氯化钠对铝硅矿物浮选的影响及其作用机理

采用季铵盐DTAL作捕收剂,研究了氯化钠对一水硬铝石和叶蜡石浮选的影响及其作用机理.随着氯化钠浓度的增加,叶蜡石的浮选回收率显著提高,而一水硬铝石的可浮性受其影响很小.机理研究表明:氯化钠对一水硬铝石的zeta-电位没有影响,而能显著降低叶蜡石的zeta-电位,增强捕收剂与叶腊石的静电作用,促进捕收剂的吸附而活化其浮选;叶蜡石表面电位的降低是因为氯离子对叶蜡石存在选择性吸附作用并对其结构进行插层,使得叶蜡石的层间距从0.93 nm增大至1.40 nm.溶液化学计算表明:氯化钠改变溶液的离子强度,显著降低了季铵盐阳离子表面活性剂的临界胶束浓度,使得吸附了捕收剂的矿物表面更容易疏水上浮.     

Gas chromatographic thermodynamics on hydration processes of magnesium chloride with low water

1　INTRODUCTIONMagnesiumchlorideisabasicmaterialforchem icalindustry ,andithaswideapplicationsinmetallur gy,architecturalmaterialandtextileindustry .Itisalsoamaterialforfire resistantproducts ,cryogenandcompoundfertilizerproductions[1] .Thefullydehy dratedmagnesiumchlorideisagoodmaterialforelec trolyticmetalmagnesium production .Becausemag nesiumchloridehasastrongadsorptiveability ,itisalsousedasadryingagent .Manysuccessfulworkshavebeendoneonthedehydrationofbischophite[2 10 ] .Butinfact,…     

Thermochemistry on coordination behavior of samaric chloride hydrate with diethylammonium diethyldithiocarbamate

The complex of samaric chloride lower hydrate-with diethylammonium diethyldithiocarbamate (D-DDC) was synthesized conveniently in absolute alcohol and dry N2 atmosphere. The title complex was identified as Et2NH2[Sm(S2CNEt2)4] by chemical and elemental analyses, the bonding characteristics of which was characterized by IR.T he enthalpies of solution of samaric chloride hydrate and D-DDC in absolute alcohol at 298.15 K and the enthalpies change of liquid-phase reaction of formation for Et2NH2[Sm(S2CNEt2)4] at different temperatures were determined by microcalorimetry. On the basis of experimental and calculated results, three thermodynamic parameters (the activation enthalpy, the activation entropy, and the activation free energy), the rate constant, and three kinetic parameters (the apparent activation energy, the pre-exponential constant, and the reaction order) of liquid phase reaction of formation were obtained. The enthalpy change of the solid-phase title reaction at 298.15 K was calculated by a thermochemical cycle.     

乙炔法氯乙烯合成固定床反应器的建模及分析

针对我国广泛应用的乙炔法氯乙烯合成固定床反应器,结合氯乙烯合成的反应动力学、催化剂的失活动力学,同时引入了传热方程,建立了完整的列管式氯乙烯合成固定床反应器的数学模型。将该模型用于工业生产,模拟了传热系数沿管长的变化,列管内反应温度沿管长的变化并与生产数据对比,验证了模型的正确性。最后分析了乙炔空速、冷却水温度对管内温度分布和乙炔转化率的影响。     

微电流电解对尿素降解的机理及影响因素研究

采用微电流电解技术对模拟游泳池水中的尿素进行降解处理,探索了电解对尿素的去除机理,研究了电流密度和氯离子浓度等因素对电解去除尿素效果的影响。结果表明:以钌钛和不锈钢分别做阳极和阴极材料,当水溶液中有较高浓度的氯离子存在时,电解过程中产生的活性氯使得尿素被氧化,尿素降解产物中无氨氮、氯胺等二次污染物,尿素极有可能通过电解生成了N2等气体挥发到空气中。电流密度和氯离子浓度对尿素的去除效率有很大影响,随着电流密度和氯离子浓度的增加,尿素去除效率逐渐上升。在500 mg/L的氯离子浓度条件下,电流密度为12 m A/cm2时,电解处理30 min时尿素去除率可达99.5%。将微电流电解技术应用于游泳池水中的尿素去除,无需添加电解质,即能达到较高的尿素去除效果,采用该技术对游泳池水中的尿素进行降解去除完全可行。     

微波辐照法制备PVC-g-DAP聚合物及其结构与性能表征

采用微波辐照法制备了以聚氯乙烯(PVC)为骨架,邻苯二甲酸二烯丙酯(DAP)为支链的接枝聚合物PVC-g-DAP。通过红外光谱、差示扫描量热分析对聚合物的结构进行了表征,同时对聚合物的流变性能、耐热性和力学性能进行了测试分析。结果表明,DAP在微波辐照下成功接枝到PVC大分子链上,PVC-g-DAP聚合物只有1个Tg,且略高于PVC。PVC-g-DAP聚合物的流变性能较PVC有大幅度改善,同时力学性能、耐热性得到提升。     

银/氯化银电极用于监测混凝土中氯离子含量的研究

采用干湿循环渗透法,通过实验室制备的银/氯化银电极来监测混凝土中的氯离子含量,测试了电极的响应性能和长期稳定性,研究了总氯离子含量与自由氯离子含量之间、总氯离子含量与电位之间的关系。结果表明:银/氯化银电极电位能比较好地监测到混凝土中氯离子含量变化的过程,具有良好的长期稳定性能。总氯离子含量随自由氯离子含量的增加而增加,两者之间呈现幂函数的规律。总氯离子含量随电位上升而下降,两者之间呈指数函数的规律。     

Electrochemical Behavior of Single CuO Nanoparticles: Implications for the Assessment of their Environmental Fate

The electrochemical behavior of copper oxide nanoparticles is investigated at both the single particle and at the ensemble level in neutral aqueous solutions through the electrode‐particle collision method and cyclic voltammetry, respectively. The influence of Cl^? and NO₃^? anions on the electrochemical processes occurring at the nanoparticles is further evaluated. The electroactivity of CuO nanoparticles is found to differ between the two types of experiments. At the single‐particle scale, the reduction of the CuO nanoparticles proceeds to a higher extent in the presence of chloride ion than of nitrate ion containing solutions. However, at the multiparticle scale the CuO reduction proceeds to the same extent regardless of the type of anions present in solution. The implications for assessing realistically the environmental fate and therefore the toxicity of metal‐based nanoparticles in general, and copper‐based nanoparticles in particular, are discussed.     

Phase change materials in the ternary system NH4Cl+CaCl2+H2O

Solubility isotherms of the ternary system (NH₄Cl+CaCl₂+H₂O) were elaborately determined at T= (273.15 and 298.15) K by using the isothermal method. In the equilibrium phase diagram, there are two solubility branches corresponding to the solid phases CaCl₂⋅6H₂O and NH₄Cl. Invariant point compositions are 36.32 wt% CaCl₂ and 3.4 wt% NH₄Cl at 273.15 K, and 45.86 wt% CaCl₂ and 5.22 wt% NH₄Cl at 298.15 K. A Pitzer-Simonson-Clegg thermodynamic model was applied to represent the thermodynamic properties of this ternary system and to construct a partial phase diagram of the ternary system at temperatures between (273.15 and 323.15) K. It was found in the predicted solubility phase diagram that the double salt 2NH₄Cl⋅CaCl₂⋅3H₂O, found by other authors at (323.1 and 348.1) K, will disappear at temperatures below 298.15 K. Besides, it was found that there are two peritectic points in the ternary system with peritectic temperatures at 299.65 K and 298.15 K, and the former peritectic point falls just on the line between the composition points of NH₄Cl and CaCl₂⋅6H₂O. According to phase rule, a solution made of this point will begin to crystallize at 299.65 K and end at 298 K and therefore can be acted as a “pseudo eutectic” phase change material (PCM). A heat storing and releasing experiment of 50 grams of the PCM was carried out, obtaining a satisfying result.     

Carbon felt-based bioelectrocatalytic flow-through detectors: Highly sensitive amperometric determination of H2O2 based on a direct electrochemistry of covalently modified horseradish peroxidase using cyanuric chloride as a linking agent

Horseradish peroxidase (HRP) was chemically modified using cyanuric chloride (CC) as a linking agent onto a carbon felt (CF), which is a microelectrode ensemble of micro carbon fiber (>7 μm, diameter) with a random three-dimensional structure. The resulting HRP-modified CF (HRP-ccCF) exhibited well-defined redox waves based on the HRP heme Fe^III/Fe^II redox couple at −0.23 V vs. Ag/AgCl (at pH 7.0), while the HRP-adsorbed CF (HRP-CF) showed no apparent redox couple in the same potential range, indicating that the chemical modification of HRP via CC facilitated the direct electron transfer (DET) between HRP and CF. The apparent heterogeneous electron transfer rate constant k_s was estimated to be 35 s⁻¹. Cyclic voltammetry and electrochemical impedance spectroscopy revealed that the interfacial properties (i.e., structure, morphology of enzyme-layer) of covalently modified HRP (HRP-ccCF) and physically adsorbed HRP (HRP-CF) are different, resulting in the difference in the electron transfer properties. The HRP-ccCF was successfully used as a working electrode unit in bioelectrocatalytic flow-through detector for highly sensitive amperometric determination of H₂O₂. Under the optimized conditions (i.e., applied potential, 0 V vs. Ag/AgCl; carrier flow rate, 3.25 ml/min; and carrier pH 7.0), the cathodic peak current of H₂O₂ linearly increased up to 3 μM (sensitivity, 1.94 μA/μM; the detection limit, 0.08 μM [S/N = 3]) with sample through-put of ca. 90 samples/h.