Vapor absorption by LiBr aqueous solution in vertical smooth tubes

Heat and mass transfer in a falling film vertical in-tube absorber was studied experimentally with LiBr aqueous solution. The presented results include the effect of solution flow rate, solution subcooling and cooling water temperature on the absorption in a smooth copper tube 16.05 mm I.D. and 400 mm long. The experimental data in the previous report for a 1200-mm-long tube was also re-examined and compared. It was demonstrated by the observation of the flow in the tube that the break down of the liquid film into rivulets leads to deterioration of heat and mass transfer at lower film Reynolds number or in longer tubes. An attempt to evaluate physically acceptable heat and mass transfer coefficients that are defined with estimated temperature and concentration at the vapor–liquid interface was also presented.     

Sheldon Cohen: Award for Distinguished Scientific Contributions.

Provides the biography of Sheldon Cohen and announces that he has received the APA Award for Distinguished Scientific Contributions (2004) for his elegant research in psychoneuroimmunology. The award citation and a selected bibliography are also provided. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Reading Motivation: Multidimensional and Indeterminate.

The Motivations for Reading Questionnaire (MRQ) contains 54 items that are posited to tap 11 dimensions of reading motivation. The structural validity of the MRQ was investigated with 2 samples: (a) 328 students in Grades 3-5 from 2 suburban mid-Atlantic elementary schools and (b) 735 students in Grades 3-5 in 2 suburban southwestern elementary schools. With confirmatory factor analyses (CFAs), the theoretical 11-factor structure did not adequately fit the data in either sample. Subsequently, exploratory factor analyses found 8 factors for each sample with 6 factors defined by only 3 or 4 common items. However, a double CFA cross-validation found an inadequate fit for both samples. Given these results, the authors suggest that the MRQ be revised. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

火炮身管内表面激光硬化处理的实验研究

提高身管寿命是火炮行业亟待解决的关键技术问题，激光表面改性技术是解决这一问题的有效方法之一。本文在分析激光表面相变硬化性能的基础上，对身管内表面进行了激光硬化处理实验研究，检测了其内表面阳线和阴线的硬化层硬度和深度，对比分析了离焦量和焦深对其内表面硬化层硬度的影响，并对激光相变硬化层金相组织进行了分析。经激光硬化处理后，身管的内表面硬度有明显提高，硬化层较深，且为很细的条状马氏体组织。     

热声制冷机及其改进实验研究

热声制冷作为一种很有前途的制冷方法，在国内外相关领域引起了极大兴趣。热声制冷机由声发生器、共振管、板叠及高、低温换热器等部分组成。对声驱动器的振动膜及其冷却系统、气体弹簧系统、高、低温换热器进行了初步改进，使制冷机冷端温降从原来的12℃提高到27℃左右，这是目前国内报道的最大温降。     

Nonstationary Simulation Model of Absorber with Falling Film of Suspension

A nonstationary model of SO₂ absorption from a gas phase to a countercurrent falling film of absorbing slurry was developed. Laminar, wavy and turbulent film structures were considered based on published information. Resistances to the mass transfer on the gas and the liquid sides of the interphase were considered, together with chemical reactions in the liquid phase. Relevant chemical equilibria in the liquid phase were modeled. Original experimental data on the neutralization reagent dissolution rate presented as a polydispersed two‐phase system of solids and on the rate of dissolved sulfite oxidation were used. The model was verified with experimental data from a laboratory‐scale falling‐film absorber using a single vertical tube under various geometrical and operating conditions, and a very good agreement was found with the experiment. Parametric sensitivity analysis showed the critical parts of the model.     

一种新型的多功能照相胶片影像质量评价方法

本设计了一种新型的多功能照相胶片感光性能和影像质量评价方法。这种方法的主要特点的快速、方便并有满足 实用要求的精确度。该方法仅使用一个测试标板，就可以很容易地测定出照相胶片的感光性能、分辨率、均方根粒度和密度振幅响应（DAR）值等多种表征影像质量的参数。本简要介绍该方法并给出试验结果及其与传统测试方法的比较和讨论意见。     

微桥法镍膜的弹性模量和残余应力测量

利用MEMS技术制作了不同尺寸的镍(Ni)膜微桥结构样品。采用纳米压痕仪XP系统测量了微桥载荷与位移的关系,并结合微桥力学理论模型得到了两种不同尺寸的Ni膜的弹性模量和残余应力。结果表明,两种不同尺寸的Ni膜的弹性模量结果一致,为190 GPa左右,但是残余应力变化较大。与采用纳米压痕仪直接测得的带有硅(Si)基底的Ni膜弹性模量186.8 7.5 GPa相比较,两者符合较好。     

Gamma-irradiation-induced Ag/SiO2 composite films and their optical absorption properties

Small Ag particles or clusters dispersed mesoporous SiO₂ composite films were prepared by a new method: First the matrix SiO₂ films were prepared by sol-gel process combined with the dip-coating technique, then they were soaked in AgNO₃ solutions followed by irradiation of γ-ray at room temperature and in ambient pressure. The structures of these films were examined by X-ray diffraction (XRD), high-resolution transmission electron microscope (HRTEM), and optical absorption spectroscopy. It has been shown that the Ag particles grown within the porous SiO₂ films are very small, and they are isolated and dispersed from each other with very narrow size distributions. With increasing the soaking concentration and an additional annealing, an opposite peakshift effect of the surface plasmon resonance (SPR) was observed in the optical absorption measurements.     

掺Er Al2O3光波导薄膜材料的制备及光学特性

介绍了掺ErAl2O3光波导薄膜的四种典型制备方法的研究结果。比较铒的发光环境和发光特性,分析了影响光致发光强度和寿命的条件和因素。不同工艺制得的Er∶Al2O3薄膜,膜内成分、膜的晶相、掺杂浓度等对Er3 的发光特性均有影响。退火对发光特性及材料具有改善作用。