江西铜工业存在的问题及对策探讨

简要介绍了我国铜工业概况，重点分析了江西铜工业存在的问题，并提出发展对策，如优化铜产品结构、利用国内外两种资源和大力发展湿法炼铜等。江西要发挥潜在优势，建立我国铜加工材生产基地，利用外力，提高铜加工材的竞争力，由进口替代逐步走向增加出口。     

WC含量对弥散强化铜Cu/WC组织与性能影响的研究

对以WC粒子为第二相的弥散强化铜材料的组织与性能进行了研究。在同样条件下，用机械混料方法制备了不同WC含量的Cu/WC复合材料，分别测定了其密度，电阻率和硬度，结果表明：WC粒子是一种较为理想的弥散相，并且WC体积含量为1.2%时，细小的球形状第二相粒子均匀分布，弥散效果好，材料密度，硬度较高，而电阻率较小，综合性能较好。     

Fire performance of wood (Pinus radiata) treated with fire retardants and a wood preservative

In this work, we co‐formulated an oil‐borne copper naphthenate/permethrin wood preservative system with synthetic polymer‐based fire‐retardant additives prior to the impregnation of Pinus radiata sapwood. We evaluated what effect, if any, the preservative had upon the fire performance properties of the fire retardants and whether the fire retardants impacted on the fungicidal and termiticidal efficacy of the preservative. The fire retardants included halogenated and phosphorus‐based systems. A mass loss calorimeter, in conjunction with a thermopile, was used to measure the time to ignition and the peak heat release rate (PHRR) from which the fire performance index (FPI) was determined. The preservative properties were evaluated using termite and soil‐block decay bioassays. In summary, we found that the rate of fire growth was reduced when the fire retardants were used in combination with the wood preservative. We also found that the PHRR was a better determinant of fire performance than the FPI. The performance of the wood preservative was enhanced against fungal decay and termite attack when used in combination with the fire retardants. The fire retardants also demonstrated some wood preservative properties of their own. Copyright © 2008 John Wiley & Sons, Ltd.     

干磨干选工艺在赤城选矿厂中的应用

赤城鑫宇选矿厂工艺流程设计中采用了干磨干选的新工艺，用来处理全铁品位为13％左右的原矿。该工艺中将原矿用干式棒磨机磨至4mm～0mm，然后进行干式磁选甩尾，甩尾产率达到36％，甩尾后原矿TFe位可达到18％，提高了入湿磨、选别的品位，有效地降低了下段磨矿的费用。该工艺投入运行后，生产情况良好。     

Evaluation of rapeseed meals in broiler chicks: Effect of iodine supply and glucosinolate degradation by myrosinase or copper

In rapeseed meals (RSM) of a conventional (c) or a newly bred (n) variety 117 or 44 mmol glucosinolates and glucosinolate degradation products per kg dry matter were detected. Soaking meals in aqueous myrosinase or copper sulphate solution and subsequent drying reduced the content of antinutrients by more than 90%. Broiler chickens were fed (i) a glucosinolate-free diet, or this diet in which half the soybean meal was replaced by RSM of various origins and treatment; (ii) untreated cRSM; (iii) cRSM treated with myrosinase: (iv) cRSM treated with Cu (v) untreated nRSM; or (vi) nRSM treated with myrosinase. These diets were administered with or without supplementary iodine. Chickens receiving the iodine-deficient diets with myrosinase-treated RSM showed growth depression, incomplete feathering, leg injuries and severe goitre. In the serum T⁴ could not be detected. Giving myrosinase-treated RSM plus iodine, or giving other RSM diets irrespective of iodine administration, no growth depression was observed. RSM diets without iodine dosage markedly increased thyroid weight: there were no differences between the RSM variants. In contrast to the treatment with myrosinase, in the sera of the chickens fed on untreated RSM or RSM treated with copper T⁴ could be detected, suggesting that in iodine-deficient conditions differences in serum T⁴ concentration between RSM groups indicate a differing anti-thyroid activity. With iodine supplementation the RSM had a significant effect on thyroid weight. The largest thyroids (five-fold heavier) were in the animals with myrosinase-treated cRSM. The untreated cRSM and the nRSM trebled or doubled the thyroid weight, and the myrosinase-treated nRSM trebled it. The thyroid weight of chicks fed cRSM treated with copper did not differ significantly from the glucosinolate-free control. There was evidence that heating the myrosinase-treated RMS produced anti-thyroid compounds; these should be identified in further investigations.     

Numerical Simulation of Independent Advance of Ore Breaking in the Non-pillar Sublevel Caving Method

The mechanism of stress generation and propagation by detonation loading in five separate independent advance of ore breaking patterns is discussed in the paper. An elastic numerical model was developed using AN- SYS/LS-DYNA 3D Nonlinear Dynamic Finite Element Software. In this package ANSYS is the preprocessor and LS-DYNA is the postprocessor. Numerical models in the paper to actual were l：10 and the element mesh was dissected in scanning mode utilizing the symmetry characteristics of the numerical model. Five different advance rates were studied. Parameters, such as the time required to maximum stress, the action time of the available stress, the maximum velocity of the nodes, the stress penetration time, the magnitude of the stress peak and the time duration for high stress were numerically simulated. The 2.2 m advance appeared optimum from an analysis of the simulation results. The results from numerical simulation have been validated by tests with physical models.     

新城金矿采场落矿控制爆破技术

新城金矿为蚀变岩型金矿床,由于受地质构造影响,顶板稳定性较差,局部和较大面积的顶板冒落现象时有发生,为了解决采场顶板安全问题和提高落矿主要技术经济指标而进行了“上向水平分层尾砂胶结充填法采场控制爆破技术”的试验研究工作,试验达到了预期效果。     

难选氧化锰矿的选别工艺特征

氧化锰矿的泥化现象一般较严重，有的矿石很容易在机械作用下碎裂泥化，并且锰在粗、细粒级中的含量差别较大，因此在选别过程中避免过碎、强搅拌、强擦洗，并利用合理的分级工序，往往能获得十分理想的选别指标。     

镇沅金精矿选择性固砷焙烧—氰化浸出新工艺研究

对云南镇沅金矿的难当金精矿进行了选择性固砷焙烧－氰化浸出的试验研究，取得了满意结果。砷固定率大于９２％，硫挥发率为７８％－８４％，金浸出率可达９１％－９３％。选择性固砷焙烧－氰化浸出新工艺可有效消除砷害，综合利用有价成分硫，特别适宜于含砷高硫，同时含碳等杂质的细粒浸染型难浸金矿石的处理，在我国有较大的发展前景。     

含碳酸盐萤石矿石全弱酸性浮选新工艺

对含碳酸盐较高的萤石矿石提出了不加纯碱的全弱酸性浮选新工艺,获得CaF_298.21％、SiO_20.67％,回收率为93.25％的良好指标,实现了低模数碳酸盐—萤石矿石的高纯分离。