黄埔发电厂#6发电机转冷水系统改造

黄埔发电厂#6发电机转冷水铜离子含量超标，通过对缺陷原因进行分析，针对二级水封的特性对溢出的转冷水进行回收并利用化学凝结水处理去除溶出的铜离子，通过控制转冷水的pH值最终减缓铜管的腐蚀.     

Change in Availability of Mineral and Raw Material Resources as a Result of Scientific and Technical Progress

The tendencies characterizing worsening of natural, mining and technical, as well as mining and geological conditions of deposit mining are analyzed for the last 100 years. The change in prices for mineral raw material is shown, and the influence exerted by scientific and technical progress in the sphere of mining and processing of copper-containing ores is established. An approach to the estimate of available mineral reserves and possibility of their involvement in mining is stated.     

云南锰矿选矿现状与前景分析

云南锰矿资源丰富,具有品位高、低磷低铁、易选等特点。文章概述了斗南、鹤庆、建水等锰矿的选矿科研进展情况,三个锰矿均可采用强磁选或磁-重选流程选别,可提高品位8—12％;精矿含锰可达33—35％,锰回收率在80％以上的好结果。     

氨荒酸盐抑制铜在NaCl溶液中腐蚀的电化学研究

通过电化学极化曲线和失重实验,研究了氨荒酸盐对铜在氯化钠溶液中的缓蚀性能,并与相应胺的缓蚀性能进行了对比。结果表明:氨荒酸盐对铜具有较好的缓蚀性能。     

全面留矿法采场顶板支护和落矿爆破工艺的研究

本文介绍的接杆锚杆护顶技术和上向眼大孔距多排微差爆破落矿技术，解决了逐昌金矿全面留矿法采矿工艺中存在的采场顶盘围在面积冒落和采场落矿爆破效果差、效率低这两个问题。     

应用硫酸铵提高乌拉嗄金矿石浮选回收率试验研究

经试验发现应用一种化学肥料硫酸铵可以显著提高乌拉嘎金矿石的浮选回收率。闭路试验尾矿工艺矿物学鉴定证明，以硫酸铵作为调整剂的浮选过程中，微细粒单体金和金与石英边生体被有效回收。     

Resilient metal spring network silicone-matrix composite for separable interconnections

Resilient metal spring silicone-matrix conducting composites for separable interconnections in electronics were fabricated by the impregnation of silicone into a preform comprising randomly oriented C-shaped Cu-Be springs and a small proportion of Sn-Pb solder, which served to connect the springs at some of their intersections. Composites containing 6.1-9.8 vol.% total filler exhibited volume electrical resistivity 0.5-1.0 mΩ.cm and contact resistivity (with copper) 11-17 mΩ.cm². A compressive stress of about 30 kPa was needed for the low contact resistivity to be reached. The volume 17-26% and the contact resistivity increased by 5% after heating in air at 130-150°C for seven days. Composites containing <9 vol.% total filler showed no stress relaxation for seven days at 6.0% strain.     

Catalyst instabilities during the liquid phase partial oxidation of methane

A promising catalytic system for the low temperature oxidation of methane to a methanol derivative has been investigated under both batch and semi-continuous operation in two different reactor types. The system comprises of a bimetallic palladium and copper(II) chloride catalyst contained in a trifluoroacetic acid (TFA) and an aqueous phase. Methane, oxygen and a co-reductant carbon monoxide constitute the gas phase. Typical operating conditions were a temperature of 85 °C and a pressure of 83 bar.

The yields of the methyl trifluoroacetate product observed in this present work were less than those obtained in other batch autoclave works, which employed only 4 ml of liquid phase, compared with 50 ml in this study. Furthermore, an encouraging initial product formation rate of ca. 40 mol/m³ h, quickly decreased after the first hour, and came to an apparent end after only 2 h. This observation had not been reported previously.

Work performed in a semi-continuous porous tube reactor (300 ml of re-circulating liquid phase) also showed the same reaction characteristics as in the batch reactor. Thus, the deteriorating product formation rate cannot be attributed to gaseous reactant depletion (batch operation). The results suggest problems associated with catalyst instabilities, e.g. with the previously elucidated Wacker chemistry.     

电解铜箔产业发展趋势

随着技术的进步,电解铜箔在厚度上迅速向薄、超薄方向发展,THE、RCC、CAC等特殊性能铜箔需求比例快速 增加,以锂离子电池为代表的新应用领域正在形成。     

纯铜双层辉光离子渗钛组织形成机理及性能分析

采用双层辉光离子渗金属技术对纯铜进行了渗钛处理。用配有能谱仪(EDS)的扫描电子显微镜(SEM)、X射线衍射仪和透射电子显微镜对合金层的显微组织形貌、钛含量分布、相组成及相结构类型进行了观察与测定，对合金层的形成机理进行了探讨，并对其性能进行了对比测定。结果表明：渗钛层由合金层和扩散层组成，合金层主要由TiCu (Cu)固溶体 TiCu4构成，TiCu4为Dla型有序相，TiCu为B2型有序相，扩散层为(Cu)固溶体。渗钛处理后纯铜的表面得到显著强化。