电压互感器二次回路N600多点接地查找及处理

从理论上分析了电压互感器二次回路多点接地的危害,并结合台山电厂220kV变电站查找N600多点接地的实际例子,介绍了N600多点接地的判断及查找方法,并提出了防范措施。     

基于VC++设计钢丝绳芯皮带电磁在线监测系统

为了保证皮带输送机的安全运行,发挥钢丝绳芯皮带在全生命周期中的最大效益,以TCK-GMS600弱磁检测器为基础,在VC++6.0集成开发环境下,应用DAQBench(Data Acquisition Bench)控件和多线程技术,开发了钢丝绳芯输送带电磁在线监测系统,实现了数据采集和存储、曲线实时显示、缺陷识别等功能,为钢丝绳芯皮带的健康维护奠定基础。     

Figure of merit for environmental SEM and its implications

A recently introduced figure of merit for environmental and low vacuum scanning electron microscopes has now been computed in the full operational pressure range for one commercial instrument. The direct simulation Monte Carlo method has been used in lieu of experimental measurements. The theory of this figure of merit is further consolidated. It is shown that a thin pressure limiting aperture can indeed be used as an optimum reference system for all instruments employing differential pumping in the transfer of an electron beam from high vacuum to high pressure. The implications of the results obtained are discussed both in relation to existing commercial instruments and associated literature to pave the way for future progress in the field.     

红霉素类抗生素电喷雾/飞行时间质谱源内CID研究

本文采用电喷雾 /飞行时间质谱法 ,对 5个红霉素类抗生素进行了源内CID研究 ,并以PEG40 0及各样品质子化分子离子 (MH+ )做为内标物 ,对碎片离子进行了准确质量测定 ,确认了这些碎片离子 ,并总结了此类化合物的裂解规律。样品分子含有去氧氨基糖 (desosamine)或红霉糖 (cladinose)两个糖基片段 ,其中去氧氨基糖易于形成带电离子。另外考察了喷管电压 (NozzlePotential)、溶剂条件等对红霉素类抗生素电喷雾源内CID质谱的影响。     

Experimental investigation on sliding and fretting wear of steam generator tube materials

In nuclear power steam generators, high flow rates can induce vibration of the tubes resulting in fretting wear damage due to contacts between the tubes and their supports. In this paper, the sliding and fretting wear tests were performed using Inconel 600HTMA and 690TT against STS 304, which are the steam generator tube materials. The sliding wear tests with a pin-on-disk type tribometer were carried out under various applied loads and sliding speeds at air environment. The fretting wear tests were carried out under various vibrating amplitudes and applied normal loads.

The result of sliding and fretting wear tests show that the heat-treated Inconel 690TT has better wear resistance than Inconel 600HTMA in air. The fretting wear regimes were plotted using the test results and the wear coefficient was calculated also. From the results, it was observed that the wear and tear by stick-slip has very strong effect on the fretting wear behavior.     

600 MW汽轮机差胀变化规律及控制

介绍ＧＥＣＡＬＳＴＨＯＭ６００ＭＷ汽轮机启停、正常运行中的差胀变化规律以及影响差胀的变化因素,总结了控制差胀变化的经验。     

660 MW机组汽轮机真空快速冷却系统的应用

通过对邯峰发电公司660 MW机组汽轮机的结构分析,介绍了其采用的真空法快速冷却(快冷)系统,并将真空法快冷与常用的加热压缩空气法快冷进行了比较。实践证明,真空快冷系统的应用较为安全可靠。     

电压互感器二次中心线接地方式的分析和改进

分析了电压互感器二次回路中心线电压产生漂移的原因，指出了现有的回路在某些特殊故障情况下的隐患，提出了中心线接线的改进方法和建议。     

600 MW机组锅炉的热化学试验

文章介绍了600 MW机组锅炉热化学试验工作的过程以及对各试验工况数据曲线的分析,并提出了改善锅炉化学运行工况的建议.     

Preparation and ethanol sensing properties of flower-like cupric oxide hierarchical nanorods

Flower-like cupric oxide (CuO) hierarchical nanorods (petal size: 60–100 nm in diameter and 500–700 nm in length) were synthesized by wet chemical-assisted hydrothermal processing. The samples were characterized by field emission scanning electron microscopy, energy dispersive X-ray spectroscopy and X-ray diffraction. The influence of hydrothermal temperature on the formation of CuO nanoflowers was investigated. Sensors based on CuO nanoflowers were fabricated by coating them on SiO₂/Si substrate attached with Pt interdigitated electrodes. Sensing characteristics of the samples were measured and evaluated as a function of operating temperature and ethanol vapor concentration. The results revealed that the p-type semiconductor CuO nanoflowers based sensors exhibit high sensitivity and selectivity toward ethanol vapor with the optimum working temperature at about 230 °C.