Effect of cobalt oxide on surface structure of alumina supported molybdena catalysts studied by in situ Raman spectroscopy

A set of Co promoted 10% Mo/Al₂O₃ samples have been characterized by means of Raman spectroscopy under ambient as well as in situ dehydrated conditions. Under ambient conditions, the degree of the polymerization of surface molybdenum oxide species decreases with increasing Co loading. Under dehydrated conditions, the polymeric molybdenum oxide species is absent with the addition of only 0.2% Co. At low Co loadings (2%), before the formation of CoMoO₄ compound, the spectral features are very similar under ambient conditions. Dehydration causes the upward shift of the Mo=O symmetric stretching mode. A broad band around 920–930 cm^–1 was thus observed. This band has been suggested to be associated with the Co-Mo interaction species. In contrast to crystalline CoMoO₄, this species shows a reversibility on H₂ reduction-O₂ reoxidation treatments. From the results obtained, it is proposed that cobalt oxide interacts with the most polymerized molybdenum oxide species to form Co-Mo interaction species and/or crystalline CoMoO₄; therefore, the amount of the surface molybdenum oxide species decreases with a change in the molecular structure as a function of the Co concentration.     

Interpretation of quasi-elastic light scattering data for flexible chains: model dependence

The autocorrelation functions and corresponding relaxation times obtained from the forward depolarized quasi-elastic light scattering experiment are exhibited for two quite similar models of flexible polymer chains in solution. A very small change in the chain dynamics is found to be sufficient to change the relaxation time from a relatively short time independent of chain length, with an autocorrelation function suggestive of an unweighted sum of contributions from all the relaxation times in the spectrum of chain motion, to a long time with an autocorrelation function identical with that for the end-to-end vector, strongly dependent upon chain length and dominated by the longest relaxation time in the spectrum. These results raise the question whether widely-used models in which information about short-range chain structure and motion is deliberately omitted can be expected to be appropriate for the interpretation of depolarized scattering experiments.     

Electrochemical and spectroscopic evidences of corrosion inhibition of bronze by a triazole derivative

The electrochemical behavior of the bronze (Cu-8Sn in wt%) was investigated in 3% NaCl aqueous solution, in presence and in absence of a corrosion inhibitor, the 3-phenyl-1,2,4-triazole-5-thione (PTS). The inhibiting effect of the PTS was evidenced for concentrations higher than 1 mM for the cathodic process whereas its effect was clearly seen with a concentration as low as 0.1 mM for the anodic process. A significant positive shift of the corrosion potential was also observed, and its inhibiting effect increased with both its concentration and the immersion time of the sample. From voltammetry and electrochemical impedance spectroscopy experiments, the inhibiting efficiency of the PTS was found to be in the 94-99% range for 1 mM concentration. Scanning electron microscopy and X-ray energy dispersion analysis of the specimen surface show the presence of sulphur on the surface. Raman micro-spectrometry study confirms the protective effect of the PTS in aqueous solution through three types of interactions with the electrode, namely the adsorption of the inhibitor in a flat configuration, the formation of copper-thiol molecules, and when copper is released, the formation of a polymeric complex.     

High quality double wall carbon nanotubes with a defined diameter distribution by chemical vapor deposition from alcohol

We have synthesized double wall carbon nanotubes (DWNTs) with few defects and little amorphous carbon by hot wall chemical vapor deposition (CVD) of alcohol. Catalysts for the DWNT growth were made from cobalt and molybdenum acetates. Scanning electron microscopy, transmission electron microscopy, multi frequency resonance Raman spectroscopy and optical absorption spectroscopy were used for characterization of the product with regard to DWNT yield, the nanotube diameter distribution, defect concentration and amorphous carbon content. Base pressures lower than 1 × 10⁻⁵ mbar in the CVD reactor considerably suppress defects in the DWNTs. Optimized growth conditions for DWNT formation are presented.     

壳聚糖与DNA作用的共振光散射特征及微量DNA的光散射测定

通过光谱法研究壳聚糖和核酸的作用 ,结果表明通过共振光散射法用壳聚糖检测微量的 DNA方法可靠、准确且简单。     

Evaporative light scattering mass detection for high-performance liquid chromatographic analysis of sucrose polyester blends in cooking oils

A high-performance liquid chromatographic method is described to determine the sucrose polyester (SPE) content in seven blends of cooking oils. Four gel-permeation chromatography (GPC) columns were used in series with an evaporative light scattering mass detector to separate the SPE from the acylglycerols in the final chromatogram. The SPE fraction was collected off the GPC column and injected onto a reverse-phase C-18 column for quantitation with sucrose octaacetate as an internal standard and a gradient of nonaqueous solvents as mobile phase. The chromatograms were interference-free, with only two sharp peaks appearing. The standards were linear from 500 to 5000 μg/mL with a correlation coefficient of r=0.999. The mean percent recovery (n=9) and standard deviation were 102±6.7. The detector could detect amounts as low as 5 μg SPE.     

Characterization of multiwall carbon nanotubes and influence of surfactant in the nanocomposite processing

Carbon nanotubes prepared by a classical CVD method with a nickel catalyst have been characterized, then used as conducting anisometric objects dispersed into a polymeric matrix. In a first part, these nanotubes are structurally characterized before and after heat treatments (HTT=1500, 2000, 2500 °C). Diffusion Raman experiments and diamagnetic susceptibility experiments demonstrated their limited graphitized structures.Then, in a second step, a well defined processing way to prepare nanocomposites with a standard epoxy resin is presented. In particular, the use or not of a non-ionic surfactant (Tergitol) to disperse these nanotubes is analyzed. The influence of nanotube contents is examined on the bulk nanocomposite density, the glass transition temperature of the nanocomposites, and the d.c. electrical conductivity behavior. These results demonstrated that the interfacial properties are playing a fundamental role. On one hand, the glass transition temperature is increasing with the nanotube content, and on the other hand, the percolation threshold is found for a rather high critical volumic concentration. Finally, it is demonstrated that a pure geometrical model is not sufficient to explain these behaviors and that a wrapping effect of the organic matrix around the nanotubes has to be considered.     

(Ag)_核·(Au)_壳复合纳米粒子的制备

以银原子团簇作晶种,采用微波高压液相合成法制备了分散性好、规则球形的(Ag)核·(Au)壳复合纳米粒子。研究了(Ag)核·(Au)壳复合纳米粒子的紫外可见吸收光谱和共振散射光谱特性。结果表明,液相(Ag)核·(Au)壳复合纳米粒子和高压微波合成的液相金纳米粒子的最强共振散射峰均在580nm处,它们的吸收光谱图相似,最大吸收分别在518.5nm和524.8nm。     

聚偏氟乙烯/聚丙烯酸酯复合乳液的合成与性能

在含氟表面活性剂存在下，将聚偏氟乙烯超声分散于甲基丙烯酸甲酯和丙烯酸丁酯的混合单体中进行乳液聚合，制备了聚偏氟乙烯／聚丙烯酸酯复合乳液。采用动态光散射DLS、透射电镜TEM和红外光谱FT—IR对乳液组成及乳胶粒子的形态进行了表征，并对聚合物胶膜的性能进行了测试分析。结果表明：聚偏氟乙烯的加入，使复合乳液膜的拉伸强度显著增大，吸水率减小。