。     

超细CaCO3与金属氧化物M2O3对Al/AP/HTPB推进剂燃烧的催化协同效应研究

对超细及市售ＣａＣＯ３在低含量（≤１％）的情况下对丁羟推进剂燃烧性能的影响进行了研究，结果发现ＣａＣＯ３低含量时可提高推进剂的燃速且超细ＣａＣＯ３比市售ＣａＣＯ３的催化效率高。进一步研究了超细ＣａＣＯ３与金属氧化物Ｍ２Ｏ３组合对推进剂燃烧的催化作用，结果表明两者有协同效应，其组合的燃烧催化效果较各自单独使用的催化效果要好。