Structural and electrochemical characterization of mechanochemically synthesized calcium zincate as rechargeable anodic materials

Hydrated calcium zincate was synthesized by mechanical ball milling of ZnO and Ca(OH)₂ in water at room temperature. The structural and electrochemical properties of this material used as rechargeable anodic material were examined by microelectrode voltammetry, charge–discharge measurements and structural analysis. The results showed that during mechanical milling, ZnO, Ca(OH)₂ and H₂O reacted rapidly to form Ca[Zn(OH)₃]₂ · 2H₂O which was subsequently transformed to a stable structure CaZn₂(OH)₆ · 2H₂O. Since this composite oxide has lower solubility in KOH solution (<35 wt %) and better electrochemical reversibility than ZnO-based negative materials, the zinc anodes using this material can overcome the problems of shape changes and dendritc formation, and therefore exhibit improved cycling life.     

溶剂沉淀法制备的聚酰胺粉末之溶剂与粉末结构和热稳定性的关系

使用粒度分布仪、白度仪、电子显微镜和差热仪测定四种溶剂沉淀法制备的聚酰胺粉末发现：每种方法所获得的粉末粒径、比表面积、白度均不相同；以乙醇 氯化钙混合溶剂制备的粉末内部具有多孔结构；以乙醇 盐酸 水混合溶剂制备的粉末热稳定性较高     

The correlations between structural and optical properties of magnetite nanoparticles synthesised from natural iron sand

The correlations between structural and optical properties of magnetite (Fe₃O₄) nanoparticles were analyzed by using X-Ray Diffraction (XRD) and Fourier Transform Infrared (FTIR) Spectroscopy. The magnetite was synthesised from the iron sand using NaOH, HCl, and NaCl as a solvent. From the quantitative analysis of XRD spectra, the crystallite size (D), strain ($\epsilon$), stress ($\sigma$), energy deformation (u), porosity, and specific surface area were determined. The Kramers Kronig (K–K) relations was applied to the FTIR spectra to determine the optical properties: refractive index (n), extinction coefficient (k), the complex dielectric function ($\mathit{\epsilon }$), and the energy loss function (Im(-1/ε)). The uniform strain was produced from the NaOH and HCl as the solvent. The magnetite had higher porosity with NaCl as a solvent and was directly proportional to the optical phonon vibration. We found a perfect correlation; when the difference between two optical phonon increases, the crystallite size decreases, and the strain will be uniform.     

细长钢管内壁涂塑工艺

采用流化床和热喷涂方法喷涂直径小于２０ｍｍ的长钢管内壁。叙述了工艺过程和涂层检测方法。     

Reforming of methane with carbon dioxide over supported bimetallic catalysts containing Ni and noble metal: I. Characterization and activity of SiO2 supported Ni–Rh catalysts

Cobalt catalysts supported on silica aerogel have been prepared using sol–gel chemistry followed by drying under supercritical ethanol conditions. Three different loadings of cobalt were synthesized: 2, 6, and 10% by weight. Transmission electron micrographs indicate that the metallic cobalt exists as discrete particles 50–70 nm in diameter for the 2 and 6% loadings. The 10% catalyst shows long needles of cobalt. BET and BJH measurements indicate that the catalysts retain the silica aerogel properties of high surface area (∼800 m²/g), large pore volume (∼5 cm³/g), and an average pore diameter in the mesoporous regime (∼25 nm). The catalysts were evaluated for Fischer–Tropsch activity in a laboratory-scale packed bed reactor. All three catalysts were active with the 10% Co catalyst achieving more than 20% CO conversion which corresponds to a rate of 1.53 g CO per g-cat per hour. The catalysts were selective for the C₁₀₊ hydrocarbons with more than 50% of the carbon contained within this fraction. A significant portion of the C₉–C₁₅ hydrocarbon product was observed as 1-olefins which reflects the enhanced mass transport within the very porous aerogel support.     

超细粉体微胶囊红磷阻燃剂的研制

红磷经湿法研磨预处理，在一定pH值（9．0－9．5），表面活性剂用量为0．8％－1．0％，2200Hz超声波振荡15min后，采用蜜胺树脂预聚体原位法包覆，制得了微胶囊红磷阻燃剂的超细粉体，其平均粒径为2．186um，并探讨了预处理，PH值，表面活性剂及超声波对粒度的影响。     

The preparation of coupled WO3/TiO2 photocatalyst by ball milling

The coupled photocatalyst WO₃/TiO₂ is prepared by ball milling by doping WO₃ into TiO₂ and using H₂O solution as disperser. The coupled photocatalyst WO₃/TiO₂ is characterized by UV–VIS diffuse reflection spectrum, X-ray photoelectron spectroscopy (XPS), X-ray powder diffraction (XRD) and Transmission electron microscopy (TEM). The results show that the optimum percentage of WO₃ doped is 3% and that the photocatalytic activity of the coupled WO₃/TiO₂ photocatalyst is much higher than that of TiO₂ and WO₃–TiO₂ with no ball milling. Compared with TiO₂, the photoexcited wavelength range of the WO₃/TiO₂ photocatalyst red-shifts about 50 nm, and the light absorption intensity is also improved. The crystal phase of TiO₂ is not changed and new crystal phases are not found during the process of ball milling. WO₃ and TiO₂ coupled highly, forming the WO₃/TiO₂ photocatalyst. The increased photocatalytic activity of the coupled photocatalyst may be attributed to the enhance charge separation efficiency and the extend wavelength range of photoexcitation.     

Oxidative coupling of methane over LaCoO3−δ-based mixed oxides

The catalytic activity of LaCoO_3–-based mixed oxides for the oxidative coupling of methane has been tested by TPR and cyclic reaction. Characterization has been done by XRD, TGA and Mössbauer spectrometry. It is likely that the perovskite-crystal structure containing hypervalent metal ions has an important role and that unique structural oxygen species in the perovskite contribute to the partial oxidation of methane.     

反应过程中升华型催化剂的物性变化(Ⅱ) X—射线衍射结果

对衰化程度不同的升华型催化剂进行了 X—射线衍射测定。发现在使用过程中催化剂比表面迅速减小,但氯化汞-活性炭催化剂的新旧样品中,氯化汞均保持单层分散。但即将废弃的醋酸锌-活性炭催化剂上,醋酸锌的单层分散情况受到破坏,出现了醋酸锌晶相峰。晶相峰的出现可能与后期使用温度偏高引起烧结有关。晶相峰的出现会降低催化活性,使之不得不被废弃。     

抗静电粉末涂料的制备

简述了抗静电粉末涂料的制备机理及铝粉、氧化镁、二氧化钛和抗静电助剂添加量对涂料性能的影响，并简述其应用。